A0120602059429_1

01 MIL on, DTC P008700, P21F500, P21F400, P218700, P21F800, and/or P217700 stored in ECM
01 20 60 2059429/1 May 5, 2020.
Model(s)
Year
VIN Range
Vehicle-Specific Equipment
RS3, TTRS
2017 - 2018
All
2.5 liter
Condition
Customer statement:
 MIL on with poor performance.
Workshop findings:
One or more of the following DTCs is stored in the engine control module (ECM), J623 (address word 0001)
about the fuel measuring system:
 DTC P008700 (fuel rail/system pressure too low).
 DTC P21F500 (fuel measuring system 2, bank 1 system too rich from idle speed).
 DTC P21F400 (fuel measuring system 2, bank 1 system too lean from idle speed).
 DTC P218700 (bank 1, fuel measuring system too lean at idle speed).
 DTC P21F800 (fuel measuring system 2, bank 1 system too lean at idle speed).
 DTC P217700 (bank 1, fuel measuring system too lean from idle speed).
Technical Background
Updated software in the engine control module will correct the condition.
Production Solution
Updated software in the engine control module (ECM), J623 (address word 0001) addressed the condition.
Service
Note:
Parts replacement does not solve this issue, claims for replaced parts will not be reimbursed.
SVM Update Instructions
Page 1 of 3
© 2020 Audi of America, Inc.
All rights reserved. Information contained in this document is based on the latest information available at the time of printing and is subject to the copyright and other intellectual property rights of Audi of
America, Inc., its affiliated companies and its licensors. All rights are reserved to make changes at any time without notice. No part of this document may be reproduced, stored in a retrieval system, or transmitted
in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, nor may these materials be modified or reposted to other sites, without the prior expressed written permission of the
publisher.
1. Follow all instructions in TSB 2011732: 00 Software Version Management (SVM), operating instructions.
2. Update the engine control module (ECM), J623 (address word 0001) using the SVM action code as listed in
the table below, if necessary:
Model
Engine
Old Software
Part Number
Old Software
Version
New Software
Part Number
New Software
Version
SVM Code
Input
(or higher)
TTRS
DAZA
8S0907404G
0001 - 0004
8S0907404G
0005
01A249
RS3
DAZA
8V0907404G
0001 - 0004
8V0907404G
0005
01A249
Warranty
Claim Type:
 110 up to 48 Months/50,000 Miles.
 1E1 up to 8 Years/80,000 Miles.
 G10 for CPO Covered Vehicles – Verify Owner.
 If vehicle is outside any warranty, this Technical Service Bulletin is informational
only.
Service Number:
2470
Damage Code:
0039
Labor Operations:
Software Update
0151 0000
Time stated on
the diagnostic
protocol (Max
50 TU)
Diagnostic Time:
GFF
No allowance
0 TU
Road test prior to service procedure
No allowance
0 TU
Road test after service procedure
No allowance
0 TU
Claim Comment:
As per TSB #2059429/1
All warranty claims submitted for payment must be in accordance with the Audi Warranty Policies and Procedures
Manual. Claims are subject to review or audit by Audi Warranty.
Page 2 of 3
© 2020 Audi of America, Inc.
All rights reserved. Information contained in this document is based on the latest information available at the time of printing and is subject to the copyright and other intellectual property rights of Audi of
America, Inc., its affiliated companies and its licensors. All rights are reserved to make changes at any time without notice. No part of this document may be reproduced, stored in a retrieval system, or transmitted
in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, nor may these materials be modified or reposted to other sites, without the prior expressed written permission of the
publisher.
Additional Information
The following Technical Service Bulletin will be necessary to complete this procedure:
 TSB 2011732, 00 Software Version Management (SVM), operating instructions.
All part and service references provided in this TSB (2059429) are subject to change and/or removal. Always
check with your Parts Department and/or ETKA for the latest information and parts bulletins. Please check the
Repair Manual for fasteners, bolts, nuts, and screws that require replacement during the repair.
©2020 Audi of America, Inc. All rights reserved. Information contained in this document is based on the latest
information available at the time of printing and is subject to the copyright and other intellectual property rights of
Audi of America, Inc., its affiliated companies and its licensors. All rights are reserved to make changes at any
time without notice. No part of this document may be reproduced, stored in a retrieval system, or transmitted in
any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, nor may these
materials be modified or reposted to other sites, without the prior expressed written permission of the publisher.
Page 3 of 3
© 2020 Audi of America, Inc.
All rights reserved. Information contained in this document is based on the latest information available at the time of printing and is subject to the copyright and other intellectual property rights of Audi of
America, Inc., its affiliated companies and its licensors. All rights are reserved to make changes at any time without notice. No part of this document may be reproduced, stored in a retrieval system, or transmitted
in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, nor may these materials be modified or reposted to other sites, without the prior expressed written permission of the
publisher.