A6621752064015_2

66 Front license plate installation
66 21 75 2064015/2 September 15, 2021. Supersedes Technical Service Bulletin Group 66 number 21-74 dated
July 16, 2021 for reasons listed below.
Model(s)
Year
VIN Range
Vehicle-Specific Equipment
Audi e-tron
GT, Audi
RS e-tron
GT
2022 - 2023
All
Not Applicable
Condition
REVISION HISTORY
Revision
Date
Purpose
2
-
Revised Technical Background (Remove statement of pending ElsaPro
revisions as they are now complete)
Revised Service (Remove statement of any differentiation of repair instruction
between ElsaPro and TSB)
Revised Service (Change to screw torque specification)
1
07/16/2021
Initial publication
Customer states:
 No customer concerns, it is found during PDI or any other diagnostic work.
Workshop findings:
 The front bumper cover and fascia do not provide obvious mounting points for the front license plate.
Technical Background
The design aesthetic of the new Audi e-tron GT/Audi RS e-tron GT makes the addition of a front license plate
carrier prohibitive. The front license plate is attached directly to the front bumper cover/grille assembly without the
use of a license plate carrier.
Production Solution
Not applicable.
Page 1 of 6
© 2021 Audi of America, Inc.
All rights reserved. Information contained in this document is based on the latest information available at the time of printing and is subject to the copyright and other intellectual property rights of Audi of
America, Inc., its affiliated companies and its licensors. All rights are reserved to make changes at any time without notice. No part of this document may be reproduced, stored in a retrieval system, or transmitted
in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, nor may these materials be modified or reposted to other sites, without the prior expressed written permission of the
publisher.
Service
The front license plate can be attached using 2 self-tapping screws (N 909 747 01) at the top of the plate.
1. The dimensions for the correct placement of the
front license plate are specified in Elsa at
Repair Manual: Body >> Body Exterior >> 66
Exterior Equipment >> Radiator Grille/Front
Trim >> License Plate, Mounting:
 Dimension -a- in mm: 21.0.
 Dimension -b- in mm: 89.0.
 Dimension -c- in mm: 120.5.
Figure 1. Reference points for placement of the front
license plate.
2. To make the front license plate installation
position replicable without the need for new
measurements in each installation case fashion
a template using a manila folder or card stock
with these dimensions transferred to it. Set the
top edge with the top fold and mark the
centerline consistent with the Audi Rings motif
as specified in Elsa.
Figure 2. Front license plate mounting hole template.
Page 2 of 6
© 2021 Audi of America, Inc.
All rights reserved. Information contained in this document is based on the latest information available at the time of printing and is subject to the copyright and other intellectual property rights of Audi of
America, Inc., its affiliated companies and its licensors. All rights are reserved to make changes at any time without notice. No part of this document may be reproduced, stored in a retrieval system, or transmitted
in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, nor may these materials be modified or reposted to other sites, without the prior expressed written permission of the
publisher.
3. Use a hole punch where the screws will be
attached and a mark can be easily made each
time. The upper screw attachment will be
expedient and consistent.
Figure 3. Hole punch through the template.
4. Mark the hole locations through the template.
Figure 4. Screw location marking.
Page 3 of 6
© 2021 Audi of America, Inc.
All rights reserved. Information contained in this document is based on the latest information available at the time of printing and is subject to the copyright and other intellectual property rights of Audi of
America, Inc., its affiliated companies and its licensors. All rights are reserved to make changes at any time without notice. No part of this document may be reproduced, stored in a retrieval system, or transmitted
in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, nor may these materials be modified or reposted to other sites, without the prior expressed written permission of the
publisher.
5. With the hole locations marked drill two 3mm
(1/8”) diameter holes no deeper than 15mm.
Mark the 15mm (19/32”) depth on the drill bit
with a piece of tape.
Figure 5. 15mm depth guide.
6. Drill the holes to 15mm in depth.
Figure 6. Drilling of the screw holes.
Page 4 of 6
© 2021 Audi of America, Inc.
All rights reserved. Information contained in this document is based on the latest information available at the time of printing and is subject to the copyright and other intellectual property rights of Audi of
America, Inc., its affiliated companies and its licensors. All rights are reserved to make changes at any time without notice. No part of this document may be reproduced, stored in a retrieval system, or transmitted
in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, nor may these materials be modified or reposted to other sites, without the prior expressed written permission of the
publisher.
7. Install the screws (N 909 747 01). Torque the
screws to 2.0 Nm.
Figure 7. Installation and final torque of the front license
plate screws.
Warranty
This TSB is informational only and not applicable to any Audi Warranty.
Required Parts and Tools
The part numbers mentioned in this TSB are different than the ones listed in ETKA. Only use parts listed in this
TSB, this includes superseding part numbers!
Part Number
Part Description
Quantity
N 90974701
02
Hexagon socket head panel bolt
Page 5 of 6
© 2021 Audi of America, Inc.
All rights reserved. Information contained in this document is based on the latest information available at the time of printing and is subject to the copyright and other intellectual property rights of Audi of
America, Inc., its affiliated companies and its licensors. All rights are reserved to make changes at any time without notice. No part of this document may be reproduced, stored in a retrieval system, or transmitted
in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, nor may these materials be modified or reposted to other sites, without the prior expressed written permission of the
publisher.
Additional Information
All part and service references provided in this TSB (2064015) are subject to change and/or removal. Always
check with your Parts Department and/or ETKA for the latest information and parts bulletins. Please check the
Repair Manual for fasteners, bolts, nuts, and screws that require replacement during the repair.
©2021 Audi of America, Inc. All rights reserved. The information contained in this document is based on the
latest information available at the time of printing and is subject to the copyright and other intellectual property
rights of Audi of America, Inc., its affiliated companies, and its licensors. All rights are reserved to make changes
at any time without notice. No part of this document may be reproduced, stored in a retrieval system, or
transmitted in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, nor may
these materials be modified or reposted to other sites, without the prior expressed written permission of the
publisher.
Page 6 of 6
© 2021 Audi of America, Inc.
All rights reserved. Information contained in this document is based on the latest information available at the time of printing and is subject to the copyright and other intellectual property rights of Audi of
America, Inc., its affiliated companies and its licensors. All rights are reserved to make changes at any time without notice. No part of this document may be reproduced, stored in a retrieval system, or transmitted
in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, nor may these materials be modified or reposted to other sites, without the prior expressed written permission of the
publisher.