SSM73973

7/20/2018
SSM73973 - 19 MY X590 I-Pace Whistle Noise from front end area | TOPIx
Reference
SSM73973
Models
I-PACE / X590 (F61609 → F60001)
Title
19 MY X590 I-Pace Whistle Noise from front end area
Category
Noise Vibration
Last modified
20-Jul-2018 00:00:00
Symptom
701000 Windnoise
Attachments
SSM Attachment_X590 Whistle Noise.pdf
Content
Issue:
The customer may experience a whistle noise subjectively from the
instrument panel area which originates at the front end of the car.
Noise is evident only at speeds of above 130KPH / 80MPH.
Affected Vehicle VIN Range
SADHB2R14K1F60001 to SADHA2B19K1F61609 – X590 I-Pace
Cause:
It has been found that a step on the bumper trim to the Front End
Carrier (FEC) duct is very sensitive for introducing a whistle noise.
Action:
1. Open the hood and remove the front stowage compartment per
TOPIx procedure 501-02 – up to step 12.
2. Insert a trim stick 260 mm from the centre to the left in the gap
between the duct and the edge of the bumper (see Figure 1)
3. Clean the gap with some cleaning cloth over a length of about
600 mm in the centre area.
4. Install an open cell seal strip (510mm X 14mm X 10mm) Part No.
T4K8298 into the gap.
5. Start with the installation of the seal at the trim stick with the
adhesive facing up, the backing paper just partially pulled off (see
Figure 2)
6. Continue to install the seal along the gap pulling off the backing
paper simultaneously until the full length is in place.
7. Remove the trim stick and press the bumper edge against the
FEC duct over the entire length to get the seal settled in the gap.
(see Figure 3)
8. Install the front stowage compartment per TOPIx procedure 50102.
https://topix.jaguar.jlrext.com/topix/content/document/view?id=916942
1/2
7/20/2018
SSM73973 - 19 MY X590 I-Pace Whistle Noise from front end area | TOPIx
Part Number – T4K8298
SRO Number - 76.16.89.01 – Install foam seal to hood latch panel –
0.40 hrs
Technicians - Please rate this SSM and provide comments so that
future communications can be improved.
1 = Poor – Basic information provided – The SSM does not help me
resolve the customer concern.
3 = Average – Adequate information provided – The SSM partially
helps me resolve the customer concern.
5 = Excellent – All required information provided to resolve the
customer concern.
https://topix.jaguar.jlrext.com/topix/content/document/view?id=916942
2/2