PIP5806D
Service Bulletin Details
Public Details for: PIP5806D
This preliminary information bulletin instructs to technicians to check the trigger wheel for interfering with the timing chain, and adding a shim to the camshaft position sensor.
Models from 2021
2021 CHEVROLET SILVERADO 1500 |
2021 CHEVROLET SILVERADO 2500 |
2021 CHEVROLET SILVERADO 3500 |
2021 GMC SIERRA 1500 |
2021 GMC SIERRA 2500 |
2021 GMC SIERRA 3500 |
Models from 2020
2020 CHEVROLET SILVERADO 1500 |
2020 CHEVROLET SILVERADO 2500 |
2020 CHEVROLET SILVERADO 3500 |
2020 GMC SIERRA 1500 |
2020 GMC SIERRA 2500 |
2020 GMC SIERRA 3500 |
Bulletin No.: PIP5806D Published date: N/A Preliminary Information PIP5806D Intermittent Extended Crank No Start And A Possible DTC P0341 Set Models Brand: Model: Model Years: VIN: from to Engine: Transmissions: Chevrolet Silverado 2020 - 2021 All All LM2 All GMC Sierra 2020 - 2021 All All LM2 All Involved Region or Country: Condition: Cause: North America Some customers may experience an intermittent extended crank or intermittent crank/no start, and may nd DTC P0341 set. The vehicle will crank until it times out. The vehicle will start on the second attempt. The StopStart system is not a ected by this condition. This may be due to a corrupt signal from camshaft position sensor to ECM. Correction: Remove the camshaft position sensor and use a borescope to inspect the camshaft trigger wheel for coming in contact with the timing chain. If the trigger wheel is coming into contact with the timing chain at any point, it will be necessary to replace the trigger wheel. It is necessary to roll the engine over by hand (up to two revolutions) to inspect each wheel segment. See the picture below: If the camshaft trigger wheel is not coming into contact with the timing chain at any point, Install a .5mm shim to the camshaft position sensor, P/N 12565102. Below are reference pictures of a good trigger wheel and chain: 1. Camshaft Position Reluctor Wheel 2. Camshaft Position Sensor 1. Camshaft Position Reluctor Wheel Warranty Information For vehicles repaired under the Bumper to Bumper and Emissions (E) coverage, use the following labor operation. Reference the Applicable Warranties section of Investigate Vehicle History (IVH) for coverage information. Labor Operation Description 4088148 Labor Time Camshaft Exciter Wheel Inspection and .5mm Camshaft Sensor shim installation *This is a unique Labor Operation for Bulletin use only. 3.1 Hrs. Version History Version Modi ed 5 05/24/2021 - Created on. 06/18/2021 - Modi ed to include checking for debris on the cam position sensor. 08/06/2021 - Modi ed to include checking for chain interference and adding Camshaft position sensor shim and graphics. 08/13/2021 - Modi ed to update the labor code and description 09/21/2021 - Modi ed to remove the SUVs © 2021 General Motors. All Rights Reserved.