ITB19-041a
Service Bulletin Details
Public Details for: ITB19-041a
2020 q50; both center display screens are blank this bulletin has been amended. See amendment history on the last page. Please discard previous versions of this bulletin.
- 2020 -
Models from 2020
2020 INFINITI Q50 |
Classification: Reference: Date: EL19-067a ITB19-041a February 10, 2020 2020 Q50; BOTH CENTER DISPLAY SCREENS ARE BLANK This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin. APPLIED VEHICLE: 2020 Q50 (V37) APPLIED SYSTEM: Vehicles equipped with factory navigation system (Vehicles equipped with navigation will have an SOS button in the overhead console assembly). Figure 1 IF YOU CONFIRM Both the upper and the lower center display screens and the HVAC controls are inoperative at all times (not intermittent). ACTION Perform the SERVICE PROCEDURE starting on the next page to configure the TCU. IMPORTANT: The purpose of ACTION (above) is to give you a quick idea of the work you will be performing. You MUST closely follow the entire SERVICE PROCEDURE as it contains information that is essential to successfully completing this repair. Infiniti Bulletins are intended for use by qualified technicians, not 'do-it-yourselfers'. Qualified technicians are properly trained individuals who have the equipment, tools, safety instruction, and know-how to do a job properly and safely. NOTE: If you believe that a described condition may apply to a particular vehicle, DO NOT assume that it does. See your Infiniti retailer to determine if this applies to your vehicle. 1/5 SERVICE PROCEDURE IMPORTANT: Before starting the procedure, make sure: ASIST on the CONSULT PC has been synchronized (updated) to the current date. All CONSULT-III plus (C-III plus) software updates, if any, have been installed. 1. Set the parking brake. 2. Connect the C-III plus VI to the vehicle. 3. Turn the ignition ON. 4. Launch C-III plus on the CONSULT PC. 5. Select Re/programming, Configuration (Figure 2). HINT: C-III plus screen shots for steps 6-8 are not shown. 6. Read the Precautions on the C-III plus screen and then select Next. 7. Select the model and the model year. 8. Select Select and then select Confirm. 9. Figure 2 Select IVC (Figure 3). Figure 3 2/5 ITB19-041a 10. Select After ECU Replacement. Figure 4 11. Select Manual selection. Figure 5 3/5 ITB19-041a 12. Select the applicable Type ID by model year and model, then select Next. If the C-III plus automatically selects the Type ID, there will be no options shown under Type ID (Figure 6). Select OK. Figure 6 13. Wait for the configuration to complete. 14. Turn the ignition OFF. 15. Exit the vehicle and close all doors. 16. Wait five (5) minutes. 17. Turn the ignition ON, and confirm the center displays are operating correctly. 4/5 ITB19-041a CLAIMS INFORMATION Submit a Primary Part (PP) type line claim using the following claims coding: DESCRIPTION Perform TCU Configuration (1) PFP (1) OP CODE RX8UAA SYM ZE DIA 32 FRT 0.2 Reference the electronic parts catalog and use the Telematics Control Unit (28275-*****) as the Primary Failed Part (PFP). AMENDMENT HISTORY PUBLISHED DATE REFERENCE DESCRIPTION November 26, 2019 ITB19-041 Original bulletin published February 10, 2020 ITB19-041a IF YOU CONFIRM statement updated 5/5 ITB19-041a