JTB00649NAS1

Service Bulletin Details

Public Details for: JTB00649NAS1

A rattle noise may be evident from the engine compartment and may appear louder while the engine is under load or on overrun. The noise may also appear louder when starting the engine from a cold engine.


- 2018 -

8/28/2018
JTB00649NAS1 - Rattle From Turbocharger Actuator Arm | TOPIx
JTB00649NAS1
TECHNICAL BULLETIN
28 AUG 2018
© Jaguar Land Rover North America, LLC
NOTE: The information in Technical Bulletins is intended for use by trained, professional Technicians with
the knowledge, tools, and equipment required to do the job properly and safely. It informs these
Technicians of conditions that may occur on some vehicles, or provides information that could assist in
proper vehicle service. The procedures should not be performed by 'do-it-yourselfers'. If you are not a
Retailer, do not assume that a condition described affects your vehicle. Contact an authorized Jaguar
service facility to determine whether this bulletin applies to a specific vehicle.
INFORMATION
SECTION:
303-04
SUBJECT/CONCERN:
Rattle From Turbocharger Actuator Arm
AFFECTED VEHICLE RANGE:
MODEL:
MODEL YEAR:
VIN:
APPLICABILITY:
F-PACE (X761)
2018 Onwards
243940 Onwards
INGENIUM I4 2.0L Petrol
F-TYPE (X152)
2018 Onwards
K48252 Onwards
INGENIUM I4 2.0L Petrol
XE (X760)
2018 Onwards
P07334 Onwards
INGENIUM I4 2.0L Petrol
XF (X260)
2018 Onwards
Y46632 Onwards
INGENIUM I4 2.0L Petrol
https://topix.jaguar.jlrext.com/topix/content/document/view?id=923339
1/4
8/28/2018
JTB00649NAS1 - Rattle From Turbocharger Actuator Arm | TOPIx
MARKETS:
NORTH AMERICA
CONDITION SUMMARY:
SITUATION:
A rattle noise may be evident from the engine compartment and may appear louder while the engine is
under load or on overrun. The noise may also appear louder when starting the engine from a cold engine.
CAUSE:
This may be caused by excessive movement within the turbocharger wastegate actuator arm linkage.
ACTION:
Should a customer express this concern, follow the Workshop Procedure below.
PARTS:
PART NUMBER
DESCRIPTION
QUANTITY
JDE40303
Turbocharger
1
JDE38786
Turbocharger oil feed pipe - With banjo bolt(s) and washers
1
JDE39699
Turbocharger engine coolant return hose - With O-ring seal
1
JDE38646
Turbocharger engine coolant inlet hose - With O-ring seal
1
T2H33504
Turbocharger to exhaust - Gasket
1
T2H33505
Turbocharger to exhaust - Clamp
1
JDE36824
Turbocharger oil return pipe - Upper O-ring seal
1
JDE36825
Turbocharger oil return pipe - Lower O-ring seal
1
T2H36179
Turbocharger to charge air cooler - Air duct - All vehicles
except F-TYPE (X152)
1
JDE38598
Turbocharger to exhaust manifold - Gasket
1
https://topix.jaguar.jlrext.com/topix/content/document/view?id=923339
2/4
8/28/2018
JTB00649NAS1 - Rattle From Turbocharger Actuator Arm | TOPIx
TOOLS:
Refer to Workshop Manual for any required special tools.
WARRANTY:
NOTES:
Repair procedures are under constant review, and therefore times are subject to change; those
quoted here must be taken as guidance only. Always refer to JLR claims submission system to
obtain the latest repair time.
The JLR Claims Submission System requires the use of causal part numbers. Labor only claims
must show the causal part number with a quantity of zero.
DESCRIPTION
SRO
TIME (HOURS)
CONDITION CODE
CAUSAL PART
Turbocharger - Renew - F-PACE (X761)
18.50.32
1.5
33
JDE38612
Turbocharger - Renew - F-TYPE (X152)
18.50.32
1.4
33
JDE38612
Turbocharger - Renew - XE (X760)
18.50.32
1.8
33
JDE38612
Turbocharger - Renew - XF (X260)
18.50.32
1.8
33
JDE38612
NOTE:
Normal Warranty procedures apply.
WORKSHOP PROCEDURE:
1
Renew the turbocharger: (see TOPIx workshop manual section 303-04: Removal and Installation Turbocharger).
F-PACE (X152): see TOPIx Workshop Manual section 303-04G: Fuel Charging and
Controls - Turbocharger - Removal and Installation - Turbocharger
https://topix.jaguar.jlrext.com/topix/content/document/view?id=923339
3/4
8/28/2018
JTB00649NAS1 - Rattle From Turbocharger Actuator Arm | TOPIx
F-TYPE (X761): see TOPIx Workshop Manual section 303-04G: Fuel Charging and
Controls - Turbocharger - Removal and Installation - Turbocharger
XE (X760): see TOPIx Workshop Manual section 303-04E: Fuel Charging and
Controls - Turbocharger - Removal and Installation - Turbocharger
XF (X260): see TOPIx Workshop Manual section 303-04G: Fuel Charging and
Controls - Turbocharger - Removal and Installation - Turbocharger
https://topix.jaguar.jlrext.com/topix/content/document/view?id=923339
4/4


© dot.report 2024

Use of this information constitutes acceptance for use in an AS IS condition. There are NO warranties, implied or otherwise, with regard to this information or its use. Any use of this information is at the user's risk. It is the responsibility of user to evaluate the accuracy, completeness or usefulness of any information, opinion, advice or other content. EACH USER WILL BE SOLELY RESPONSIBLE FOR ANY consequences of his or her direct or indirect use of this web site. ALL WARRANTIES OF ANY KIND ARE EXPRESSLY DISCLAIMED. This site will NOT BE LIABLE FOR ANY DIRECT, INDIRECT or any other kind of loss.