JTB00191NAS2

TECHNICAL BULLETIN
JTB00191NAS2
12-DEC-12
ISSUE ‘2’ CHANGES ARE HIGHLIGHTED IN GRAY
SECTION: 501-12
Glove Compartment Lid not Damped When Opening
AFFECTED VEHICLE RANGE:
XK (X150)
VIN:
Model Year:
B00001-B45174
2007-2011
CONDITION SUMMARY:
Situation: The glove compartment lid may not be damped when opening.
Cause: This may be caused by the glove compartment lid damper cord retaining tab coming away from the
glove compartment housing.
NOTE: The split / cotter pin (2mm X 30mm) must be locally sourced.
Action: In the event of a customer concern of the above, refer to the Repair Procedure outlined below to
install a split / cotter pin onto the glove compartment damper arm.
PARTS:
2mm X 30mm split / cotter pin
Qty: 1 (to be obtained locally)
TOOLS:
No special tools required
WARRANTY:
NOTE: Repair procedures are under constant review, and therefore times are subject to change; those
quoted here must be taken as guidance only. Always refer to DDW to obtain the latest repair time.
DDW requires the use of causal part numbers. Labor only claims must show the causal part number with a
quantity of zero.
DESCRIPTION
Glove compartment damper arm - repair
SRO
TIME
(HOURS)
CONDITION
CODE
CAUSAL
PART
76.95.64
0.30
42
C2P16747SEP
Normal Warranty policies and procedures apply
NOTE: The information in Technical Bulletins is intended for use by trained, professional Technicians with the knowledge, tools, and
equipment required to do the job properly and safely. It informs these Technicians of conditions that may occur on some vehicles, or
provides information that could assist in proper vehicle service. The procedures should not be performed by 'do-it-yourselfers'. If you are not
a Retailer, do not assume that a condition described affects your vehicle. Contact an authorized Jaguar service facility to determine whether
this bulletin applies to a specific vehicle.
© Jaguar Land Rover North America, LLC
555 MacArthur Boulevard
Mahwah, NJ 07430
REPAIR PROCEDURE
1. Refer to Workshop Manual section 501-12 and remove the
glove compartment.
2. Drill a 2mm hole through the glove compartment damper arm
(shaded area).
3. Install the glove compartment lid damper cord looped () end
into the damper arm.
4. Install the split / cotter pin () into the hole and through the
damper cord looped end.
5. Fold the protruding ends of the split / cotter pin.
6. Refer to Workshop Manual section 501-12 and install the
glove compartment.