T-SB-0084-19

T-SB-0084-19
July 24, 2019
Carpet Pulling Out From Side Trim
Service
Category
Vehicle Interior
Section
Interior Panels/Trim
Market USA
Applicability
YEAR(S)
MODEL(S)
ADDITIONAL INFORMATION
2015 - 2019
Yaris
Body Type(s): 5D, 5Dr. Hatch Back
Introduction
Some 2015 – 2019 model year Yaris vehicle passenger front, passenger rear, and/or driver rear
doors may exhibit floor carpet that appears deformed or incorrect. When weight is applied on the
floor near the door scuff plate, the carpet can be pulled out from behind it. Follow the Repair
Procedure in this bulletin to address this condition.
Warranty Information
OP CODE
DESCRIPTION
TIME
BD1904
Resecure Floor Carpet
0.4
Combo A
Each Additional Repair Location
0.3
OFP
T1
T2
58510-0D770-C1
67
57
APPLICABLE WARRANTY
 This repair is covered under the Toyota Basic Warranty. This warranty is in effect for 36 months
or 36,000 miles, whichever occurs first, from the vehicle’s in-service date.
 Warranty application is limited to occurrence of the specified condition described in
this bulletin.
© 2019 Toyota Motor Sales, USA
Page 1 of 4
T-SB-0084-19
July 24, 2019
Page 2 of 4
Carpet Pulling Out From Side Trim
Required Tools & Equipment
REQUIRED TOOLS & MATERIAL
QUANTITY
Insulating Felt or Thick Tape (30 in. Long and AT LEAST 2 in. Wide)
1
Hole Punch or Knife
1
Cable Tie
1*
*Cable tie quantity may differ based on affected area. Refer to the Repair Procedure.
Repair Procedure
1. Confirm the condition exists.
Does the passenger front, passenger rear, and/or driver rear doors exhibit floor carpet that
appears deformed or incorrect?
 YES — Continue to step 2.

NO — This bulletin does NOT apply. Continue diagnosis using the applicable
Repair Manual.
Figure 1. Good Condition
Figure 2. Not Good Condition
2. Remove the scuff plate from the lower doorjamb of the affected area.
© 2019 Toyota Motor Sales, USA
T-SB-0084-19
July 24, 2019
Page 3 of 4
Carpet Pulling Out From Side Trim
Repair Procedure (continued)
3. Using a knife or hole punch, make a hole in the carpet just large enough to fit a cable tie
through. (See Figures 3 and 4.)
 Passenger front: Three holes and three cable ties

Passenger rear (left and right sides): One hole and one cable tie
4. Cut the 30 x 2-in. insulating felt or thick tape into five 6 x 2-in. pieces.
5. At each of the five cable tie locations, wrap the cut felt or tape completely around the conduit
and the drain tube.
6. Route the cable tie underneath the conduit and through the punched hole in the carpet.
Figure 3. Passenger Front
5
Figure 4. Passenger Rear
1
c
4
3
4
2
2
3
1
c
1
Passenger Front Side
2
Drain Tube
3
Front of Vehicle
1
Front of Vehicle
4
Insulating Felt
2
Drain Tube
5
Cable Tie
3
Insulating Felt
4
Cable Tie (One for Each Side)
© 2019 Toyota Motor Sales, USA
T-SB-0084-19
July 24, 2019
Carpet Pulling Out From Side Trim
Repair Procedure (continued)
7. Close the cable tie and tighten it, making sure not to pinch the drain tube.
8. Cut the excess plastic off of the end of the cable tie.
9. Position the head of the cable tie between the conduit and the weatherstrip.
10. Reinstall the scuff plate to the lower doorjamb of the affected area(s).
11. Visually confirm the repair.
© 2019 Toyota Motor Sales, USA
Page 4 of 4