P-SC-2014020002

Campaign No. 2014020002, February 2014
TO:
ALL MERCEDES-BENZ CENTERS
SUBJECT:
Model 231 (SL), Model Year 2014
Insulate Washer Fluid Reservoir Wiring Harness
This Service Campaign has been initiated because Daimler AG (DAG), the manufacturer of MercedesBenz vehicles, has determined that additional washer fluid reservoir wire harness insulation is required at
the cable grommet. An authorized Mercedes-Benz dealer will install additional washer fluid reservoir
wiring harness insulation at the next workshop visit.
Prior to performing this Service Campaign:

Please check VMI to determine if the vehicle is involved in the Campaign and if it has been previously
repaired.

Please review the entire Service Campaign bulletin and follow the repair procedure exactly as
described.
Approximately 225 vehicles are affected.
Order No. P-SC-2014020002
This bulletin has been created and maintained in accordance with MBUSA-SLP S423QH001, Document and Data
Control, and MBUSA-SLP S424HH001, Control of Quality Records.
2
Procedure
1. Remove windshield washer fluid reservoir (A, Figure 1), refer to WIS: AR82.35-P-6000RK.
A
Figure 1
Note (regarding above WIS instructions):

Tire rotation does not apply to this campaign.

Collect windshield washer fluid and reuse (pour fluid through a strainer when refilling reservoir).

Do not remove windshield washer pump(s) from reservoir.

Ensure wiring harness is dry before applying tape (tape will not adhere to a wet harness).

Ensure windshield washer fluid does not spill on harness.

Perform campaign prior to topping off windshield washer fluid.
2. Seal (wrap) wiring harness for washer fluid reservoir (A, Figure 1) from A-pillar grommet to washer fluid
reservoir with PVC plastic adhesive tape in marked area (Figure 2).
Figure 2
P-SC- 2014020002
3
Note:
Ensure that there is an overlap with the grommet (Figure 3).
There must also be an overlap of at least 50 % at the windings.


Figure 3
3. Additionally, wrap G12 fabric tape around the wiring harness along the entire length of the PVC plastic
adhesive tape.
4. Assemble in the reverse order.
Note (regarding referenced WIS instructions):
Windshield wiper fluid is shop supply.
Primary Parts Information
Qty.
Part Name
Part Number
1 1)
1 2)
1
A 001 989 17 85
A 007 989 07 85
A 004 997 9890
1)
2)
PVC plastic adhesive tape
G12 fabric tape
Cable tie
Estimated Replacement
Rate
100%
1 roll of PVC plastic adhesive tape is sufficient for 50 vehicles. Submit as local purchase PVC00264, handling is included.
1 roll of G12 fabric tape is sufficient for 12 vehicles. Submit as local purchase GFT00014, handling is included.
P-SC- 2014020002
4
Note:

Please be aware that only the part number(s) referenced in the Campaign Bulletin is/are approved for
use to repair the vehicle. Repairs performed using any other part(s) will not have been performed in
accordance with the campaign. Accordingly, warranty claims submitted with reference to an improper
part number(s) will be denied.

The following allowable labor operation should be used when submitting a warranty claim for this repair:
Warranty Information
Operation: Insulate washer fluid reservoir wiring harness (02-8395).
Damage Code
59 911 33 7
Operation Number
02-8395
Note:
Operation Number labor times are subject to change.
P-SC- 2014020002
Labor Time (hrs.)
1.2