PIC5779K

Service Bulletin Details

Public Details for: PIC5779K

This preliminary information communication provides the technician with information on the proper washing of the bright aluminum moldings to avoid the moldings from getting damaged. It is recommended that a non-alkaline solution be used for


- 2020 - 2019 - 2018 - 2017 - 2016 - 2015 - 2014 - 2013 - 2012 - 2011 -

Bulletin No.: PIC5779K
Published date: 07/19/2019
Preliminary Information
PIC5779K Information on Preparation / Washing to Avoid
Damaging Bright Aluminum Moldings
Models
Brand:
Model:
Model Years:
VIN:
from
to
Engine:
Transmissions:
Buick
Envision
2017 - 2020
ALL
ALL
ALL
ALL
Buick
LaCrosse
2017 - 2019
ALL
ALL
ALL
ALL
Buick
Regal
2011 - 2020
ALL
ALL
ALL
ALL
Cadillac
ATS
2013 - 2019
ALL
ALL
ALL
ALL
Cadillac
CTS Sedan VIN A
2014 - 2019
ALL
ALL
ALL
ALL
Cadillac
XT5
2017 - 2020
ALL
ALL
ALL
ALL
Cadillac
XTS
2013 - 2019
ALL
ALL
ALL
ALL
Chevrolet
Cruze
2011 - 2019
ALL
ALL
ALL
ALL
Chevrolet
Impala (New Body Style)
2014 - 2020
ALL
ALL
ALL
ALL
Chevrolet
Malibu
2016 - 2020
ALL
ALL
ALL
ALL
Chevrolet
Volt
2016 - 2019
ALL
ALL
ALL
ALL
GMC
Acadia
2017 - 2019
ALL
ALL
ALL
ALL
Supersession Statement
This PI was superseded to update Model Years. Please discard PIC5779J.
The following diagnosis might be helpful if the vehicle exhibits the symptom(s) described in this PI.
Condition / Concern
Important: Do Not Wash The Vehicle Until This Information Has Been Reviewed. This PI is being made available to
advise dealers and customers alike on proper care of Bright Aluminum Moldings.
Recommendations / Instructions
Important: Please ensure this information is reviewed with vehicle owners. In order to avoid damage that may
not be covered by your warranty, it is recommended that a non-alkaline solution be used for preparation &
washing of the Bright Aluminum Moldings.
If a cleaning solution greater than 11.0 pH is used, the following procedure must be used:
- Prewash the vehicle to bring moldings to room temperature.
- Apply cleaning solution out of the sunlight at room temperature.
- Rinse moldings with clean water within 5 minutes of application of cleaning solution.
Please follow this diagnostic or repair process thoroughly and complete each step. If the condition exhibited is
resolved without completing every step, the remaining steps do not need to be performed.
Additional SI Keywords
belt chrome damage emblem exterior handle molding spot
© 2019 General Motors. All Rights Reserved.


© dot.report 2024

Use of this information constitutes acceptance for use in an AS IS condition. There are NO warranties, implied or otherwise, with regard to this information or its use. Any use of this information is at the user's risk. It is the responsibility of user to evaluate the accuracy, completeness or usefulness of any information, opinion, advice or other content. EACH USER WILL BE SOLELY RESPONSIBLE FOR ANY consequences of his or her direct or indirect use of this web site. ALL WARRANTIES OF ANY KIND ARE EXPRESSLY DISCLAIMED. This site will NOT BE LIABLE FOR ANY DIRECT, INDIRECT or any other kind of loss.