A20-033
Service Bulletin Details
Public Details for: A20-033
Service bulletin - the mil is on with dtc P26A3 (electric water valve malfunction).
- 2014 -
Models from 2014
2014 HONDA ACCORD PLUG-IN HYBRID |
Service Bulletin 20-033 August 31, 2020 Version 1 MIL On with DTC P26A3 AFFECTED VEHICLES Year Model Trim Level VIN Range 2014 Accord Plug-In Hybrid ALL ALL SYMPTOM The MIL is on with DTC P26A3 (electric water valve malfunction). PROBABLE CAUSE A malfunction in the climate control unit software causes improper control of the three-way valve. CORRECTIVE ACTION Update the PGM-FI software, and replace the climate control unit. PARTS INFORMATION Part Name Part Number Quantity Auto Air Conditioner Control Assembly 79600-T3V-A42ZA 1 WARRANTY CLAIM INFORMATION The normal warranty applies. Operation Number Description Flat Rate Time Defect Code Symptom Code Template ID Failed Part Number 1255G0 Update the PGM-FI software, and replace the climate control unit. 1.0 hr 03214 03217 A20033A 37805-5K0-A15 Skill Level: Repair Technician CUSTOMER INFORMATION: The information in this bulletin is intended for use only by skilled technicians who have the proper tools, equipment, and training to correctly and safely maintain your vehicle. These procedures should not be attempted by “do-it-yourselfers,” and you should not assume this bulletin applies to your vehicle, or that your vehicle has the condition described. To determine whether this information applies, contact an authorized Honda automobile dealer. © 2020 American Honda Motor Co., Inc. — All Rights Reserved Page 1 of 2 SOFTWARE INFORMATION NOTE Unnecessary or incorrect repairs resulting from a failure to update the diagnostic and reprogramming software are not covered under warranty. Before beginning the repair, make sure all diagnostic and reprogramming software are updated as listed. i-HDS Software Version 1.006.004 or later HDS Software Version 3.104.002 or later J2534 Rewrite Software Information PC Application Version 1.2.1.1 Database Update 19-AUG-2020 or later NoticeDB Version 19-AUG-2020 or later Update only the systems and software listed in this service bulletin. American Honda has validated and approved the Denso DST-I as the vehicle communication interface (VCI) to support this service bulletin. For more information about updating vehicle systems, refer to service bulletin 01-023, Updating Control Units/Modules. Year/Model Vehicle System 2014 Accord Plug-In Hybrid PGM-FI Program ID (or later) 37805-5K0-A15 REPAIR INFORMATION NOTICE • Make sure the 12-volt battery is fully charged before starting an update. • Connect a fully charged jumper battery to the vehicle, and leave it connected during the entire procedure to maintain steady voltage. • Do not use the GR8 because the vehicle requires a steady electrical current. • Control module failure caused by the improper completion of a software update (early key cycle, low battery voltage, disconnected DLC cable, etc.) is not covered by warranty. • If an error occurs during the update or the i-HDS freezes, do not disconnect the battery or turn the ignition to OFF. Reboot the i-HDS, and start over. • To prevent control unit damage, do not operate anything electrical (headlights, audio system, brakes, A/C, power windows, door locks, etc.) during the update. • Warranty reimbursement for technician labor is not allowed for routine checking/installation of any available software update. NOTE This update will not require entering a service bulletin number. 1. Clear DTC P26A3 using the i-HDS. 2. Update the PGM-FI software using the J2534 Rewrite software with the DST-i. Refer to service bulletin 01-023, Updating Control Units/Modules. 3. Replace the climate control unit. Refer to the service information. END Page 2 of 2