T-SB-0005-22

T-SB-0005-22
February 3, 2022
Incorrect Fuel Gauge Reading
Service
Category
Vehicle Interior
Section
Meter/Gauge/Display
Market USA
Applicability
YEAR(S)
MODEL(S)
ADDITIONAL INFORMATION
2020 - 2022
Camry
VDS(s): C11BK, F11BK, G11BK, J11BK,
K61BK, L11BK, M11BK, R11BK, S11BK, T11BK
Drive Type(s): AWD
Introduction
Some 2020 – 2022 model year Camry AWD vehicles equipped with an A25A engine may exhibit
an incorrect fuel gauge reading on the instrument cluster/Multi-information Display (MID) after
refueling to full. Follow the Repair Procedure in this bulletin to address this condition.
Warranty Information
OP CODE
DESCRIPTION
TIME
OFP
T1
T2
800279
Combination Meter Assembly Reprogramming
*
83800-#####**
8B
74
*See the Flat Rate Manual.
**Warranty claim MUST be submitted with the correct 10-digit OFP. Choose the correct OFP for the vehicle being
repaired by searching for the parts in the Electronic Parts Catalog using the VIN filter.
APPLICABLE WARRANTY
 This repair is covered under the Toyota Basic Warranty. This warranty is in effect for
36 months or 36,000 miles, whichever occurs first, from the vehicle’s in-service date.
 Warranty application is limited to occurrence of the specified condition described in
this bulletin.
© 2021 Toyota Motor Sales, USA
Page 1 of 4
T-SB-0005-22
February 3, 2022
Page 2 of 4
Incorrect Fuel Gauge Reading
Parts Information
PART NUMBER
PREVIOUS
PART NAME
QTY
Meter Assy, Combination
–
NEW
83800-0XQ40
83800-0XQ50
83800-0XQ60
83800-0XQ70
83800-0XX20
83800-0XX30
83800-0XY50
83800-0XY60
83800-0XY51
83800-0XY61
83800-0XY70
83800-0XY80
83800-0XY90
83800-0XZ00
83800-0XY71
83800-0XY81
83800-0XY91
83800-0XZ01
83800-0XQ41
83800-0XQ51
83800-0XQ42
83800-0XQ52
83800-0XQ61
83800-0XQ71
83800-0XX21
83800-0XX31
83800-0XQ62
83800-0XQ72
83800-0XX22
83800-0XX32
NOTE
The combination meter assembly should NOT be replaced as part of the Repair Procedure.
© 2021 Toyota Motor Sales, USA
T-SB-0005-22
February 3, 2022
Page 3 of 4
Incorrect Fuel Gauge Reading
Required Tools & Equipment
REQUIRED EQUIPMENT
SUPPLIER
Techstream ADVI*
PART NUMBER
QTY
TSADVUNIT
Techstream 2.0
TS2UNIT
ADE
1
Techstream Lite
TSLITEPDLR01
Techstream Lite (Green Cable)
TSLP2DLR01
*Essential SST.
NOTE
 Only ONE of the Techstream units listed above is required.
 Software version 16.30.011 or later is required.
 Additional Techstream units may be ordered by calling Approved Dealer Equipment (ADE)
at 1-800-368-6787.
 Use Techstream or an approved J2534 interface to perform flash reprogramming updates.
Visit techinfo.toyota.com for more information regarding J2534 reprogramming.
SPECIAL SERVICE TOOLS (SST)
PART NUMBER
QTY
Battery Diagnostic Tool*
DCA-8000P_T
1
*Essential SST.
NOTE
Additional SSTs may be ordered by calling 1-800-933-8335.
Calibration Information
CALIBRATION ID
MODEL YEAR
2020 – 2022
MODEL
Camry
ENGINE
A25A
DRIVETRAIN
AWD
© 2021 Toyota Motor Sales, USA
PREVIOUS
NEW
838000XQ4111
838000XQ4112
838000XQ4114
838000XQ4121
838000XQ4122
838000XQ4124
838000XP6124
838000XP6128
838000XP6125
838000XP6127
838000XP6144
838000XP6148
838000XP6145
838000XP6147
T-SB-0005-22
February 3, 2022
Page 4 of 4
Incorrect Fuel Gauge Reading
Repair Procedure
1. Confirm the condition exists.
Does the vehicle exhibit an incorrect fuel gauge reading on the instrument cluster/MID
AFTER refueling to full?

YES — Continue to step 2.

NO — This bulletin does NOT apply. Continue diagnosis using the applicable
Repair Manual.
2. Use Techstream to confirm if the combination meter assembly calibration has been updated.
Is the calibration ID listed in Techstream the latest combination meter assembly calibration?

YES — This bulletin does NOT apply. Continue diagnosis using the applicable
Repair Manual.

NO — Continue to step 3.
3. Flash reprogram the combination meter assembly.
NOTE
 The battery diagnostic tool MUST be used in Power Supply Mode to maintain battery voltage
at 13.5V while flash reprogramming the vehicle.
 For details on how to use the battery diagnostic station, refer to the DCA-8000 Instruction Manual
located at TIS – Diagnostics – Tools & Equipment – Battery Diagnostics.
Follow the procedures outlined in T-SB-0134-16 Techstream ECU Flash Reprogramming
Procedure, and flash the ECM (PCM) with the NEW calibration file update.
4. Confirm the condition is no longer present.
Does the vehicle exhibit a correct fuel gauge reading on the instrument cluster/MID
AFTER refueling to full?

YES — The repair is complete.

NO — This bulletin does NOT apply. Continue diagnosis using the applicable
Repair Manual
© 2021 Toyota Motor Sales, USA