PIT6018F

Bulletin No.: PIT6018F
Published date: N/A
Preliminary Information
PIT6018F IPC Display And Radio Blank, No Audio or Possible
Update Failed Message On Display After a Discharged Battery
Event
Product Investigation Review Required
Models
Brand:
Model:
Model Years:
VIN:
from
to
Engine:
Transmissions:
Cadillac
Lyriq
2023 - 2024
All
All
All
All
Cadillac
XT4
2024
All
All
All
All
Chevrolet
Colorado
2023
All
All
All
All
Chevrolet
Silverado EV
2024
All
All
All
All
GMC
Canyon
2023
All
All
All
All
Involved Region or
Country:
Additional RPO(s):
Condition:
Cause:
North America
Equipped with Infotainment System RPO IVD
IPC Display And Radio Blank, No Audio.
Possibly a Failed Update Message After a Discharged Battery
Event
Logic Lock Up Usually Due To Low Voltage Or A Failed Update.
Correction:
Note: Use a USB C type ash drive for the vehicle, it is not recommended to use an adapter as this may cause the
programming event to fail.
USB 2.0 & above with FAT32 format (USB 3.0 & 3.1 is highly recommended)
Minimum size 16GB, maximum size of 32GB.
Disconnect the battery and fully charge then reconnect. If the battery was previously charged, leave it
disconnected for 15 minutes.
Recheck the functions. There are three conditions that the vehicle could be in.
1.The screen will be black
i. Start at Section 1.
2. The screen will show the below update failed message asking to return the vehicle to the dealer (image)
i. Start at Section 2.
3. The screen will come up normally
i. Start at Section 2.
Section 1
Perform radio reprogramming with SPS2 using the Dealer VCI for the appropriate model.
It will be necessary to calculate the VCI for each vehicle. The calculation is based on the last 6 digits of the VIN and
a brand speci c number.
Chevrolet Colorado: 96413 + Last 6 of VIN = VCI number
(ex: 96413 + 165897 = 262310)
GMC Canyon: 36173 + Last 6 of VIN = VCI number
(ex: 36173 + 160558 = 196731)
Note: If you receive an “invalid VCI” error or have any issues with the VCI, please contact Techline at 1-800-8286860.
If you still have a black screen, disconnect the battery again for 15 minutes and recheck for screen operation.
Section 2
If function has returned perform a battery test, note results and attach to the repair order.
Note: Use a USB C type ash drive for the vehicle, it is not recommended to use an adapter as this may cause the
programming event to fail.
USB 2.0 & above with FAT32 format (USB 3.0 & 3.1 is highly recommended)
Minimum size 16GB, maximum size of 32GB.
Using SPS load an appropriate USB drive with the latest software.
After the USB drive is created by SPS, follow PIT6047 Radio USB Update Battery Ignore File to create an additional
le on the drive named gm_usb_ignore_battery.
Install the USB drive and shut the vehicle o .
While the vehicle is o and the USB drive is still connected, the radio will start recovering within 15-20 minutes.
Some vehicles may not be able to turn the ignition on or o as long as the message is on the display it should
start recovering.
It may be necessary to repeat this process until it completes.
Note: The A11 radio will not have communication with GDS2 when the failed update message is not present but it
will still have communication with SPS2 the recovery will not begin without the message present.
Note: If the radio display shows "Calibrate Device" after the USB update has completed, the A11 radio needs to be
reprogrammed with SPS2 for calibrations. If it does not show this, all is well and vehicle can be retested for
operation and released.
Perform SPS Setup
If issue is not resolved or there are codes now stored perform published diagnostics.
Warranty Information
Warranty Information
For vehicles repaired under the Bumper-to-Bumper coverage (Canada Base Warranty coverage), use the following
labor operation. Reference the Applicable Warranties section of Investigate Vehicle History (IVH) for coverage
information.
Labor
Operation
Description
Time
Reprogram radio for update failed, or IPC and radio black and no audio and battery
discharged
*This is a unique Labor Operation for Bulletin use only.
2889718
Version History
Version
Modified
7
05/16/2023 - Created on.
07/26/2023 - Added recovery process.
08/02/2023 - Updated Recovery Process.
08/08/2023 - Updated Correction, added XT4.
08/09/2023 - Added Lyriq 2023- 2024 Model Year, updated
correction and VCI's.
08/11/2023 - Added Labor Operation.
08/18/2023 - Added USB drive recommendation.
© 2023 General Motors. All Rights Reserved.
0.6
Hr.