20A5S5RS5TECHREP

Service Bulletin Details

Public Details for: 20A5S5RS5TECHREP

Reminders section: changed testing verbiage to: - guided fault finding must be used, session must be completed and sent to gff paperless - total pdi test must be completed prior to any other work involving the scan tool (special function


- 2020 -

2020
A5/S5
Audi Pre-Delivery Inspection
Stock No.
Dealer Number
R.O. No.
VIN
Road test mileage out
Road test mileage in
Reminders
 All items must be completed prior to customer delivery by a certified Audi technician
 Audi recommends using an Audi approved battery charger to prevent excessive battery discharge during inspection
 Guided Fault Finding must be used, session must be completed and sent to GFF Paperless
 Total PDI Test must be completed prior to any other work involving the scan tool (special function tab -> Total PDI Test)
 Start Guided Fault Finding with the engine running to insure control modules in transport mode are identified
 For items marked with *, please refer to the PDI Technician Reference Document posted on ServiceNet for additional information
 For items marked with **, follow instructions for stock inventory vehicle
Vehicle Preparation
Trunk Inspection (continued)
 Check Elsa for open campaigns and updates
 Verify operation of emergency release handle
 Verify Audi phone box customer registration form is present
in vehicle and add the serial number from Elsa (if equipped).
See TSB 2051720
 Install wheel bolt cover removal tool from PDI kit into trunk
tool kit*
 Perform any open campaigns*
 Set spare tire pressure*
 Perform diagnostic work*
 Check battery clamps for proper torque*
 Perform TSB 2058096/1 “91 Audi connect has no function,
SOS LED is off, and SOS warning message in FPK”
Interior
 Perform MMI Menu Reset: 5F-Information Electronics >>
Guided Functions >> Basic Settings >> Reset MMI Menu
Settings
 Deactivate privacy mode: Main Menu >> Privacy >> Activate Privacy Settings (Turn off)
 Turn Vehicle Off and allow Bus Sleep Cycle
 Install front license plate carrier (if necessary)*
Exterior
 Check all key buttons and features*
 Inspect exterior for damage, dings, dents and surface
scratches. Report and repair any damage before delivery to
the customer
Lighting and Windshield
 Test exterior lighting functions
 Verify tool kit is installed securely in luggage compartment
 Verify operation of all seat belts and latches
 Check operation of window, lock, and seat controls*
 Inspect mirrors for proper operation*
 Check rear view mirror operation*
 Verify operation of all interior lights
 Verify SOS button is green and Roadside assistance button
LED will remain off. Reference TSB 2052299 if issues occur
 Verify operation of heated seats
 Verify operation of heated rear seats (if equipped)
 Verify operation of ventilated seats (if equipped)
 Verify proper operation of climate control*
 Inspect operation of all power outlets*
 Verify the glove compartment opens and closes properly
 Check panoramic sunroof and sunshade operation*
 Test windshield washers. Correct aim if necessary*
 Verify operation of front Passenger Occupant Detection
System
Trunk Inspection
Settings
 Verify trunk is operational
 Verify operation of MMI® touch
Effective 3-24-2020-US
Version 1.4
PRE-DELIVERY INSPECTION (PDI) | 1
2020
A5/S5
Audi Pre-Delivery Inspection
Settings (continued)
Driving Performance (continued)
 Set Time source setting to “GPS” and set Auto daylight savings time to “on.”*
 Verify engine Start-Stop System functionality*
 Verify engine performance and acceleration*
 Set Time to “Automatic setting” and “Automatic time zone”
 Verify transmission operation, including shift paddles
 Verify and set language and measurement units*
 Test drive vehicle applying brakes several times*
 Verify Speech Dialog System is operating*
 Check steering/tire alignment
 Set “Entertain. Fad.” in Parking aid to an audible level*
 Set dealership location in navigation (if equipped)*
 Check for squeaks, rattles and wind noise. Repair any
squeaks, rattles or wind noises before delivery to the customer
 Turn off Manual Speed Warning (if equipped)*
 Calibrate rear view mirror*
 Set “Music volume while parking” to medium*
 Verify quality of radio reception in AM/FM/SiriusXM® bands
Media / Radio / SAT
 Verify operation of aux. input
Driver Assistance
 Insert SD card and test function of all slots
 Verify cruise control/ACC with Stop & Go functionality (if
equipped)
 Verify HD Radio is turned “off”*
 Verify Audi side assist functionality (if equipped)
Audi connect® (USA ONLY) (if equipped)
 Verify Audi active lane assist functionality (if equipped)
 Turn on the Wi-Fi® hotspot (if equipped)*
 Verify operation of parking system (if equipped)*
 Check Wi-Fi® hotspot visibility. No data available at PDI (if
equipped)*
 Verify all vehicle Head-up display functionality (if equipped)*
 Enable satellite map view for navigation (if equipped)*
 Activate NAV and follow directions back to dealership (if
equipped)
On-Hoist Inspection
Convertible Functionality (if equipped)
 Remove transport suspension blocks (follow ELSA instruction)
 Test operation of power folding top*
 Check steering, boots, brake system, hoses, tires and wheels
for damage
 Verify convertible top manual closing tools are present
 Check underside of vehicle for fluid leaks and loose components
Post-Road Test Inspection
 Install wheel locks (if equipped)
 Interrogate fault memory and upload Diagnostic Log to GFF
Paperless Server
 Install wheel bolt covers and center caps as supplied*
 Inspect wheel bolts for proper torque*
 Set and store tire pressures for either sold vehicle OR stock
inventory vehicle*
 Check service interval and verify correct interval is displayed
 Check engine oil level*
 Check all fluid levels and top off if necessary
Driving Performance
 Ensure the yellow tire pressure tag is installed on the steering wheel
 Check horn operation
 Apply 30 Day Inventory Maintenance Sticker**
 Verify hold and release of electronic parking brake
 Install showroom charger to ensure battery remains
charged at all times**
Technician
I certify that all operations have been completed and this vehicle has been prepared in accordance with Audi Procedures and
Quality Standards, and has met the standards for Perfect Delivery.
Technician Signature
Effective 3-24-2020-US
Version 1.4
Last 8 of VIN
Completion Date
PRE-DELIVERY INSPECTION (PDI) | 2


© dot.report 2024

Use of this information constitutes acceptance for use in an AS IS condition. There are NO warranties, implied or otherwise, with regard to this information or its use. Any use of this information is at the user's risk. It is the responsibility of user to evaluate the accuracy, completeness or usefulness of any information, opinion, advice or other content. EACH USER WILL BE SOLELY RESPONSIBLE FOR ANY consequences of his or her direct or indirect use of this web site. ALL WARRANTIES OF ANY KIND ARE EXPRESSLY DISCLAIMED. This site will NOT BE LIABLE FOR ANY DIRECT, INDIRECT or any other kind of loss.