T-SB-0229-17 Rev

Service Bulletin Details

Public Details for: T-SB-0229-17 Rev

Tsb: some 2017 model year highlander and sienna vehicles may exhibit a mil on condition with diagnostic trouble code (dtc) P211904 ? (throttle actuator ?A? Control throttle body range/performance system internal failure). The engine control


- 2017 -

T-SB-0229-17
Rev1
June 22, 2017
MIL ON With DTC P211904
Service
Category
Engine/Hybrid System
Section
Engine Control
Market USA
Applicability
YEAR(S)
MODEL(S)
ADDITIONAL INFORMATION
2017
Highlander, Sienna
REVISION NOTICE
December 11, 2020 Rev1:
 The entire bulletin has been updated.
Any previous printed versions of this bulletin should be discarded.
Introduction
Some 2017 model year Highlander and Sienna vehicles may exhibit a MIL ON condition with
Diagnostic Trouble Code (DTC) P211904 – (Throttle Actuator “A” Control Throttle Body
Range/Performance System Internal Failure). The Engine Control Module (ECM) (SAE term:
Powertrain Control Module/PCM) logic has been modified to reduce the possibility of this
condition. Follow the Repair Procedure in this bulletin to address this condition.
Production Change Information
This bulletin applies to vehicles produced BEFORE the Production Change Effective VINs
shown below.
MODEL
PLANT
DRIVETRAIN
AWD
TMMI
West
Highlander
2WD
AWD
TMMI
East
Sienna
2WD
AWD
2WD
STOP & START
PRODUCTION CHANGE EFFECTIVE VIN
Y
5TDJZRFH#HS433631
N
5TDBZRFH#HS433631
Y
5TDKZRFH#HS216576
N
5TDZZRFH#HS216576
Y
N
© 2020 Toyota Motor Sales, USA
5TDJZRFH#HS516309
5TDKZRFH#HS517245
5TDZZ3DC#HS863189
5TDDZ3DC#HS176531
Page 1 of 4
T-SB-0229-17
Rev1
June 22, 2017
Page 2 of 4
MIL ON With DTC P211904
Warranty Information
OP CODE
MODEL
DESCRIPTION
DRIVETRAIN
TIME
Highlander
0.7
Reprogram
ECM (PCM)
T1
T2
8A
99
89661-0E830
89661-0E831
AWD
800269
OFP
2WD
89661-0E840
89661-0E841
89661-0E850
89661-0E851
89661-0E860
89661-0E861
AWD
Sienna
0.7
2WD
89661-08443
89661-08444
89661-08163
89661-08164
APPLICABLE WARRANTY
 This repair is covered under the Toyota Federal Emission Warranty. This warranty is in effect for
96 months or 80,000 miles, whichever occurs first, from the vehicle’s in-service date.
 Warranty application is limited to occurrence of the specified condition described in
this bulletin.
Parts Information
MODEL
DRIVETRAIN STOP & START
NEW
Y
89661-0E830
89661-0E831
89661-0E835
N
89661-0E840
89661-0E841
89661-0E845
Y
89661-0E850
89661-0E851
89661-0E855
89661-0E860
89661-0E861
89661-0E865
89661-08443
89661-08444
89661-08447
89661-08163
89661-08164
89661-08167
AWD
Highlander
2WD
AWD
N
Sienna
2WD
–
–
PART NUMBER
PREVIOUS
–
00451-00001-LBL
© 2020 Toyota Motor Sales, USA
PART NAME
QTY
Computer, Engine
Control (ECM/PCM)
–
Authorized
Modification Labels
1
T-SB-0229-17
Rev1
June 22, 2017
Page 3 of 4
MIL ON With DTC P211904
Required Tools & Equipment
REQUIRED EQUIPMENT
SUPPLIER
Techstream ADVi*
Techstream 2.0
Techstream Lite
Techstream Lite (Green Cable)
PART NUMBER
QTY
TSADVUNIT
ADE
TS2UNIT
1
TSLITEPDLR01
TSLP2DLR01
*Essential SST.
NOTE
 Only ONE of the Techstream units listed above is required.
 Software version 15.30.027 or later is required.
 Additional Techstream units may be ordered by calling Approved Dealer Equipment (ADE)
at 1-800-368-6787.
 Use Techstream or an approved J2534 interface to perform flash reprogramming updates.
Visit techinfo.toyota.com for more information regarding J2534 reprogramming.
SPECIAL SERVICE TOOLS (SST)
PART NUMBER
QTY
Battery Diagnostic Tool*
DCA-8000P T
1
*Essential SST.
NOTE
Additional SSTs may be ordered by calling 1-800-933-8335.
NOTE
 The battery diagnostic tool MUST be used in Power Supply Mode to maintain battery voltage at
13.5V while flash reprogramming the vehicle.
 For details on how to use the battery diagnostic tool, refer to the DCA-8000 Instruction Manual located
at TIS – Diagnostics – Tools & Equipment – Battery Diagnostics.
© 2020 Toyota Motor Sales, USA
T-SB-0229-17
Rev1
June 22, 2017
Page 4 of 4
MIL ON With DTC P211904
Calibration Information
CALIBRATION ID
MODEL
DRIVETRAIN STOP & START
ECU TYPE
PREVIOUS
Engine
896630E43000
896630E43100
Transmission
896650E09000
Engine
896630E44000
896630E44100
Transmission
896650E10000
Engine
896630E45000
896630E45100
Transmission
896650E11000
Engine
896630E46000
896630E46100
Transmission
896650E12000
Engine
896630836000
896630836300
896630836400
Transmission
896650808000
896650808100
Engine
896630828000
896630828300
896630828400
Transmission
896650807000
896650807100
Y
NEW*
896630E43200*/
896650E09100*
AWD
N
896630E44200*/
896650E10100*
Highlander
Y
896630E45200*/
896650E11100*
2WD
N
AWD
Sienna
N
2WD
896630E46200*/
896650E12100*
896630836500*/
896650808200*
896630828500*/
896650807200*
*Refer to Service Bulletin No. T-SB-0001-18 Transaxle Assembly and ECM (PCM) Software Confirmation for
calibration information.
Repair Procedure
Confirm the condition exists.
Does the vehicle exhibit a MIL ON condition with DTC P211904 present?

YES — Continue to step 2.

NO — This bulletin does NOT apply. Continue diagnosis using the applicable
Repair Manual.
Follow the procedures outlined in Service Bulletin No. T-SB-0001-18, Transaxle Assembly and
ECM (PCM) Software Confirmation, confirm transmission and ECU (PCM) hardware match,
and complete repairs as needed.
© 2020 Toyota Motor Sales, USA


© dot.report 2024

Use of this information constitutes acceptance for use in an AS IS condition. There are NO warranties, implied or otherwise, with regard to this information or its use. Any use of this information is at the user's risk. It is the responsibility of user to evaluate the accuracy, completeness or usefulness of any information, opinion, advice or other content. EACH USER WILL BE SOLELY RESPONSIBLE FOR ANY consequences of his or her direct or indirect use of this web site. ALL WARRANTIES OF ANY KIND ARE EXPRESSLY DISCLAIMED. This site will NOT BE LIABLE FOR ANY DIRECT, INDIRECT or any other kind of loss.