20A3S3RS3TECHREP
Service Bulletin Details
Public Details for: 20A3S3RS3TECHREP
Reminders section: changed testing verbiage to: - guided fault finding must be used, session must be completed and sent to gff paperless - total pdi test must be completed prior to any other work involving the scan tool (special function
- 2020 -
Models from 2020
2020 AUDI A3 |
2020 AUDI RS3 |
2020 AUDI S3 |
2020 A3/S3/RS 3 Audi Pre-Delivery Inspection Stock No. Dealer Number R.O. No. VIN Road test mileage out Road test mileage in Reminders All items must be completed prior to customer delivery by a certified Audi technician Audi recommends using an Audi approved battery charger to prevent excessive battery discharge during inspection Guided Fault Finding must be used, session must be completed and sent to GFF Paperless Total PDI Test must be completed prior to any other work involving the scan tool (special function tab -> Total PDI Test) Start Guided Fault Finding with the engine running to insure control modules in transport mode are identified For items marked with *, please refer to the PDI Technician Reference Document posted on ServiceNet for additional information For items marked with **, follow instructions for stock inventory vehicle Vehicle Preparation Trunk Inspection (continued) Check Elsa for open campaigns and updates Install wheel bolt cover removal tool from PDI kit into trunk tool kit* Verify Audi phone box customer registration form is present in vehicle and add the serial number from Elsa (if equipped). See TSB 2051720 Set adaption channel to enable CD Ripping using Guided Functions (if equipped with NAV)* Verify tool kit is installed securely in luggage compartment Verify inflatable repair kit and compressor are present (RS 3 only) Perform any open campaigns* Verify temporary inflatable spare tire is present (A3 Sedan and S3 FWD only)* Perform diagnostic work* Check battery clamps for proper torque* Install front license plate carrier (if necessary)* Interior Exterior Verify operation of all seat belts and latches Check all key buttons and features* Check operation of window, lock, and seat controls* Inspect the outer door seals at all four doors and clean any visible adhesive using D 002 000 A2 Adhesive Remover or Acetone Inspect mirrors for proper operation* Inspect exterior for damage, dings, dents and surface scratches. Report and repair any damage before delivery to the customer Lighting and Windshield Test exterior lighting functions Test windshield washers (and headlight washers on S3/RS 3). Correct aim if necessary* Trunk Inspection Verify trunk is operational Check rear view mirror operation* Verify operation of all interior lights Verify operation of heated seats Verify operation of manual folding 2nd row Verify proper operation of climate control* Inspect operation of all power outlets* Check panoramic sunroof and sunshade operation (Sedan only)* Verify the glove compartment opens and closes properly Verify operation of front Passenger Occupant Detection System Verify operation of emergency release handle Effective 3-24-2020-US Version 1.2 PRE-DELIVERY INSPECTION (PDI) | 1 2020 A3/S3/RS 3 Audi Pre-Delivery Inspection Settings Driving Performance (continued) Verify operation of MMI® touch (if equipped) Verify engine performance and acceleration* Set time source setting to “GPS” (if equipped) and set auto daylight savings time to “on” * Verify transmission operation, including shift paddles (if equipped) Set Time to “Automatic setting” and “Automatic time zone” Test drive vehicle applying brakes several times* Verify and set language and measurement units* Check steering/tire alignment Verify Speech Dialog System is operating (if equipped)* Check for squeaks, rattles and wind noise. Repair any squeaks, rattles or wind noises before delivery to the customer Set “Entertain. Fad.” in parking aid to an audible level (if equipped)* Set dealership location in navigation (if equipped)* Turn off Manual Speed Warning* Calibrate rear view mirror* Verify quality of radio reception in AM/FM/SiriusXM® bands Media / Radio / SAT Driver Assistance Verify operation of all USB ports Verify cruise control/ACC functionality (if equipped) Verify operation of aux. input Verify Audi side assist functionality (if equipped) Verify operation of CD/DVD player (if equipped) Verify Audi side assist with with rear cross traffic assist (if equipped) Insert SD card and test function of slots Program the presets to local stations Verify HD Radio is turned “off”* Audi connect (USA ONLY) (if equipped) ® Turn on the Wi-Fi® hotspot (if equipped)* Check Wi-Fi® hotspot visibility. No data available at PDI (if equipped)* Enable satellite map view for navigation (if equipped)* On-Hoist Inspection Remove transport suspension blocks (follow ELSA instruction) Check steering, boots, brake system, hoses, tires and wheels for damage Check underside of vehicle for fluid leaks and loose components Inspect wheel bolts for proper torque* Install wheel locks (if equipped) Install wheel bolt covers and center caps as supplied* Set and store tire pressures for either sold vehicle OR stock inventory vehicle* Verify Audi active lane assist functionality (if equipped) Verify operation of Audi parking system (if equipped)* Verify operation of High beam assist (if equipped) Activate navigation and follow directions back to dealership (if equipped) Post-Road Test Inspection Interrogate fault memory and upload diagnostic log to GFF Paperless Server Select reset interval in the MMI vehicle settings Service and Checks menu if it is not displaying correct 10K and 20K intervals Check service interval and verify correct interval is displayed Check engine oil level* Check all fluid levels and top off if necessary Ensure the yellow tire pressure tag is installed on the steering wheel Apply 30 Day Inventory Maintenance Sticker** Install showroom charger to ensure battery remains charged at all times** Must fuel with 91 Octane or higher (S3, RS 3) Driving Performance Check horn operation Verify hold and release of electronic parking brake Verify engine Start-Stop System functionality* Effective 3-24-2020-US Version 1.2 PRE-DELIVERY INSPECTION (PDI) | 2 2020 A3/S3/RS 3 Audi Pre-Delivery Inspection Technician I certify that all operations have been completed and this vehicle has been prepared in accordance with Audi Procedures and Quality Standards, and has met the standards for Perfect Delivery. Technician Signature Effective 3-24-2020-US Version 1.2 Last 8 of VIN Completion Date PRE-DELIVERY INSPECTION (PDI) | 3