A2623502070152_1

Technical Service Bulletin
26 Exhaust manifold heat shield, noises from engine compartment - 5.2 ltr. V10 FSI
26 23 50 2070152/1 April 27, 2023.
Model(s)
Year
VIN Range
Vehicle-Specific Equipment
R8, and R8
Spyder
2016 – 2023
All
Not Applicable
Condition
Customer states:
• Whirring/ringing noises when accelerating at engine RPM between 2000 and 2500 rpm.
Workshop findings:
•
Noise complaint can be duplicated and sounds like a whirring/ringing noise produced by a metal panel.
Technical Background
Due to tight component tolerances, vibrations may occur under specific loads and engine RPM ranges and result
in minimal contact between the exhaust manifold heat shields and the exhaust manifolds.
Production Solution
Not Applicable
Service
If the customer complaint is similar to the noise which can be heard after 12-13 seconds in example video 1,
please check the manifold heat shields on bank 1 and bank 2 in accordance with example videos 2 (OK) and 3
(not OK).
Page 1 of 3
© 2023 Audi of America, Inc.
All rights reserved. Information contained in this document is based on the latest information available at the time of printing and is subject to the copyright and other intellectual property rights
of Audi of America, Inc., its affiliated companies and its licensors. All rights are reserved to make changes at any time without notice. No part of this document may be reproduced, stored in a
retrieval system, or transmitted in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, nor may these materials be modified or reposted to other sites, without
the prior expressed written permission of the publisher.
Technical Service Bulletin
Figure 1: This video demonstrates
the noise that a customer may
report, which can be heard 12-13
seconds into the video.
Figure 2: This video demonstrates
the sound that is produced by the
heat shield when checking for
proper fit.
Figure 3: This video demonstrates
the noise that is produced by the
heat shield when there is not
enough clearance.
You may access all three videos here:
https://audi-external.kzoplatform.com/containers/2464810158010668389
If there is a similar noise issue with the heat shields, the affected heat shield must be adjusted (while still
installed) to allow for greater clearance between the heatshield and the exhaust manifold.
Figure 4: The manifold heat shield is circled in red.
Warranty
Page 2 of 3
© 2023 Audi of America, Inc.
All rights reserved. Information contained in this document is based on the latest information available at the time of printing and is subject to the copyright and other intellectual property rights
of Audi of America, Inc., its affiliated companies and its licensors. All rights are reserved to make changes at any time without notice. No part of this document may be reproduced, stored in a
retrieval system, or transmitted in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, nor may these materials be modified or reposted to other sites, without
the prior expressed written permission of the publisher.
Technical Service Bulletin
Claim Type:
• 110 Up to 48 Months/50,000 Miles.
• If the vehicle is outside of any warranty, this Technical Service Bulletin is
informational only.
Service Number:
2612
Damage Code:
0020
Labor Operations:
Modify manifold heat shields (Coupé)
2612 4999
20 TU
Modify manifold heat shields (Spyder)
2612 4999
80 TU
GFF
No allowance
0 TU
Road test prior to the service procedure
0121 0002
10 TU
Road test after the service procedure
0121 0004
10 TU
Diagnostic Time:
Claim Comment:
As per TSB 2070152/1
All warranty claims submitted for payment must be in accordance with the Audi Warranty Policies and Procedures
Manual. Claims are subject to review or audit by Audi Warranty.
Additional Information
All part and service references provided in this TSB (2070152) are subject to change and/or removal. Always
check with your Parts Department and/or ETKA for the latest information and parts bulletins. Please check the
Repair Manual for fasteners, bolts, nuts, and screws that require replacement during the repair.
©2023 Audi of America, Inc. All rights reserved. The information contained in this document is based on the
latest information available at the time of printing and is subject to the copyright and other intellectual property
rights of Audi of America, Inc., its affiliated companies, and its licensors. All rights are reserved to make changes
at any time without notice. No part of this document may be reproduced, stored in a retrieval system, or
transmitted in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, nor may
these materials be modified or reposted to other sites, without the prior expressed written permission of the
publisher.
Page 3 of 3
© 2023 Audi of America, Inc.
All rights reserved. Information contained in this document is based on the latest information available at the time of printing and is subject to the copyright and other intellectual property rights
of Audi of America, Inc., its affiliated companies and its licensors. All rights are reserved to make changes at any time without notice. No part of this document may be reproduced, stored in a
retrieval system, or transmitted in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, nor may these materials be modified or reposted to other sites, without
the prior expressed written permission of the publisher.