SSM76000
Service Bulletin Details
Public Details for: SSM76000
Startup battery reduced state of charge
8/2/23, 8:31 AM TOPIx - SSM76000 - Startup Battery Reduced State of Charge (SOC) Reference SSM76000 Models E-PACE / X540 F-PACE / X761 XE / X760 XF / X260 Title Startup Battery Reduced State of Charge (SOC) Category Electrical Last modified 10-Jul-2023 00:00:00 Symptom 206000 Warning Indicators Content X540, X761, X760, X260 23MY onwards MHEV vehicles only Issue: Customers are reporting 'Stop Safely' and 'Electric Charging fault' warning messages displayed on the Instrument Panel Cluster. The following Diagnostic Trouble Codes (DTC)s may also be stored in the Battery Energy Control Module (BECM): - U0120-00 - P0DA8-62 - U0064-87. Cause: The cause is currently unknown and is under investigation. The information gathered from this SSM will assist the investigation. Action: Upon a vehicle entering the retailer with 'Stop Safely' and 'Electric Charging fault' warning messages displayed on the Instrument Panel Cluster, continue diagnosis using the TOPIx workshop manual and TOPIx Cloud, as required. Extra care must be taken to make sure all BISG electrical connections and connector pins are secure and correctly installed. If no fault is found by continuing further diagnosis, and the same warning messages and DTCs become present again within 2 days: Collect the Power Mode Zero (PMZ) logs with the existing Belt Intergrated Starter Generator (BISG) installed. For guidance on collecting the PMZ logs, on TOPIx, go to, Browse All > Documents > Diagnostics > General > CAN logger > Open 'VCI_CAN_Logger_1 - JLR VCI CAN Logger' Raise an Electronic Product Quality Report (EPQR) with the following information: - This SSM reference (SSM 76000) - Engineering reference: PTS_100 https://topix.jaguar.jlrext.com/topix/content/document/view?id=1700321 1/2 8/2/23, 8:31 AM TOPIx - SSM76000 - Startup Battery Reduced State of Charge (SOC) - The PMZ logs - The serial number located on the existing BISG Renew the BISG If the same warning messages and DTCs become present again within 2 days, after renewing the BISG: Collect the PMZ logs again, this time with the new BISG installed For guidance on collecting the PMZ logs, on TOPIx, go to, Browse All > Documents > Diagnostics > General > CAN logger > Open 'VCI_CAN_Logger_1 - JLR VCI CAN Logger' Raise a Technical Assistance (TA) with the following information: - This SSM reference (SSM 76000) - Engineering reference: PTS_100 - The PMZ logs for the new BISG - The serial number located on the new BISG anBhdHRlcnM7MjAyMy0wOC0wMlQxMjozMTo0My45NTFaOzEzNi4yMjYuNTAuMTEzOw== https://topix.jaguar.jlrext.com/topix/content/document/view?id=1700321 2/2