21Q3TECHREPORT

2021
Q3
Audi Pre-Delivery Inspection
Stock No.
Dealer Number
R.O. No.
VIN
Road test mileage out
Road test mileage in
Reminders
 All items must be completed prior to customer delivery by a certified Audi technician
 Audi recommends using an Audi approved battery charger to prevent excessive battery discharge during inspection
 Guided Fault Finding must be used, session must be completed and sent to GFF Paperless
 Total PDI Test must be completed prior to any other work involving the scan tool (special function tab -> Total PDI Test)
 Start Guided Fault Finding with the engine running to ensure control modules in transport mode are identified
 For items marked with *, please refer to the PDI Technician Reference Document posted on ServiceNet for additional information
 For items marked with **, follow instructions for stock inventory vehicle
Vehicle Preparation
Interior
 Check Elsa for open campaigns and updates
 Verify operation of all seat belts and latches
 Verify Audi phone box customer registration form is present
in vehicle and add the serial number from Elsa (if equipped).
See TSB 2051720
 Check operation of window, lock, and seat controls*
 Perform any open campaigns*
 Perform diagnostic work*
 Install front license plate carrier (if necessary)*
 Inspect mirrors for proper operation*
 Check rear view mirror operation*
 Verify operation of all interior lights
 Verify operation heated seats
 Verify proper operation of climate control*
Exterior
 Inspect operation of all power outlets*
 Check all key buttons and features*
 Check panoramic sunroof and sunshade operation*
 Inspect exterior for damage, dings, dents and surface
scratches. Report and repair any damage before delivery to
the customer
 Verify the glove compartment opens and closes properly
Lighting and Windshield
 Test exterior lighting functions
 Test windshield washers (and headlight washers if
equipped). Correct aim if necessary*
Trunk Inspection
 Verify power tailgate is operational and set default opening
height*
 Install wheel bolt cover removal tool from PDI kit into trunk
tool kit*
 Verify operation of front Passenger Occupant Detection
System
Settings
 Set Time source setting to “GPS” and set Auto daylight savings time to “on.” (if equipped with navigation)*
 Set “Entertain. Fad.” in parking aid to an audible level (if
equipped)*
 Set Time to “Automatic setting” and “automatic time zone”
 Verify and set language and measurement units*
 Verify Speech Dialog System is operating*
 Set dealership location in navigation (if equipped)*
 Verify tool kit is installed securely in luggage compartment
 Set spare tire pressure*
Media / Radio / SAT
 Check battery clamps for proper torque*
 Verify operation of aux input
 Insert SD card and test function of slot
Effective 6-30-2020-US
Version 1.0
PRE-DELIVERY INSPECTION (PDI) | 1
2021
Q3
Audi Pre-Delivery Inspection
Media / Radio / SAT (continued)
Driving Performance (continued)
 Verify HD Radio is turned “off”*
 Check steering/tire alignment
 Verify operation of USB data and charge (2 in front), USB
charge (2 in rear)
 Check for squeaks, rattles and wind noise. Repair any
squeaks, rattles or wind noises before delivery to the
customer
Audi connect® (USA ONLY) (if equipped)
 Calibrate rear view mirror*
 Turn on the Wi-Fi® hotspot (if equipped)*
 Verify quality of radio reception in AM/FM/SiriusXM® bands
(if equipped)
 Check Wi-Fi® hotspot visibility. No data available at PDI (if
equipped)*
Driver Assistance
 Enable satellite map view for navigation (if equipped)*
 Verify all cruise control functions
On-Hoist Inspection
 Verify adaptive cruise control with Stop & Go functionality
(if equipped)
 Remove transport suspension blocks (follow ELSA instruction)
 Audi active lane assist (if equipped)
 Check steering, boots, brake system, hoses, tires and wheels
for damage
 Check underside of vehicle for fluid leaks and loose components
 Install wheel locks (if equipped)
 Install wheel bolt covers and center caps as supplied*
 Inspect wheel bolts for proper torque*
 Set and store tire pressures for either sold vehicle OR stock
inventory vehicle*
 Verify Audi side assist functionality (if equipped)
 Verify operation of Topview camera (if equipped)
 Verify operation of rearview camera
 Verify operation of Park steering assist (if equipped)
 Verify operation of Audi parking system plus with rear cross
traffic assist (if equipped)*
 Activate navigation and follow directions back to dealership
(if equipped)
Post-Road Test Inspection
Driving Performance
 Check horn operation
 Interrogate fault memory and upload Diagnostic Log to GFF
Paperless Server
 Verify hold and release of electronic parking brake
 Check service interval and verify correct interval is displayed
 Verify engine Start-Stop System functionality*
 Check engine oil level*
 Verify engine performance and acceleration*
 Check all fluid levels and top off if necessary
 Verify transmission operation, including shift paddles (if
equipped)
 Ensure the yellow tire pressure tag is installed on the steering wheel
 Test drive vehicle applying brakes several times*
 Apply 30 Day Inventory Maintenance Sticker**
 Install showroom charger to ensure battery remains
charged at all times**
Technician
I certify that all operations have been completed and this vehicle has been prepared in accordance with Audi Procedures and
Quality Standards, and has met the standards for Perfect Delivery.
Technician Signature
Effective 6-30-2020-US
Version 1.0
Last 8 of VIN
Completion Date
PRE-DELIVERY INSPECTION (PDI) | 2