T-SB-0055-18-Rev
Service Bulletin Details
Public Details for: T-SB-0055-18-Rev
Tsb: revision notice september 12, 2018 rev1: ? The warranty information section has been updated. Any previous printed versions of this bulletin should be discarded. Some 2016 ? 2018 model year tacoma vehicles equipped with an led type cen
Models from 2018
2018 TOYOTA TACOMA |
Models from 2017
2017 TOYOTA TACOMA |
Models from 2016
2016 TOYOTA TACOMA |
T-SB-0055-18 Rev1 July 2, 2018 Water Leak at Rear of Cab - Center High Mount Stop Lamp Service Category Vehicle Exterior Section Lighting (ext) Market USA Applicability YEAR(S) MODEL(S) ADDITIONAL INFORMATION 2016 - 2018 Tacoma Body Type(s): Double Cab REVISION NOTICE September 12, 2018 Rev1: The Warranty Information section has been updated. Any previous printed versions of this bulletin should be discarded. Introduction Some 2016 – 2018 model year Tacoma vehicles equipped with an LED type center high mount stop lamp may exhibit a water leak into the rear of the cab. Upon closer inspection, it may become apparent that the water leak is coming from the space between the center high mount stop lamp and the body of the vehicle. Follow the Repair Procedure in this bulletin to address this condition. Production Change Information This bulletin applies to vehicles produced BEFORE the Production Change Effective VINs shown below. MODEL PLANT DRIVETRAIN TMMBC Tacoma PRODUCTION CHANGE EFFECTIVE VIN 3TM######JM141428 ALL TMMTX 5TF######JX137401 © 2018 Toyota Motor Sales, USA Page 1 of 3 T-SB-0055-18 Rev1 July 2, 2018 Page 2 of 3 Water Leak at Rear of Cab - Center High Mount Stop Lamp Warranty Information OP CODE DESCRIPTION TIME OFP T1 T2 811571X R & R Center Stop Light for LED Type 2.2 81570-04040 66 57 APPLICABLE WARRANTY This repair is covered under the Toyota Basic Warranty. This warranty is in effect for 36 months or 36,000 miles, whichever occurs first, from the vehicle’s in-service date. Warranty application is limited to occurrence of the specified condition described in this bulletin. Parts Information PART NUMBER PREVIOUS NEW 81570-04040 81570-04050 PART NAME QTY Lamp Assy, Stop Center 1 Repair Procedure 1. Confirm the water leak condition exists. A. Apply water on and around the center high mount stop lamp and check the interior trim, headliner, and back glass for water drop formations on the interior of the vehicle. Does the vehicle exhibit a water leak into the rear of the cab? YES — Continue to substep B. NO — This bulletin does NOT apply. Continue diagnosis using the applicable Repair Manual. B. Is the source of the leak above the headliner? YES — Continue to step 2. NO — This bulletin does NOT apply. Continue diagnosis using the applicable Repair Manual. 2. Lower the headliner to inspect for the source of the leak. Is the source of the leak the center high mount stop lamp? YES — Continue to step 3. NO — This bulletin does NOT apply. Continue diagnosis using the applicable Repair Manual. © 2018 Toyota Motor Sales, USA T-SB-0055-18 Rev1 July 2, 2018 Page 3 of 3 Water Leak at Rear of Cab - Center High Mount Stop Lamp Repair Procedure (continued) 3. Remove the center stop lamp assembly. Refer to TIS, applicable model and model year Repair Manual: 2016 – 2018 Tacoma: Vehicle Interior – Lighting (int) – “Lighting: High Mounted Stop Light Assembly: Removal” 4. Install the NEW center stop lamp assembly. NOTE Make sure the body of the vehicle is clean and dry BEFORE installing the NEW part. Refer to TIS, applicable model and model year Repair Manual: 2016 – 2018 Tacoma: Vehicle Interior – Lighting (int) – “Lighting: High Mounted Stop Light Assembly: Installation” 5. Confirm that the water leak condition no longer exists. © 2018 Toyota Motor Sales, USA