08-053-15
Service Bulletin Details
Public Details for: 08-053-15
Cluster backlighting dimming incorrectly this bulletin involves replacing and programming the instrument panel cluster. A small number of customer may notice that the cluster illumination is not dimming properly while in day or night mod
- 2015 -
Models from 2015
2015 JEEP RENEGADE |
NUMBER: GROUP: DATE: 08-053-15 Electrical May 08, 2015 This bulletin is supplied as technical information only and is not an authorization for repair. No part of this publication may be reproduced, stored in a retrieval system, or transmitted, in any form or by any means, electronic, mechanical, photocopying, or otherwise, without written permission of FCA US LLC. THIS SERVICE BULLETIN IS ALSO BEING RELEASED AS RAPID RESPONSE TRANSMITTAL (RRT) 15-050. ALL APPLICABLE SOLD AND UN-SOLD RRT VIN's HAVE BEEN LOADED. TO VERIFY THAT THIS RRT SERVICE ACTION IS APPLICABLE TO THE VEHICLE, USE VIP OR PERFORM A VIN SEARCH IN TECHCONNECT. ALL REPAIRS ARE REIMBURSABLE WITHIN THE PROVISIONS OF WARRANTY. THE wiTECH SOFTWARE LEVEL MUST BE AT 15.04 OR HIGHER TO PERFORM THIS PROCEDURE. SUBJECT: Cluster Backlighting Dimming Incorrectly OVERVIEW: This bulletin involves replacing and programming the instrument panel cluster. MODELS: 2015 (BU) Jeep Renegade (Brazil only) NOTE: This bulletin applies to vehicles built on or before April 10, 2015 (MDH 0410XX) with Brazil Country Code (Sales Code 8A1). SYMPTOM/CONDITION: A small number of customer may notice that the cluster illumination is not dimming properly while in day or night modes. DIAGNOSIS: If a customer’s VIN is listed in VIP or your RRT VIN list, perform the repair. PARTS REQUIRED: Qty. Part No. Description 1 100224773 Instrument Panel Cluster REPAIR PROCEDURE: 1. Remove and replace the Instrument Cluster following the instructions on Dealer Connect, TechCONNECT under 08 - Electrical, 8J - Instrument Cluster, Removal/Installation. 08-053-15 -2- NOTE: Keep the Instrument Cluster un-installed but connected to its wiring harness. 2. Access the link for a remote setup http://tinyurl.com/k9pxlxb and fill the form. Press “Send (Enviar)” to be placed on the attendance line. NOTE: Make sure the computer is connected to the internet. 3. After the support session has been initiated, follow the instructions given from the chat line agent. 4. The agent will perform the programming remotely. be sure to pay attention to the chat session in the event some instruction is required. 5. Finish installing the new instrument cluster following the replacement procedure located in TechCONNECT under 08 - Electrical, 8J - Instrument Cluster, Installation. POLICY: Reimbursable within the provisions of the warranty. TIME ALLOWANCE: Labor Operation No: 08-45-10-9B Description Cluster, Instrument Panel - Replace (2 - Skilled) FAILURE CODE: ZZ Service Action Skill Category 6 - Electrical and Body Systems Amount 0.6 Hrs.