20-FL-011H
Service Bulletin Details
Public Details for: 20-FL-011H
This bulletin provides information related to an electronic control module (ecm) software update which revises dtc P00D2: oxygen sensor heater control circuit range/performance bank 1 diagnostic logic.
Models from 2020
2020 HYUNDAI SANTA FE |
Models from 2019
2019 HYUNDAI SANTA FE |
GROUP NUMBER FUEL SYSTEM Technical Service Bulletin DATE 20-FL-011H MODEL(S) DECEMBER, 2020 SANTA FE (TMA) ECM SOFTWARE UPDATE – DTC P00D2 SUBJECT: Description: This bulletin provides information related to an Electronic Control Module (ECM) software update which revises DTC P00D2: Oxygen Sensor Heater Control Circuit Range/Performance Bank 1 diagnostic logic. Applicable Vehicle: Certain 2019 - 2020MY Santa Fe (TMA) equipped with 2.4L GDI engine. Warranty Information: Model Op. Code Operation Op. Time Causal Part Nature Code Cause Code Santa Fe (TMA) 00DA23R0 ECM UPGRADE 0.3 M/H 39171-2GTC0 I3T ZZ3 NOTE 1: Submit Claim on Campaign Claim Entry Screen. NOTE 2: If a part is found in need of replacement while performing this TSB and the affected part is still under warranty, submit a separate warranty claim using the same Repair Order. If the affected part is out of warranty, submit a Prior Approval Request for goodwill consideration prior to performing the work. GDS Information: System Selection: ENGINE CONTROL MODULE (ECM) Event # Description 623* TMA 2.4GDI – P00D2 DTC LOGIC IMPROVEMENT (*or use a later available event as listed in the GDS ECU Update screen if one is available.) Service Procedure: 1. Perform GDS Mobile software update per TSB 15-GI-001. 2. After successful completion of ECM software update, check for Diagnostic Trouble Codes in ALL menus and erase any DTC. 3. Confirm normal vehicle operation. NOTICE You must initially perform GDS ECM Update in Auto Mode. If the ECM Update starts but then fails in Auto Mode, perform the update in Manual Mode to recover. Circulate To: Service Manager, Warranty Manager, Service Advisors, Technicians, Fleet Repair ECM SOFTWARE UPDATE – DTC P00D2 SUBJECT: ! WARNING GDS-M Vehicle Battery Low Voltage Warning: When the vehicle battery is lower than 12 volts, the GDS-M will trigger a Low Battery Voltage Warning. If this Warning occurs, A. Connect the battery to a fully charged battery jump pack or GR8 charger using “Power Supply Mode” to continue the software update. OR B. Select “BACK” to exit the SW update. Then, start the engine and idle with the headlights on for 20 minutes. Return to the SW update after charging the battery. ECM ROM ID Information Table: MODEL MY (EMISSION) IMMO. PCM P/No. ROM ID OLD NEW TMAJNC48SE2A TMAJNC48SE2B TMAJNC48SEAC 19MY (ULEV) 39171-2GTC0 +IMMO 39171-2GTD0 TMAJNC48SEAD TMAJNC48SEAE TMAJNC48SEAF TMAJNC48SG1E TMAJNC48SG1A TMAJNC48SG1B TMAJNC48SG1C TMAJNC48SG1D TMA 2.4L GDI TMAJNC48NE2A TMAJNC48NE2B TMAJNC48NEAC 19MY (ULEV) -IMMO 39173-2GTE0 TMAJNC48NEAD TMAJNC48NEAE 39173-2GTF0 TMAJNC48NEAF TMAJNC48NG1E TMAJNC48NG1A TMAJNC48NG1B TMAJNC48NG1C TMAJNC48NG1D TSB #: 20-FL-011H Page 2 of 4 SUBJECT: ECM SOFTWARE UPDATE – DTC P00D2 SUBJECT: MODEL MY (EMISSION) IMMO. PCM P/No. ROM ID OLD NEW TMAJNS48SE2A TMAJNS48SE2B TMAJNS48SEAC TMAJNS48SEAD 19MY (SULEV) +IMMO 39171-2GTC5 TMAJNS48SEAE TMAJNS48SEAF TMAJNS48SG1E TMAJNS48SG1A TMAJNS48SG1B TMAJNS48SG1C TMAJNS48SG1D TMAJNS48NE2A TMAJNS48NE2B TMAJNS48NEAC TMAJNS48NEAD 19MY (SULEV) -IMMO 39173-2GTG0 TMAJNS48NEAE TMAJNS48NEAF TMAJNS48NG1E TMAJNS48NG1A TMAJNS48NG1B TMAJNS48NG1C TMA 2.4L GDI TMAJNS48NG1D 20MY (ULEV) 39171-2GTC1 +IMMO 39171-2GTD1 TMAKNC48SG1A TMAKNC48SG1B TMAKNC48SG1C TMAKNC48SG3A TMAKNC48SG3C TMAKNC48SG3B 20MY (ULEV) 39173-2GTE1 -IMMO 39173-2GTF1 TMAKNC48NG1A TMAKNC48NG1B TMAKNC48NG1C TMAKNC48NG3C TMAKNC48NG3A TMAKNC48NG3B TMAKNS48SG1A TMAKNS48SG1B 20MY (SULEV) +IMMO 39171-2GTC6 TMAKNS48SG1C TMAKNS48SG3C TMAKNS48SG3A TMAKNS48SG3B TSB #: 20-FL-011H Page 3 of 4 SUBJECT: ECM SOFTWARE UPDATE – DTC P00D2 SUBJECT: MODEL TMA 2.4L GDI MY (EMISSION) IMMO. ROM ID OLD NEW TMAKNS48NG1A TMAKNS48NG1B 20MY (SULEV) PCM P/No. -IMMO 39173-2GTG1 TMAKNS48NG1C TMAKNS48NG3C TMAKNS48NG3A TMAKNS48NG3B NOTE: +IMMO = Start Stop Button, -IMMO = Key Start Manual Mode Password Information Tables: EVENT # #623 MENU PASSWORD TMA 2.4GDI -IMMO 39173-2GTE0/F0 4811 TMA 2.4GDI -IMMO 39173-2GTG0 4812 TMA 2.4GDI -IMMO 39173-2GTE1/F1 4833 TMA 2.4GDI -IMMO 39173-2GTG1 4834 TMA 2.4GDI +IMMO 39171-2GTC0/D0 4815 TMA 2.4GDI +IMMO 39171-2GTC5 4816 TMA 2.4GDI +IMMO 39171-2GTC1/D1 4837 TMA 2.4GDI +IMMO 39171-2GTC6 4838 NOTE: +IMMO = Start Stop Button, -IMMO = Key Start TSB #: 20-FL-011H Page 4 of 4 SUBJECT: