JLRTB02087NAS1

7/16/2021
TECHNICAL BULLETIN
JLRTB02087NAS1
TECHNICAL BULLETIN
05 JUL 2021
© Jaguar Land Rover North America, LLC
NOTE: The information in Technical Bulletins is intended for use by trained, professional
Technicians with the knowledge, tools, and equipment required to do the job properly and
safely. It informs these Technicians of conditions that may occur on some vehicles, or
provides information that could assist in proper vehicle service. The procedures should not
be performed by 'do-it-yourselfers'. If you are not a Retailer, do not assume that a condition
described affects your vehicle. Contact an authorized Land Rover service facility to
determine whether this bulletin applies to a specific vehicle.
INFORMATION
SECTION:
412-01
SUBJECT/CONCERN:
Air Conditioning (A/C) Not Blowing As Cold As Expected
AFFECTED VEHICLE RANGE:
MODEL:
MODEL YEAR:
VIN:
ASSEMBLY PLANT:
I-PACE (X590)
2020
F80716-F90426
Graz (Austria)
I-PACE (X590)
2020-2021
600001-608281
Graz (Austria)
MARKETS:
NORTH AMERICA
https://www.odyssey.jlrint.com/odyssey/WorkflowHtmlComposition.do?wid=1616167407515
1/7
7/16/2021
TECHNICAL BULLETIN
CONDITION SUMMARY:
SITUATION:
There is no cold air blowing through the air vents when the Air Conditioning (A/C) has been
selected. Further investigation has found there is no/low refrigerant in the A/C system.
CAUSE:
The bolts retaining the Low Pressure (LP) and High Pressure (HP) pipes to the A/C
compressor are too long.
ACTION:
Follow the instructions below.
PARTS:
PART NUMBER
DESCRIPTION
QUANTITY
J9D1170
O-ring
1
J9D1172
O-ring
1
JDE6912
Bolt
2
WARRANTY:
NOTE:
* When submitting your Warranty claim within the Warranty portal, use the
Condition Code list shown to select the Condition Code which best describes the
vehicle defect.
NOTES:
Repair procedures are under constant review, and therefore times are subject to
change; those quoted here must be taken as guidance only. Use TOPIx to obtain
the latest repair time.
The JLR claims submission system requires the use of causal part numbers. Labor
only claims must show the causal part number with a quantity of zero.
https://www.odyssey.jlrint.com/odyssey/WorkflowHtmlComposition.do?wid=1616167407515
2/7
7/16/2021
TECHNICAL BULLETIN
DESCRIPTION
JLRTB - A/C pipe retaining bolts Renew
SRO
TIME
(HOURS)
CONDITION
CODE
CAUSAL
PART
99.01.62
2.5
*
C2Z1459
NOTE:
Normal Warranty procedures apply.
SERVICE INSTRUCTION:
NOTES:
This procedure contains illustrations showing certain components removed to
provide extra clarity.
This procedure contains some variation in the illustrations depending on the
vehicle specification, but the essential information is always correct.
1.
Evacuate the A/C system (see TOPIx Workshop Manual section 412-00: Climate
Control System - General Information - General Procedures - Air Conditioning
System Recovery, Evacuation and Charging).
https://www.odyssey.jlrint.com/odyssey/WorkflowHtmlComposition.do?wid=1616167407515
3/7
7/16/2021
TECHNICAL BULLETIN
2.
WARNING:
Jaguar Land Rover (JLR) Electric Vehicle Authorised Person (EVAP) trained
technicians only.

Power Down the High Voltage (HV) system. Only technicians qualified to EVAP
level or higher are allowed to perform this procedure (see TOPIx Workshop Manual
section 414-01: Battery, Mounting and Cables - High Voltage System - General
Procedures - High Voltage System Power Down/Up - Front Traction and Auxiliary
Circuits).
3.

Remove the Noise, Vibration and Harshness (NVH) cover.
https://www.odyssey.jlrint.com/odyssey/WorkflowHtmlComposition.do?wid=1616167407515
4/7
7/16/2021
TECHNICAL BULLETIN
4.

Release the 2 pipes from the A/C compressor.
Remove and discard the 2 bolts.
5.

Renew the 2 A/C pipe seals.
https://www.odyssey.jlrint.com/odyssey/WorkflowHtmlComposition.do?wid=1616167407515
5/7
7/16/2021
TECHNICAL BULLETIN
6.

Install the 2 pipes into the A/C compressor.
Install the 2 new bolts.
Torque: 24 Nm
7.

Install the NVH cover.
https://www.odyssey.jlrint.com/odyssey/WorkflowHtmlComposition.do?wid=1616167407515
6/7
7/16/2021
TECHNICAL BULLETIN
8.
WARNING:
JLR EVAP trained technicians only.

Power Up the HV system. Only technicians qualified to EVAP level or higher are
allowed to perform this procedure (see TOPIx Workshop Manual section 414-01:
Battery, Mounting and Cables - High Voltage System - General Procedures - High
Voltage System Power Down/Up - Front Traction and Auxiliary Circuits).
9.
Charge the A/C system (see TOPIx Workshop Manual section 412-00: Climate
Control System - General Information - General Procedures - Air Conditioning
System Recovery, Evacuation and Charging).
https://www.odyssey.jlrint.com/odyssey/WorkflowHtmlComposition.do?wid=1616167407515
7/7