PIT5800B
Service Bulletin Details
Public Details for: PIT5800B
This preliminary information communicates and issues with fuse f49 blowing causing a ses mil and a service theft deterrent system message displayed in the dic. It instructions dealership to inspect the 12 volt power accessory port for shor
Models from 2023
| 2023 CADILLAC ESCALADE ESV |
| 2023 CHEVROLET SUBURBAN |
| 2023 CHEVROLET TAHOE |
| 2023 GMC YUKON XL |
Models from 2022
| 2022 CADILLAC ESCALADE ESV |
| 2022 CHEVROLET SUBURBAN |
| 2022 CHEVROLET TAHOE |
| 2022 GMC YUKON XL |
Models from 2021
| 2021 CADILLAC ESCALADE ESV |
| 2021 CHEVROLET SUBURBAN |
| 2021 CHEVROLET TAHOE |
| 2021 GMC YUKON XL |
Bulletin No.: PIT5800B Published date: 12/12/2022 Preliminary Information PIT5800B Service Theft Deterrent System / SES MIL / Fuse F49DR Open / DTCs B113C, B13AC, B1AC3, B195D, B195E, U3018, U3501 Models Brand: Model: Model Years: VIN: from to Engine: Transmissions: Cadillac Escalade Models 2021 - 2023 All All All All Chevrolet Suburban 2021 - 2023 All All All All Chevrolet Tahoe 2021 - 2023 All All All All GMC Yukon Models 2021 - 2023 All All All All Involved Region or Country North America Condition Some customers may comment on a SES MIL and a Service Theft Deterrent System message displayed in the DIC. When checking for DTC's, any of the following DTC's may be set: B113C, B13AC, B1AC3, B195D, B195E, U3018 and/or U3501. Also, fuse F49DR in the right IP fuse block will be open. Cause One possible cause of this condition is a short in the 12 volt power accessory illuminated ring. The 12 volt power accessory ports X80G or X80H have a LED illuminated ring around the perimeter (1), shown below. The LED illuminated ring is part of the 12 volt accessory port receptacle retainer, see 2nd photo. The 12 volt accessory port receptacle retainer has two contact tabs for the LED illuminated ring (2 and 3) which mate to the 12 volt accessory port receptacle (5 and 6), see 3rd photo. Tab 2 is for the power to the LED illuminated ring circuit 6817 and tab 3 is the ground which should only contact the outer metal body (6) of the 12 volt accessory port receptacle. If tab 3 is improperly formed or gets bent during service, it can short out between the metal body (6) and the slide contact (5) for tab 2, as shown below in call out 4. Tab 3 should only contact the metal body of the 12 volt accessory port receptacle (6). Correction: Following SI, remove the 12 volt power accessory port X80G or X80H and inspect grounding tab 3. If the tab is shorting out between the metal body (6) and slide contact (5) for tab 2 then replace the 12 volt Accessory Power Port Receptacle Retainer. Note: After repairs are complete, some DTCs may not clear until the vehicle completely goes to sleep. Turn the ignition o and disable RAP by opening and closing the driver’s door, then leave the vehicle undisturbed so it can completely power down which may take up to 20 minutes. Warranty Information For vehicles repaired under the Bumper-to-Bumper coverage (Canada Base Warranty coverage), use the following labor operation. Reference the Applicable Warranties section of Investigate Vehicle History (IVH) for coverage information. Labor Operation Description Labor Time 5420300 Front Floor Console Accessory Power Rear Receptacle Retainer Replacement Use Published Time Version History Version Modi ed 3 11/19/2020 - Created on. 01/24/2022- Updates to the model and correction sections 12/12/2022 - Updates to the Models, Cause and Correction sections © 2023 General Motors. All Rights Reserved.