No. 168-22
Service Bulletin Details
Public Details for: No. 168-22
Technical information for wnm8 - reworking threaded bush on rear end strut
- 2022 -
Models from 2022
Service Technical Information 168/22 ENU WNM8 4 WNM8 – Reworking Threaded Bush on Rear-End Strut (Workshop Campaign) Revision: This bulletin replaces bulletin Group 4 168/22 WNM8, dated September 30, 2022. Model Year: 2022 Model Line: Panamera (971) Concerns: Threaded bush on rear-end strut Information: There is a possibility that the fastening screws on the rear end strut on the affected vehicles were not tightened to the specified tightening torque. This can result in acoustic problems (rattling noises) in the rear end area. Action required: Reworking threaded bush on rear-end strut. Affected Vehicles: Only vehicles assigned to the campaign (see also PCSS Vehicle Information). Required parts Parts Info: Part No. Designation Number PAF008584 Internal hexagon round flange screw, M8 x 20 2 pieces PAF008976 Threaded Insert 2 pieces Required tools Tools: • • Torque wrench, 6-50 Nm (4.43-36.88 ft-lbs) e.g. VAG 1331A torque wrench, 6-50 Nm or equivalent Thread Repair Kit M8 (Twinsert) - VAS 271 001 Reworking threaded bush on rear-end strut Work Procedure: 1 Removing rear-end strut (hash). For instructions, see Workshop Manual '421319 Removing and installing strut' AfterSales Aug 21, 2023 Page 1 of 2 4 Service Technical Information ENU 168/22 WNM8 2 Rework Threaded bush for rear end strut -1threaded bushes for rear end strut (hash). 3 Installing rear end strut (hash). For instructions, see Workshop Manual '421319 Removing and installing strut' Replace Threaded bush for rear end strut -1both rear screws for the new threaded bushes on the rear-end strut (hash) and tighten to the prescribed tightening torque. Tightening torque 25 Nm (18.4 ftlb.) 4 Enter the campaign in the Warranty and Maintenance booklet. Threaded bush for rear end strut Warranty processing Scope 1: Reworking threaded bush on rear-end strut Labor time: Reworking threaded bush on rear-end strut Includes: Removing and installing rear end struts (hash) Labor time: 124 TU Required parts: PAF008584 Internal hexagon round flange screw, M8 x 20 2 pieces PAF008976 Threaded Insert 2 pieces Damage code WNM8 066 000 1 Important Notice: Technical Bulletins issued by Porsche Cars North America, Inc. are intended only for use by professional automotive technicians who have attended Porsche service training courses. They are written to inform those technicians of conditions that may occur on some Porsche vehicles, or to provide information that could assist in the proper servicing of a vehicle. Porsche special tools may be necessary in order to perform certain operations identified in these bulletins. Use of tools and procedures other than those Porsche recommends in these bulletins may be detrimental to the safe operation of your vehicle, and may endanger the people working on it. Properly trained Porsche technicians have the equipment, tools, safety instructions, and know-how to do the job properly and safely. Part numbers listed in these bulletins are for reference only. The work procedures updated electronically in the Porsche PIWIS diagnostic and testing device take precedence and, in the event of a discrepancy, the work procedures in the PIWIS Tester are the ones that must be followed. © 2023 Porsche Cars North America, Inc. Aug 21, 2023 Page 2 of 2 AfterSales