A21-063

Service Bulletin Details

Public Details for: A21-063

Service bulletin - a buzz or ticking sound is heard from the center display.


- 2022 -

Models from 2022
2022 HONDA CIVIC
Service Bulletin
21-063
March 1, 2022
Version 2
9" Center Display Buzz Or Ticking Sound
Supersedes 21-063, dated August 13, 2021, to revise the information highlighted in yellow.
AFFECTED VEHICLES
Year
Model
Trim Level
VIN Range
2022
Civic
ALL
ALL
REVISION SUMMARY
Under AFFECTED VEHICLES, trim level updated to ALL.
SYMPTOM
A buzz or ticking sound is heard from the center display.
POSSIBLE CAUSE
There is a gap between the center display unit and the dashboard causing vibrations.
CORRECTIVE ACTION
Apply wool felt tape to the lower corners of the center display unit.
REQUIRED MATERIALS
Part Name
Part Number
Quantity
Wool Felt Tape (One roll repairs 1,000 vehicles)
06993-SA5-000
1
WARRANTY CLAIM INFORMATION
The normal warranty applies.
Operation
Number
Description
Flat Rate
Time
Defect
Code
Symptom
Code
Template
ID
Failed Part Number
0160A0
Apply wool felt tape to
the bottom of the
center display unit.
0.6 hr.
06201
04201
A21063A
8A700-T20-A01
Skill Level: Repair Technician
CUSTOMER INFORMATION: The information in this bulletin is intended for use only by skilled technicians who have the proper tools, equipment,
and training to correctly and safely maintain your vehicle. These procedures should not be attempted by “do-it-yourselfers,” and you should not
assume this bulletin applies to your vehicle, or that your vehicle has the condition described. To determine whether this information applies, contact
an authorized Honda automobile dealer.
© 2022 American Honda Motor Co., Inc. – All Rights Reserved
Page 1 of 3
REPAIR PROCEDURE
1. Remove the center speaker lid.
2. Remove the dashboard center trim.
3. Remove the center display unit.
NOTE: Use caution to prevent damaging the center display unit.
Page 2 of 3
4. Apply 5 x 10 x 1 mm pieces of felt tape to the applicable screen as shown in the location on both sides, then install
the center display unit.
NOTE: Make sure the felt is not visible after screen installation.
5. Install the parts in the reverse order of removal.
6. Do the climate control unit Self-Diagnostic Function with the HDS.
END
Page 3 of 3


© dot.report 2024

Use of this information constitutes acceptance for use in an AS IS condition. There are NO warranties, implied or otherwise, with regard to this information or its use. Any use of this information is at the user's risk. It is the responsibility of user to evaluate the accuracy, completeness or usefulness of any information, opinion, advice or other content. EACH USER WILL BE SOLELY RESPONSIBLE FOR ANY consequences of his or her direct or indirect use of this web site. ALL WARRANTIES OF ANY KIND ARE EXPRESSLY DISCLAIMED. This site will NOT BE LIABLE FOR ANY DIRECT, INDIRECT or any other kind of loss.