JTB00191NAS3
Service Bulletin Details
Public Details for: JTB00191NAS3
Glove compartment lid not damped when opening.
- 2013 - 2012 - 2011 - 2010 - 2009 - 2008 - 2007 -
Models from 2013
| 2013 JAGUAR XK |
Models from 2012
| 2012 JAGUAR XK |
Models from 2011
| 2011 JAGUAR XK |
Models from 2010
| 2010 JAGUAR XK |
Models from 2009
| 2009 JAGUAR XK |
Models from 2008
| 2008 JAGUAR XK |
Models from 2007
| 2007 JAGUAR XK |
Page 1 of 2
TECHNICAL BULLETIN
JTB00191NAS3
06 SEP 2013
© Jaguar Land Rover North America, LLC
NOTE: The information in Technical Bulletins is intended for use by trained, professional Technicians with the knowledge, tools,
and equipment required to do the job properly and safely. It informs these Technicians of conditions that may occur on some
vehicles, or provides information that could assist in proper vehicle service. The procedures should not be performed by 'do-ityourselfers'. If you are not a Retailer, do not assume that a condition described affects your vehicle. Contact an authorized
Jaguar service facility to determine whether this bulletin applies to a specific vehicle.
This reissue replaces all previous versions. Please destroy all previous versions. Only refer to the
electronic version of this Technical Bulletin in TOPIx.
SECTION: 501-12
Glove Compartment Lid Not Damped When Opening
AFFECTED VEHICLE RANGE:
XK Range (X150)
Model Year:
2007-2013
VIN:
B00001-B51978
MARKETS:
NAS
CONDITION SUMMARY:
Situation: The glove compartment lid may not be damped when opening.
Cause: This may be caused by the glove compartment lid damper cord retaining tab coming away from the
glove compartment housing.
Action: Should a customer express this concern, follow the Service Instruction outlined below.
PARTS:
NOTE: The cotter / split pin (2mm x approx 30mm) must be locally sourced.
-
2mm X 30mm cotter / split pin
Quantity: 1 (locally
sourced)
TOOLS:
No Tools Required
WARRANTY:
NOTE: Repair procedures are under constant review, and therefore times are subject to change;
those quoted here must be taken as guidance only. Always refer to TOPIx to obtain the latest repair
time.
NOTE: DDW requires the use of causal part numbers. Labor only claims must show the causal part
number with a quantity of zero.
DESCRIPTION
SRO
TIME (HOURS)
CONDITION CODE
CAUSAL PART
Glove compartment damper arm - Repair
76.95.64
0.3
42
C2P16747SEP
NOTE: Normal Warranty policies and procedures apply.
SERVICE INSTRUCTION:
http://topix.jaguar.jlrint.com/topix/service/document/438326
9/11/2013
Page 2 of 2
1. Remove the glove compartment (see TOPIx Workshop Manual, Section 501-12).
2. Using a suitable 2mm drill, drill a hole (shown in
the shaded area) through the glove compartment
damper arm.
3. Install the glove compartment lid damper cord
looped end into the damper arm ('1').
Install the cotter / split pin into the drilled hole
and through the damper cord looped end ('2').
4. Fold the protruding ends of the cotter / split pin.
5. Install the glove compartment (see TOPIx Workshop Manual, Section 501-12).
http://topix.jaguar.jlrint.com/topix/service/document/438326
9/11/2013