JTB00339NAS1

Page 1 of 4
TECHNICAL BULLETIN
JTB00339NAS1
04 FEB 2014
© Jaguar Land Rover North America, LLC
NOTE: The information in Technical Bulletins is intended for use by trained, professional Technicians with the knowledge, tools,
and equipment required to do the job properly and safely. It informs these Technicians of conditions that may occur on some
vehicles, or provides information that could assist in proper vehicle service. The procedures should not be performed by 'do-ityourselfers'. If you are not a Retailer, do not assume that a condition described affects your vehicle. Contact an authorized
Jaguar service facility to determine whether this bulletin applies to a specific vehicle.
SECTION: 501-14
'Hood Open' Message Displayed on Instrument Cluster
AFFECTED VEHICLE RANGE:
XJ Range (X351)
Model Year:
2010-2014
VIN:
V00047-V62119
MARKETS:
NAS
CONDITION SUMMARY:
Situation: A 'Hood Open' message may be displayed on the Instrument Cluster.
Cause: This may be caused by a faulty hood open switch
Action: Should a customer express this concern, follow the Service Instruction outlined below.
PARTS:
C2D30423
Hood Latch
Quantity: 1
TOOLS:
No Tools Required
WARRANTY:
NOTE: Repair procedures are under constant review, and therefore times are subject to change;
those quoted here must be taken as guidance only. Always refer to TOPIx to obtain the latest repair
time.
NOTE: DDW requires the use of causal part numbers. Labor only claims must show the causal part
number with a quantity of zero.
DESCRIPTION
SRO
TIME (HOURS)
CONDITION CODE
CAUSAL PART
Hood open switch / latch - Renew
86.65.99
0.3
42
C2D5991
NOTE: Normal Warranty policies and procedures apply.
SERVICE INSTRUCTION:
1. Open the hood.
2. Remove the two bolts from the left-side hood latch.
http://topix.jaguar.jlrint.com/topix/service/document/452792
2/12/2014
Page 2 of 4
3. Lift the left-side hood latch upwards to allow access
to the spacer.
4. Remove the spacer.
http://topix.jaguar.jlrint.com/topix/service/document/452792
2/12/2014
Page 3 of 4
5. Disconnect the electrical connector.
6. Remove the switch:

 Release the two clips.
http://topix.jaguar.jlrint.com/topix/service/document/452792
2/12/2014
Page 4 of 4
7. Release the hood cable.
8.
NOTE: The hood open switch element is now integrated into the new latch assembly .
Install a new left-side hood latch:

 To install, reverse the removal procedure.
• Tighten the two bolts; torque to 10Nm.
http://topix.jaguar.jlrint.com/topix/service/document/452792
2/12/2014