20A4TECHREP1219

Service Bulletin Details

Public Details for: 20A4TECHREP1219

"vehicle preparation section: added additional steps to perform tsb 2058096/1 "91 audi connect has no function, sos led is off, and sos warning message in fpk"": - perform mmi menu reset: 5f-information electronics >> guided functions >>


- 2020 -

2020
A4/S4/A4 allroad
Audi Pre-Delivery Inspection
Stock No.
Dealer Number
R.O. No.
VIN
Road test mileage out
Road test mileage in
Reminders
 All items must be completed prior to customer delivery by a certified Audi technician
 Audi recommends using an Audi approved battery charger to prevent excessive battery discharge during inspection
 ALL PDI function tests must be run in Guided Fault Finding (GFF) using PDI Total Function Test Plan only. Do NOT use Guided
Functions for any PDI related test as these will not be uploaded to the Paperless Server. Refer to the Special functions tab of ODIS
Diagnosis for using GFF for PDI function tests
 It is advised to start ODIS with the engine running to enable all 5F Test Plans in GFF
 For items marked with *, please refer to the PDI Technician Reference Document posted on ServiceNet for additional information
 For items marked with **, follow instructions for stock inventory vehicle
Vehicle Preparation
Trunk Inspection
 Check Elsa for open campaigns and updates
 Verify trunk is operational
 Verify Audi phone box customer registration form is present
in vehicle and add the serial number from Elsa (if equipped).
See TSB 2051720
 Verify operation of emergency release handle
 Perform any open campaigns*
 Verify tool kit is installed securely in luggage compartment
 Perform diagnostic work*
 Verify inflatable spare tire and compressor are present
 Perform TSB 2058096/1 “91 Audi connect has no function, SOS LED is off, and SOS warning message in FPK”
 Set spare tire pressure*
 Perform MMI Menu Reset: 5F-Information Electronics
>> Guided Functions >> Basic Settings >> Reset MMI
Menu Settings
 Deactivate privacy mode: Main Menu >> Privacy >>
Activate Privacy Settings (Turn off)
 Turn Vehicle Off and allow Bus Sleep Cycle
 Install front license plate carrier (if necessary)*
 Install wheel bolt cover removal tool from PDI kit into trunk
tool kit*
 Check battery clamps for proper torque*
Interior
 Verify operation of all seat belts and latches
 Check operation of window, lock, and seat controls*
 Inspect mirrors for proper operation*
 Check rear view mirror operation*
 Verify operation of all interior lights
Exterior
 Check all key buttons and features*
 Inspect exterior for damage, dings, dents and surface
scratches. Report and repair any damage before delivery to
the customer
Lighting and Windshield
 Test exterior lighting functions
 Test windshield washers. Correct aim if necessary
Effective 12-19-2019-US
Version 1.3
 Verify SOS button is green and Roadside assistance button
LED will remain off. Reference TSB 2052299 if issues occur
 Verify operation of heated seats
 Verify operation of heated rear seats (if equipped)
 Verify operation of ventilated seats (if equipped)
 Verify proper operation of climate control*
 Inspect operation of all power outlets*
 Check panoramic sunroof and sunshade operation*
 Verify the glove compartment opens and closes properly
 Verify operation of front Passenger Occupant Detection
System
PRE-DELIVERY INSPECTION (PDI) | 1
2020
A4/S4/A4 allroad
Audi Pre-Delivery Inspection
Settings
Driving Performance
 Set Time source setting to “GPS” and set Auto daylight savings time to “on”*
 Check horn operation
 Verify hold and release of electronic parking brake
 Verify operation of MMI® touch
 Verify engine Start-Stop System functionality*
 Set Time to “Automatic setting” and “Automatic time zone”
 Verify engine performance and acceleration*
 Verify and set language and measurement units*
 Verify transmission operation, including shift paddles
 Verify Speech Dialog System is operating*
 Test drive vehicle applying brakes several times*
 Set “Entertain. Fad.” in Parking aid to an audible level*
 Check steering/tire alignment
 Set “Music volume while parking” to medium*
 Check for squeaks, rattles and wind noise. Repair any
squeaks, rattles or wind noises before delivery to the customer
 Set dealership location in navigation (if equipped)*
 Turn off Manual Speed Warning (if equipped)*
 Calibrate rear view mirror*
 Verify quality of radio reception in AM/FM/SiriusXM® bands
Media / Radio / SAT
 Verify operation of aux. input
Driver Assistance
 Insert SD card and test function of all slots
 Verify cruise control/ACC functionality (if equipped)
 Verify HD Radio is turned “off”*
 Verify Audi side assist functionality (if equipped)
Audi connect® (USA ONLY) (if equipped)
 Verify operation of parking system (if equipped)*
 Turn on the Wi-Fi® hotspot (if equipped)*
 Verify all vehicle Head-up display functionality (if equipped)*
 Check Wi-Fi® hotspot visibility. No data available at PDI (if
equipped)*
 Activate NAV and follow directions back to dealership (if
equipped)
 Enable satellite map view for navigation (if equipped)*
Post-Road Test Inspection
On-Hoist Inspection
 Remove transport suspension blocks (follow ELSA instruction)
 Check steering, boots, brake system, hoses, tires and wheels
for damage
 Check underside of vehicle for fluid leaks and loose components
 Inspect wheel bolts for proper torque*
 Interrogate fault memory and upload Diagnostic Log to GFF
Paperless Server
 Check service interval and verify correct interval is displayed
 Check engine oil level*
 Check all fluid levels and top off if necessary
 Install wheel locks (if equipped)
 Ensure the yellow tire pressure tag is installed on the steering wheel
 Install wheel bolt covers and center caps as supplied*
 Apply 30 Day Inventory Maintenance Sticker**
 Set and store tire pressures for either sold vehicle OR stock
inventory vehicle*
 Install showroom charger to ensure battery remains
charged at all times**
Technician
I certify that all operations have been completed and this vehicle has been prepared in accordance with Audi Procedures and
Quality Standards, and has met the standards for Perfect Delivery.
Technician Signature
Effective 12-19-2019-US
Version 1.3
Last 8 of VIN
Completion Date
PRE-DELIVERY INSPECTION (PDI) | 2


© dot.report 2024

Use of this information constitutes acceptance for use in an AS IS condition. There are NO warranties, implied or otherwise, with regard to this information or its use. Any use of this information is at the user's risk. It is the responsibility of user to evaluate the accuracy, completeness or usefulness of any information, opinion, advice or other content. EACH USER WILL BE SOLELY RESPONSIBLE FOR ANY consequences of his or her direct or indirect use of this web site. ALL WARRANTIES OF ANY KIND ARE EXPRESSLY DISCLAIMED. This site will NOT BE LIABLE FOR ANY DIRECT, INDIRECT or any other kind of loss.