Edition32

A PDF of this newsletter and previous ones can be found by logging in to ServiceNet and clicking on the ElsaWeb
Newsletter section in the Technician References menu.
Edition 32: April 15, 2013
Content

Submit Your Article
Suggestions

Feedback Corner

Technical Bulletins

Pending Service
Solutions

Tech Tips

Campaigns

Updates

Suggestions
Submit Your Article Suggestions
We appreciate the article suggestions that have we have received and will be including many of
the topics in upcoming newsletters.
Please continue to submit suggestions for topics that you would like to see covered. Email your
ideas to [email protected].
Feedback Corner
This week’s feedback is from Blair regarding a 2004 Phaeton Repair Manual procedure. He
states:
“In the Repair Manual for removal of rear shelf, there is no mention of the need to remove the
three anchor points for car seats. Also in the SRT section for removal/installation, there is no
mention of the need to remove and install the C-Pillar Trim, which must be done to remove
the rear shelf.”
This feedback was reviewed by the Service Information team and was resolved. We really
appreciate Blair sending in feedback to help improve the quality of the repair Information.
Feedback Status
New
Completed To Factory
16
16
3
*Please note that this feedback feature is not the place to obtain technical assistance on Volkswagen vehicles, or to
report potential issues you may have experienced with a vehicle. If you require assistance in repairing or diagnosing a
vehicle issue, or wish to report a technical issue, please create a Volkswagen Technical Assistance ticket and contact the
Volkswagen Technical Helpline at (800)-678-2389.
Back to top
Technical Bulletins
01 13 11 - 2033416 Update Programming - MIL ON, DTC P0263, P0266,
P0269, P0272, P0275 and/or P0278 Stored in ECM Fault Memory
Model(s)
Year
Eng. Code
Trans.
Code
VIN Range
From
VIN Range
To
Touareg
2011–
2012
3.0L TDI(CATA)
All
All
All
Diagnostic strategy too sensitive.
Production Solution: Improved ECM software to address MIL ON complaints.
28 13 01 - 2029514 Supersedes T. B. V281206 dated December 20, 2012 to
correct battery removal and installation labor operation number in first
warranty table.
MIL ON, DTC(s) P0671, P0672, P0673 and/or P0674 Stored in ECM Fault
Memory.
Model(s)
Year
Eng. Code
Trans.
Code
VIN Range
VIN
From
Range To
Golf, Jetta Sportwagen,
Golf Wagon, Jetta
2011–
2012
2.0L (CJAA)
All
All
All
Passat
2012
2.0L(CKRA)
All
All
All
Internal hardware issue of the glow plug relay may cause an over voltage supply to
the glow plug(s) damaging the heating element
Production Solution: Improved glow plug relays implemented in production and
spare parts.
46 13 01 - 2010245 Supersedes T. B. V461105 dated April 15, 2011 to adjust
applicable model year to 2012 and 2013 models only.
Model(s)
Year
Eng.
Code
Trans.
Code
VIN Range
From
VIN Range
To
All(Except
Routan)
2012–
2013
All
All
All
All
Vibration or noise when braking may be due to brake disc corrosion protection
which has not been completely removed by normal braking, or surface rust built up
during transportation.
Note: This Technical Bulletin only applies once at PDI. Please note that vehicles in
dealer inventory should be maintained per the recommended 30 days maintenance
procedure to prevent excessive rust build up.
Production Solution: No production change required.
Pending Service Solutions
Pending Service Solutions coming soon.
Back to top
Tech Tips
24-11-02TT - P117A Fault Code
Model(s)
Year
Eng. Code
Trans. Code
Jetta, Golf, Beetle, Beetle
Convertible
2006–2013
All
All
For concerns of Fault Code P117A “Bank 1, correction Lambda middle reached
adjustment limit” stored in the ECM, check that the O2 sensors have not been
installed or connected improperly.
A quick check is to disconnect the rear O2 sensor and start the engine. The ECM
should set a fault for sensor 3 (heater circuit). If the fault is for sensor 2, the sensors
or connectors may be installed or connected improperly. If the fault is for sensor 3,
open a VTA ticket and contact the Volkswagen Technician’s Helpline.
46-09-04TT - Synchronization of the EPB Switch and EPB Module
Model(s)
Year
Eng. Code
Trans. Code
Passat
2006–2010
All
All
CC, Tiguan
2009–2013
All
All
If fault code 03200 or 16352 is present in the Electromechanical Parking Brake
(EPB) module, it may be due to the switch and module not being synchronized. To
synchronize the EPB switch and EPB control module:
Insert the ignition key to the run position.
 Press and hold the EPB switch.
Cycle the ignition off and then back to the run position.
 Let off of the EPB button.


61-12-01TT - Convertible Top Operation Stops, Trunk Does Not Lock Properly,
and/or Right Flap Does Not Close
Model(s)
Year
Eng. Code
Trans. Code
EOS
2012
All
All
Some 2012 EOS convertible tops may not function properly during opening or
closing. The trunk lock operation may not complete, which can cause trunk to be
inoperative and/or parcel shelf flaps to remain open when top opening cycle has
completed. This may affect the G562, G563, or G564 sensors when running the
test plan or looking at MVB 2. The guide bushing at the back of the lock
mechanism may not align with the guide pin mounted on the body. This can cause
damage to the guide bushing. The lock mechanism will need to be adjusted and
the guide bushing replaced in most instances.
To repair, open the trunk to access the underside of the parcel shelf. Remove the
guide bushing if it is damaged. Loosen the 2 lock mechanism mounting nuts shown
in figure 3 below on the underside of the parcel shelf (be sure to only loosen these
2 nuts due to pretension on the lock assembly). Adjust the locking mechanism so
that the rear alignment guide pin is centered in the guide bushing hole. Resecure
the 2 mounting nuts to 22NM. Close the trunk and cycle the top to check
functionality. If the guide bushing was found to be damaged, replace with part
number 1Q0898162A (see ETKA for latest supersession).
69-13-03TT - Front Seat Belt Tensioner Igniter 2 Location
Model(s)
Year
Eng. Code
Trans. Code
Passat
2012–2013
All
All
2012-2013 Passat vehicles use 2 front seat belt tensioner igniters and 1 belt force
limiter on each side of the vehicle. Seat belt tensioner igniter 1 (N153 for driver
side and N154 for passenger side) and belt force limiter (G551 for driver side and
G552 for passenger side) are located in the seat belt retractor assembly, while seat
belt tensioner igniter 2 (N297 for driver side and N298 for passenger side) is
located in the seat belt end fitting. The connector for N297/N298 can be accessed
by removing B-pillar trim and pulling back carpet slightly.
91-12-05TT - 2.5L Engine – P117A Fault Code (April 5, 2013: Update to Model
Years)
Model(s)
Year
Eng. Code
Trans. Code
Jetta, Golf, Beetle, Beetle
Convertible
2006–2013
2.5L
All
For concerns of Fault Code P117A “Bank 1, correction Lambda middle reached
adjustment limit” stored in the ECM, check that the O2 sensors have not been
installed or connected improperly.
A quick check is to disconnect the rear O2 sensor and start the engine. The ECM
should set a fault for sensor 3 (heater circuit). If the fault is for sensor 2, the sensors
or connectors may be installed or connected improperly. If the fault is for sensor 3,
open a VTA ticket and contact the Volkswagen Technician’s Helpline.
91-13-03TT - Equipped with RNS 510 – Radio Preset Display
Model(s)
Year
Eng. Code
Trans. Code
CC, Eos, Passat, Tiguan
2009–2013
All
All
Golf, Jetta, Jetta Sportwagen
2009–2011
All
All
Be aware that the 24 RNS-510 radio presets are not band dependent, and can be
programmed to any mix of AM, FM, or satellite stations. The presets shown on the
display will not change when switching between bands.
Back to top
Campaigns
No new campaigns in ElsaWeb.
Back to top
Updates
97Z5 Engine Wiring Spacer Ring (NVLW)
Model(s)
Year
Eng. Code
Trans. Code
VIN Range
From
VIN Range To
Touareg
2013
CNRB (3.0L
TDI)
All
All
All
This update has been proactively released to prevent chafing from occurring to the
engine harness.
This UPDATE is in effect until removed. Vehicle must meet all of the following
criteria:
Procedure is valid only for vehicles that show the 97Z5 code in ElsaWeb,
Campaign/Action Information screen on the day of repair.
 If the vehicle is sold it must be within the NEW VEHICLE LIMITED
WARRANTY.
 Procedure must be performed within the allotted time frame stated in this
UPDATE.
 Procedure must be performed on applicable vehicles in dealer inventory
prior to sale.

Back to top
Suggestions
Please send comments or suggestions to: [email protected]
Back to top
© 2013 Volkswagen of America, Inc. All rights reserved. Information contained in this document is based on the latest
information available at the time of printing and is subject to the copyright and other intellectual property rights of
Volkswagen of America, Inc., its affiliated companies and its licensors. All rights are reserved to make changes at any time
without notice. No part of this document may be reproduced, stored in a retrieval system, or transmitted in any form or by
any means, electronic, mechanical, photocopying, recording, or otherwise, nor may these materials be modified or reposted
to other sites, without the prior expressed written permission of the publisher.