7F2-Q5F39-12

XPOLogistics Manufacturing
ANCRA Track Replacement
November 29, 2018
If an ANCRA Lift-A-Deck track is damaged or has exceeded maximum allowable wear in the
groves, the track will need to be replaced. This document details the procedure for replacing
tracks that are attached to the composite sidewalls with rivets and adhesive.
1. Using a chisel, drill, or other available tool, remove the head of the rivet from the inside
of the trailer. Then use a punch to drive the rivet body through the sidewall panel, from
the inside.
2. Use a heat gun on the surface of the ANCRA track to weaken the adhesive. Use a thin
piece of wire or a putty knife behind the track to pry the track away from the panel. The
heat gun and wire/putty knife will have to be used at the same time to work from one end
of the track to the other (starting at the top and working down).
3. Remove any remaining adhesive from the panel using the heat gun and a scraper.
4. Clean the panel and the rear surface of the replacement ANCRA track with alcohol.
5. Apply a bead of adhesive (3/16” in diameter) to the rear of the ANCRA track. Try to
keep the bead centered in the middle of the track.
6. Line the track up with the existing holes and press the track against the wall. Take care
not to pick the track up once it has been placed as this can create air bubbles which can
weaken the adhesive. The track can be slid from side-to-side to help align the holes
without causing any issues.
7. Replace all rivets (6300174 8-8) from the inside. Put a ¼” flat washer on the stem of the
rivet on the outside of the panel to ensure a good seal. If 6300174 is not available a solid
rivet can be used in its place (6300112 8-8).
8. Avoid using the replaced track for at least 12 hours to allow the adhesive plenty of time
to cure. Colder climates will slow the curing process.
2001 S. Benton Street, Searcy, AR 72143
Phone 501-279-0991