ITB14012

Classification:
Reference:
Date:
WT14-003
ITB14-012
March 14, 2014
2014 Q50; TPMS CONFIGURATION
APPLIED VEHICLES:
2014 Q50 (V37)
2014 Q50 Hybrid (V37)
SERVICE INFORMATION
When a BCM is replaced for any reason, TPMS (Tire Pressure Monitor System) configuration must be
performed.
TPMS configuration is in addition to any other BCM configurations that may be performed.
If TPMS configuration is not performed, TPMS transmitter ID registration will not complete.
Follow the Service Procedure in this bulletin to perform TPMS configuration.
Infiniti Bulletins are intended for use by qualified technicians, not 'do-it-yourselfers'. Qualified technicians are properly trained
individuals who have the equipment, tools, safety instruction, and know-how to do a job properly and safely. NOTE: If you believe that
a described condition may apply to a particular vehicle, DO NOT assume that it does. See your Infiniti dealer to determine if this
applies to your vehicle.
1/9
SERVICE PROCEDURE
1. Connect the CONSULT-III plus (C-III plus) Vehicle Interface (plus VI) to the vehicle.
2. Turn the ignition ON.
3. Open / start C-III plus.
4. Wait for the plus VI to be recognized.

The serial number will display when the plus VI is recognized.
5. Select Diagnosis (One System).
Step
5
plus VI is
recognized
Figure 1
2/9
ITB14-012
6. Select BCM.
Step
6
Figure 2
7. Select BCM again.
Step
7
Figure 3
3/9
ITB14-012
8. Select ECU Identification.
Step
8
Figure 4
9. Write down the BCM part number:
NOTE: This number will be used later for TPMS configuration.
10. Select Home.
Step
10
Step 9
Write down this number.
This is the BCM Part Number.
Figure 5
4/9
ITB14-012
11. Select Re/programming, Configuration.
Step
11
Figure 6
12. Use arrows (if needed) to view and read all precautions.
13. Check the box confirming the precautions have been read.
14. Select Next.
Step
12
Step
13
Step
14
Figure 7
5/9
ITB14-012
15. Select Infiniti, Vehicle Name, correct Model Year, and then Select.

If the screen in Figure 8 does not display, skip to step 16.
Step
15
Example
Figure 8
16. Make sure VIN or Chassis # matches the vehicle’s VIN.
17. Select Confirm.
Step
16
Step
17
Figure 9
6/9
ITB14-012
18. Select Confirm.
Step
18
Figure 10
19. Select Air Pressure Monitor.
Step
19
Figure 11
7/9
ITB14-012
20. Select Manual Configuration.
Step
20
Figure 12
21. Select the DATA PART NO. that matches the BCM part number you wrote down in step 9.
 Use the scroll arrows to scroll and find the correct DATA PART NO. / BCM part number.
22. Select Next.
Step
21
Example
Step
22
Scroll
arrows
Figure 13
8/9
ITB14-012
23. Confrim the correct DATA PART NO is listed.
 This should be the BCM part number you wrote down in step 9.
24. Select OK.
Step
23
Step
24
Figure 14
25. TPMS configuration is complete.
26. Select Home, close C-III plus and disconnect from the vehicle.
9/9
ITB14-012