Technician Repor

2019
A3 Sedan & Cabriolet/S3/RS 3
Audi Pre-Delivery Inspection
Stock No.
Dealer Number
R.O. No.
VIN
Road test mileage out
Road test mileage in
Reminders
 All items must be completed prior to customer delivery by an Audi technician
 Audi recommends using an Audi approved battery charger to prevent excessive battery discharge during inspection
 ALL PDI function tests must be run in Guided Fault Finding (GFF) using PDI Total Function Test Plan only. Do NOT use Guided
Functions for any PDI related test as these will not be uploaded to the Paperless Server. Refer to the Special functions tab of ODIS
Diagnosis for using GFF for PDI function tests
 It is advised to start ODIS with the engine running to enable all 5F Test Plans in GFF
 For items marked with *, please refer to the PDI Technician Reference Document posted on ServiceNet for additional information
 For items marked with **, follow instructions for stock inventory vehicle
Vehicle Preparation
Exterior (continued)
 Check Elsa for open campaigns and updates
 Inspect exterior for damage, dings, dents and surface
scratches
 Deactivate vehicle transport mode*
This step must be performed with the engine off, and ignition on
Lighting and Windshield
 Set service reminder*
 Test exterior lighting functions
 Perform any open campaigns*
 Test front washers (and headlight washers on S3 and RS 3)*
 Set the service intervals to 10k instead of 5k during PDI or
existing 2018 vehicles that are set incorrectly
 Install wiper blades
1. Click on the “Special functions” tab
Trunk Inspection
2. Scroll down to ‘Maintenance’
 Verify trunk is operational
3. Select the 17 - inspection with oil change - 10,000 miles,
USA function test
 Verify operation of emergency release handle
4. Perform the function test, but make sure you select
“USA” as the country variant and when the question
“Which service display should be reset?” comes up,
select #2 (Oil service display and inspection service
display).
5. Then the MMI® indicator should now properly display the
following values
− Next oil service in 10,000 miles / 365 days
− Next inspection service at 20,000 miles / 730 days
Exterior
 Check all key buttons and features*
 Inspect the outer door seals at all four doors and clean any
visible adhesive using D 002 000 A2 Adhesive Remover or
Acetone
Effective 9-17-2018-US
Version 1.0
 Install wheel bolt cover removal tool from PDI kit into trunk
tool kit*
 Verify tool kit is installed securely in luggage compartment
 Verify inflatable repair kit and compressor are present (A3
Cabriolet quattro and RS 3 only)
 Verify temporary inflatable spare tire is present (A3 Sedan,
S3, and A3 Cabriolet FWD only)*
 Check battery clamps for proper torque*
Interior
 Verify operation of all seat belts and latches
 Check operation of window, lock, and seat controls*
 Inspect mirrors for proper operation*
 Check rear view mirror operation*
 Verify operation of all interior lights
PRE-DELIVERY INSPECTION (PDI) | 1
2019
A3 Sedan & Cabriolet/S3/RS 3
Audi Pre-Delivery Inspection
Interior (continued)
On-Hoist Inspection (continued)
 Verify operation of heated seats
 Inspect wheel bolts for proper torque*
 Verify operation of manual folding 2nd row
 Install wheel locks (if equipped)
 Verify proper operation of climate control*
 Install wheel bolt covers and center caps as supplied*
 Inspect operation of all power outlets*
 Set and store tire pressures for either sold vehicle OR stock
inventory vehicle*
 Check panoramic sunroof and sunshade operation (Sedan
only)*
 Verify the glove compartment opens and closes properly
 Verify operation of front Passenger Occupant Detection
System
Driving Performance
 Check horn operation
 Verify hold and release of electronic parking brake
 Verify engine Start-Stop System functionality*
Settings
 Verify operation of MMI® touch (if equipped)
 Set time source setting to “GPS” and set auto daylight savings time to “on.”*
 Set Time to “Automatic setting” and “Automatic time zone”
 Verify and set language and measurement units*
 Verify Speech Dialog System is operating (if equipped)*
 Verify engine performance and acceleration*
 Verify transmission operation, including shift paddles (if
equipped)
 Test drive vehicle applying brakes several times*
 Check steering/tire alignment
 Check for squeaks, rattles and wind noise
 Calibrate rear view mirror*
 Set “Entertain. Fad.” in parking aid to an audible level (if
equipped)*
 Verify quality of radio reception in AM/FM/SiriusXM® bands
 Set dealership location in navigation (if equipped)*
Driver Assistance
 Turn off Manual Speed Warning*
 Verify cruise control/ACC functionality (if equipped)
Media / Radio / SAT
 Verify operation of all USB ports
 Verify operation of aux. input
 Verify operation of CD/DVD player (if equipped)
 Insert SD card and test function of slots
 Program the presets to local stations
 Verify Audi side assist functionality (if equipped)
 Verify Audi side assist with with rear cross traffic assist (if
equipped)
 Verify Audi active lane assist functionality (if equipped)
 Verify operation of Audi parking system (if equipped)*
 Verify operation of High-beam assist (if equipped)
 Verify HD Radio is turned “off”*
 Activate navigation and follow directions back to dealership
(if equipped)
Audi connect® (USA ONLY) (if equipped)
Cabriolet Functionality
 Turn on the Wi-Fi® hotspot (if equipped)*
 Test operation of power folding top*
 Check Wi-Fi® hotspot visibility. No data available at PDI (if
equipped)*
 Verify convertible top manual closing tools are present
 Enable Google Earth view for navigation (if equipped)*
Post-Road Test Inspection
On-Hoist Inspection
 Interrogate fault memory and upload diagnostic log to GFF
Paperless Server
 Remove transport suspension blocks (follow ELSA instruction)
 Select reset interval in the MIB Service and Checks menu if it
is not displaying correct 10K and 20K intervals
 Check steering, boots, brake system, hoses, tires and wheels
for damage
 Perform a battery test*
 Check underside of vehicle for fluid leaks and loose components
 Check service interval and verify correct interval is displayed
PRE-DELIVERY INSPECTION (PDI) | 2
Effective 9-17-2018-US
Version 1.0
2019
A3 Sedan & Cabriolet/S3/RS 3
Audi Pre-Delivery Inspection
Post-Road Test Inspection (continued)
 Check engine oil level*
 Check all fluid levels and top off if necessary
 Ensure the yellow tire pressure tag is installed on the
steering wheel
 Apply Inventory Maintenance Sticker**
 Install showroom charger to ensure battery remains
charged at all times**
 Must fuel with 91 Octane or higher (S3, RS 3)
Technician
I certify that all operations have been completed and this vehicle has been prepared in accordance with Audi Procedures and
Quality Standards, and has met the standards for Perfect Delivery.
Technician Signature
Effective 9-17-2018-US
Version 1.0
Last 8 of VIN
Completion Date
PRE-DELIVERY INSPECTION (PDI) | 3