NTB23-062
Service Bulletin Details
Public Details for: NTB23-062
License plate bracket installation on front fascia service information review the service procedure starting on page 3 to install a license plate bracket to the front fascia of an applied vehicle.
- 2023 -
Models from 2023
2023 NISSAN ARIYA |
Classification: BT23-003 Reference: Date: NTB23-062 July 31, 2023 LICENSE PLATE BRACKET INSTALLATION ON FRONT FASCIA APPLIED VEHICLES: 2023 ARIYA (FE0) SERVICE INFORMATION Review the SERVICE PROCEDURE starting on page 3 to install a license plate bracket to the front fascia of an APPLIED VEHICLE. Bulletins are intended for use by qualified technicians, not 'do-it-yourselfers'. Qualified technicians are properly trained individuals who have the equipment, tools, safety instruction, and know-how to do a job properly and safely. NOTE: If you believe that a described condition may apply to a particular vehicle, DO NOT assume that it does. See your Nissan dealer to determine if this applies to your vehicle. 1/5 REQUIRED SPECIAL TOOLS EPDM Semi Closed Cell Foam J-50397-7 (new tool number NI-50397-7) Urethane Foam Tape J-50397-11 (new tool number NI-50397-11) Figure 1 New or replacement Required Special Tools are available from Tech Mate online: www.techmatetools.com, or by phone: 1-833-397-3493. 2/5 NTB23-062 SERVICE PROCEDURE 1. Cut the EPDM Semi Closed Cell Foam J-50397-7 into two (2) pieces. IMPORTANT: Each piece must be no longer than 70 mm (2.75 in.) 70 mm (2.75 in.) Figure 2 2. Cut the Urethane Foam J-50397-11 into two (2) pieces. IMPORTANT: Each piece must be no longer than 70 mm (2.75 in.) 70 mm (2.75 in.) Figure 3 3. Remove the two (2) posts from the back of the license plate bracket, as shown in Figure 4. Figure 4 3/5 NTB23-062 4. Double layer the foam by placing the EPDM Semi Closed Cell Foam J-50397-7 onto the Urethane Foam J-50397-11, as shown in Figure 5. EPDM Semi Closed Cell Foam (J-50937-7) Figure 5 5. Urethane Foam (J-50937-11) Install the J-nuts, and then place the two (2) pieces of double layered foam on the top corners of the license plate bracket, as shown in Figure 6. IMPORTANT: The double layered foam must not cover the J-nuts. J-nuts (2) Double layered foam (2) Figure 6 4/5 NTB23-062 6. Mount the front license plate bracket to the bumper fascia at the location marks (small dimples) using the two (2) provided screws. Figure 7 CLAIMS INFORMATION Submit a Primary Part (PP) type line claim using the following claims coding: (1) DESCRIPTION PFP OP CODE SYM DIA FRT Install Front License Plate Bracket (1) BX8JAA ZE 32 0.2 Reference the electronic parts catalog and use the license plate bracket as the Primary Failed Part (PFP). EXPENSE CODE EXPENSE CODE 071 DESCRIPTION FOAM PAD/TAPE MAX AMOUNT $12.70 AMENDMENT HISTORY PUBLISHED DATE REFERENCE July 31, 2023 NTB23-062 DESCRIPTION Original bulletin published 5/5 NTB23-062