060309004M

Service Bulletin Details

Public Details for: 060309004M

This technical bulletin provides a procedure to apply grease to the leaf springs to correct a condition of a squeak noise from the metals making contact.


- 2019 - 2018 - 2017 - 2016 - 2015 - 2014 - 2013 - 2012 - 2011 - 2010 - 2009 - 2008 - 2007 - 2006 - 2005 - 2004 - 2003 - 2002 - 2001 - 2000 - 1999 -

Models from 2005
2005 GMC C SERIES
Models from 2004
2004 GMC C SERIES
Models from 2003
2003 GMC G SERIES
Models from 2002
2002 GMC GM
Models from 2001
2001 GMC GM
Models from 2000
2000 GMC G SERIES
Models from 1999
1999 GMC G SERIES
Bulletin No.:
Service Bulletin
Date:
06-03-09-004M
June, 2019
TECHNICAL
Subject:
Squeak Noise from Rear of Vehicle (Lubricate Rear Leaf Springs)
Models:
1999 - 2007 Chevrolet Silverado (Classic)
2007 - 2013 Chevrolet Silverado 1500
2007 - 2019 Chevrolet Silverado 2500/3500
2014 - 2019 Chevrolet Express
1999 - 2007 GMC Sierra (Classic)
2007 - 2013 GMC Sierra 1500
2007 - 2019 GMC Sierra 2500/3500
2014 - 2019 GMC Savana
2007 - 2010 HUMMER H3, H3T
Attention: This Bulletin also applies to any of the above models that may be Export from North
America vehicles.
This Bulletin has been revised to add 2019 model year. Please discard Corporate Bulletin
Number 06-03-09-004L.
Condition
Correction
Some customers may comment about a squeak noise
coming from the rear of the vehicle. During normal
operation, certain vehicles may exhibit a squeaking
noise that may be traced to the rear leaf springs. While
this noise is an operating characteristic of leaf springs,
the frequency and severity of this noise will be affected
by the roads that the vehicle is driven on.
To correct this condition, lubricate the rear leaf springs
using the following procedure.
Important: It has been found that the application of
grease to the rear leaf springs does a better job of
preventing the noise from reoccurring than replacement
of the spring.
1. Raise the vehicle on a frame lift-type hoist.
2. Inspect the springs for damage. If none is found,
proceed to the next step.
3. Pressure wash the rear leaf springs to remove as
much dirt and grit as possible.
4. Dry the springs with compressed air.
Cause
This condition may be due to debris getting between
the leaf springs.
Copyright 2019 General Motors LLC. All Rights Reserved.
Page 2
June, 2019
Bulletin No.: 06-03-09-004M
1826776
4842041
4842042
Bulletin No.: 06-03-09-004M
June, 2019
Page 3
Please inform the customer that this will offer relief, but
is not a lifetime repair. Periodic cleaning and grease
re-application may be necessary throughout the life of
the vehicle.
For 1500 Series (½ ton) models only: On vehicles
built prior to October 2004, if the above procedure does
not correct this noise, it could be caused by an
incorrectly dimensioned splay clip (the band holding the
ends of the leafs together) that interferes with the leaf
springs. A 5 mm (0.197 in) wider splay clip was
introduced in early 2005 model year to provide
additional clearance. To correct this concern, replace
the rear leaf spring assembly. There was no change to
the part number.
Parts Information
4842043
Note: Ensure any tool used to gently pry the tip inserts
or spring leaves is protected to prevent damage to the
spring leaves.
5. Apply a liberal amount of grease, P/N 19356408 (in
Canada, use P/N 19356409), both underneath and
on top of the front and rear tip inserts for the #2 and
#3 leaves, as indicated above. A screwdriver can
be used to gently pry up the leaf; however, a rag
around the screwdriver must be used to prevent
damage to the leaf. Use a flat-bladed tool, such as
a gasket scraper or a brush to properly distribute
the grease at least 6 inches from each end of
the leaf.
6. Lower the vehicle to the ground and test drive to
verify the repair.
Part Number
Description
Qty
19356408
(in Canada,
use 19356409)
Lubricant
2
Warranty Information
For vehicles repaired under warranty, use:
Labor
Operation
Description
Labor
Time
Lubricate Rear Leaf Springs-LD
0.5 hr
Lubricate Rear Leaf
Springs-HD
0.9 hr
8080008*
*This is a unique Labor Operation for Bulletin use only.
GM bulletins are intended for use by professional technicians, NOT a "do-it-yourselfer". They are written to inform these
technicians of conditions that may occur on some vehicles, or to provide information that could assist in the proper
service of a vehicle. Properly trained technicians have the equipment, tools, safety instructions, and know-how to do a
job properly and safely. If a condition is described, DO NOT assume that the bulletin applies to your vehicle, or that your
vehicle will have that condition. See your GM dealer for information on whether your vehicle may benefit from the
information.
WE SUPPORT VOLUNTARY
TECHNICIAN
CERTIFICATION


© dot.report 2024

Use of this information constitutes acceptance for use in an AS IS condition. There are NO warranties, implied or otherwise, with regard to this information or its use. Any use of this information is at the user's risk. It is the responsibility of user to evaluate the accuracy, completeness or usefulness of any information, opinion, advice or other content. EACH USER WILL BE SOLELY RESPONSIBLE FOR ANY consequences of his or her direct or indirect use of this web site. ALL WARRANTIES OF ANY KIND ARE EXPRESSLY DISCLAIMED. This site will NOT BE LIABLE FOR ANY DIRECT, INDIRECT or any other kind of loss.