03-001-17
Service Bulletin Details
Public Details for: 03-001-17
Noise in front of vehicle when accelerating or decelerating this bulletin involves replacing both front half shafts. The customer may describe a ?Clunk type? Noise in front of the vehicle while accelerating or decelerating.
Models from 2017
2017 JEEP RENEGADE |
Models from 2016
2016 JEEP RENEGADE |
Models from 2015
2015 JEEP RENEGADE |
NUMBER: GROUP: DATE: 03-001-17 Differential & Driveline March 10, 2017 This bulletin is supplied as technical information only and is not an authorization for repair. No part of this publication may be reproduced, stored in a retrieval system, or transmitted, in any form or by any means, electronic, mechanical, photocopying, or otherwise, without written permission of FCA US LLC. SUBJECT: Noise In Front Of Vehicle When Accelerating Or Decelerating OVERVIEW: This bulletin involves replacing both front half shafts. MODELS: 2015 - 2017 (BU) Jeep Renegade NOTE: This bulletin applies to vehicles within the following markets/countries: EMEA. NOTE: This bulletin applies to vehicles built on or before December 14, 2016 (MDH 1214XX) equipped with 2.0L I4 Turbo Diesel Engine (Sales Code EBT) with a 9-SPD 948TE Automatic Transmission (Sales Code DFH). SYMPTOM/CONDITION: The customer may describe a “clunk type” noise in front of the vehicle while accelerating or decelerating. DIAGNOSIS: 1. Verify the noise is coming from the front half shafts. Refer to the detailed service procedures available in DealerCONNECT> TechCONNECT under: Service Info> 03 Differential and Driveline/Half Shaft, Front/Diagnosis and Testing. 2. If the noise is coming from either of the front half shafts: a. Replace both half shafts. Proceed to Step #1 in the repair procedure. 3. If the noise is not coming from one or both front half shafts: a. This Bulletin does not apply. Normal diagnosis should be performed. If the customer describes the symptom/condition listed above, perform the Repair Procedure. 03-001-17 -2- PARTS REQUIRED: Qty. Part No. Description 2 68368730AA Shaft, Axle Half, Front 2 06509898AA NUT, Hex Flange Lock, M24x1.5 (Axle Hub Nut) 2 68361340AA NUT, Lock, M10X1.50 (Tie Rod End Nut) 2 68270263AA Bolt, Torx Head, M10X1.50X55.00 (Lower Ball Joint Stud Bolt) 2 06511467AA NUT, Hex Flange (Lower Ball Joint Stud Nut) REPAIR PROCEDURE: NOTE: The axle hub nut, lower ball joint stud nut and bolt are not reusable and must be replaced. 1. Remove both front half shafts. Refer to the detailed service procedures available in DealerCONNECT> TechCONNECT under: Service Info> 03 - Differential and Driveline> Half Shaft, Front> Removal/Installation. POLICY: Reimbursable within the provisions of the warranty. TIME ALLOWANCE: Labor Operation No: 02-13-05-9G Description Replace Both Front Axle Half Shafts (2 - Skilled) FAILURE CODE: ZZ Service Action Skill Category 3 - Driveline Amount 2.5 Hrs.