NTB14078A

Service Bulletin Details

Public Details for: NTB14078A

If you confirm the customer reports or the technician confirms all of the following: - the message "parking sensor error" is displayed in the vehicle's meter after cranking or starting the engine. - only occurs after a vehicle has b


- 2014 - 2013 -

Classification:
Reference:
EL14-008a
Date:
NTB14-078a
March 13, 2015
2013-2014 PATHFINDER; PARKING SENSOR ERROR
DISPLAYED ON METER AT TEMPERATURE BELOW 5°F
This bulletin has been amended. The Action and Parts Information sections have been revised.
Please discard all previous versions.
APPLIED VEHICLE:
2013-2014 Pathfinder (R52)
IF YOU CONFIRM
The customer reports or the technician confirms all of
the following:

The message "Parking Sensor Error" is displayed
in the vehicle’s meter after cranking or starting the
engine.

Only occurs after a vehicle has been cold soaked
for several hours at an outside temperatures of
-15°C (5°F) or below.

Does not display after the vehicle warms up and
the ignition has been cycled.
Error message
Figure 1
NOTE:

If the Parking Sensor Error message remains ON after the vehicle has warmed up
and the ignition has been cycled, refer to the Electronic Service Manual (ESM) for
further diagnosis.

If the above conditions should occur, a combination of the following DTCs may be
current:





B2727
B2729
B272A
B272B
B272C
FRONT CENTER SENSOR CONFIG ERROR
CORNER SENSOR FL CONFIG ERROR
CENTER SENSOR FL CONFIG ERROR
CENTER FR CONFIG ERROR
CORNER SENSR FR CONFIG ERROR
Nissan Bulletins are intended for use by qualified technicians, not 'do-it-yourselfers'. Qualified technicians are
properly trained individuals who have the equipment, tools, safety instruction, and know-how to do a job
properly and safely. NOTE: If you believe that a described condition may apply to a particular vehicle, DO
NOT assume that it does. See your Nissan dealer to determine if this applies to your vehicle.
1/2
ACTION
Replace the Sonar Control Unit.

Refer to the ESM, section SN-Sonar System, for replacement information.
NOTE: The replacement Sonar Control Unit will need to be configured. Refer to
INSPECTION AND ADJUSTMENT > ADDITIONAL SERVICE WHEN REPLACING
SONAR CONTROL UNIT before removing the unit.
PARTS INFORMATION
DESCRIPTION
Sonar Control Unit
PART #
28532-3JA3C
QUANTITY
1
CLAIMS INFORMATION
OPERATION
Replace Sonar Control Unit
OP CODE
RD39AA
PFP
(1)
SYM DIAG
ZE
32
FRT
(2)
(1) Refer to the electronic parts catalog FAST and use the Sonar Control Unit part number (28532XXXXX) as the primary failed part.
(2) Reference the current Nissan Warranty Flat Rate Manual and use the indicated flat rate time.
2/2
NTB14-078a


© dot.report 2024

Use of this information constitutes acceptance for use in an AS IS condition. There are NO warranties, implied or otherwise, with regard to this information or its use. Any use of this information is at the user's risk. It is the responsibility of user to evaluate the accuracy, completeness or usefulness of any information, opinion, advice or other content. EACH USER WILL BE SOLELY RESPONSIBLE FOR ANY consequences of his or her direct or indirect use of this web site. ALL WARRANTIES OF ANY KIND ARE EXPRESSLY DISCLAIMED. This site will NOT BE LIABLE FOR ANY DIRECT, INDIRECT or any other kind of loss.