0215814
Service Bulletin Details
Public Details for: 0215814
Accessory drive belt tensioner component changes
- 2014 - 2013 - 2012 - 2011 - 2010 -
Models from 2014
2014 SUBARU LEGACY |
Models from 2013
2013 SUBARU LEGACY |
Models from 2012
2012 SUBARU LEGACY |
Models from 2011
2011 SUBARU LEGACY |
Models from 2010
2010 SUBARU LEGACY |
ATTENTION: CLAIMS PERSONNEL q IMPORTANT - All Service Personnel Should Read and Initial in the boxes provided, right. SERVICE MANAGER © 2014 Subaru of America, Inc. All rights reserved. GENERAL MANAGER q PARTS MANAGER q q SERVICE INFORMATION APPLICABILITY: SUBJECT: NUMBER: 02-158-14 2010-15 Legacy Models with 3.6L H6 Engine Accessory Drive Belt Tensioner Component Changes DATE: 11/21/14 INTRODUCTION This Service Information bulletin announces changes to the component parts of the accessory drive belt tensioner assembly used on 3.6L H-6 engines. These design changes will increase the rigidity of the tensioner assembly while improving production efficiency. COUNTERMEASURE IN PRODUCTION The new accessory belt tensioner components were incorporated into production on July 18, 2014 starting with Engine Number: 552158. PART INFORMATION PART NUMBER DESCRIPTION 13086AA200 BRKT- TENSIONER 13082AA020 STOPPER- BELT ADJ 13063AA020 WASH- BELT ADJ 800110670 BOLT- 10 X 70 X 70 1. BRKT-TENSIONERDiameter of the adjuster bolt hole increased to match M10 bolt (8.5mm to 10.5mm) 2. S TOPPER-BELT ADJShape changed to prevent damage to the mounting bracket and to accomodate increased bolt size from M8 to M10. CAUTION: VEHICLE SERVICING PERFORMED BY UNTRAINED PERSONS COULD RESULT IN SERIOUS INJURY TO THOSE PERSONS OR TO OTHERS. Subaru Service Bulletins are intended for use by professional technicians ONLY. They are written to inform those technicians of conditions that may occur in some vehicles, or to provide information that could assist in the proper servicing of the vehicle. Properly trained technicians have the equipment, tools, safety instructions, and know-how to do the job correctly and safely. If a condition is described, DO NOT assume that this Service Bulletin applies to your vehicle, or that your vehicle will have that condition. Bulletin Number: 02-158-14; Date: 11/21/14 4. B OLT- Size increase to increase regidity from M8 to M10. 3. W ASH-BELT ADJOutside diameter increased from 31 to 33mm. Continued... SUBARU OF AMERICA, INC. IS ISO 14001 COMPLIANT ISO 14001 is the international standard for excellence in Environmental Management Systems. Please recycle or dispose of automotive products in a manner that is friendly to our environment and in accordance with all local, state and federal laws and regulations. Page 1 SERVICE PROCEDURE / INFORMATION When repairing or replacing the belt tensioner or its component parts, follow the procedures outlined in the applicable Service Manual. **VERY IMPORTANT: If any of the four belt tensioner components described in this bulletin require replacement, ALL FOUR PARTS MUST BE REPLACED AS A SET as they cannot be mixed and matched. REMINDER: SOA strongly discourages the printing and/or local storage of service information as previously released information and electronic publications may be updated at any time. Always refer to STIS for the latest service information before performing any repairs. Bulletin Number: 02-158-14; Date: 11/21/14 Page 2