20 AT-009H

GROUP
NUMBER
AUTOMATIC
TRANSMISSION
Technical Service Bulletin
20-AT-009H
DATE
MODEL
SANTA FE (TMa)
MARCH, 2020
SUBJECT:
AUTOMATIC TRANSAXLE HARSH UPSHIFT WHEN COLD
This TSB supersedes TSB 19-AT-013H to change the Op Code and Parts Information.
Description: If you are servicing a 2019 Santa Fe (2.0T) with a harsh 2-3 or 3-4 upshift when cold,
follow the Service Procedure below.
Applicable
Vehicles:
2019 MY Santa Fe (TMa) 2.0T produced from 6/26/2018~3/31/2019
Parts Information:
Model
Part
Drive
Part Number
2019 Santa Fe
(TMa)
Torque converter
2WD/4WD
45100-4G210
Automatic Transmission Fluid
2WD/4WD
00232-19057 (1 quart)
Warranty Information:
MODEL
OP CODE
OPERATION
OP TIME
CAUSAL PART
NATURE
CODE
CAUSE
CODE
2019 Santa Fe (TMa)
00DA07R0
Torque converter
2WD/4WD
3.1
45100-4G210
T74
ZZ3
NOTE 1: Submit Claim on Campaign Claim Entry Screen.
NOTE 2: If a part is in need of replacement while performing the repair for this TSB and the affected part is
still under warranty, please submit a separate claim using the same Repair Order. If the affected part is out of
warranty, submit a Prior Approval Request for goodwill consideration prior to performing the work.
Service Procedure:
1.
If the transmission has a harsh 2-3 or 3-4 upshift at small accelerator pedal inputs
(15~30% APS) when the ATF is cold, but the harsh upshift does not occur after the ATF is
warmed to normal operating temperatures (above 180°F or 80°C), go to Step 2.
2.
Record the preset radio stations.
Refer to the 2019 Santa Fe Shop Manual, Automatic Transaxle System, Automatic
Transaxle and Repair Procedures and remove the transmission.
3.
Remove the old torque converter and install a new torque converter.
Circulate To: Service Manager, Warranty Manager, Service Advisors, Technicians, Fleet Repair
AUTOMATIC TRANSMISSION HARSH UPSHIFT WHEN COLD
SUBJECT:
4.
Measure the depth of the torque converter in
the converter housing. If the measurement is
less than the specification, rotate the torque
converter in both directions and push inward
until the measurement is at specification.
Specification: 0.39~0.51 inch (10~13 mm).
NOTICE
Do not use an impact gun to force
the transmission installation.
5.
Reinstall the transmission.
6.
Reconnect the battery.
Input the radio stations recorded in Step 2.
7.
Remove the transaxle fill plug.
Use a funnel to add approximately 1 quart of
SP4-M ATF through the fill plug opening.
Reinstall the fill plug.
Attach the GDS and select Data Analysis, A/T
menu and Oil Temperature Sensor.
Start the engine and shift to Park. When the
ATF is at the low end of 122°F~140°F
(50~60°C), remove the level checking plug.
The level is correct when oil flows out of the
level checking plug in a thin steady stream.
Collect and dispose of any excess fluid in
accordance with local regulations.
8.
Drive the vehicle when the ATF temperature is cold and hot and confirm the transmission shifts
correctly.
The Service Procedure is now complete.
TSB #: 20-AT-009H
Page 2 of 2