PIT5207

File in Section:
Service Bulletin
Bulletin No.:
Date:
PIT5207
April, 2013
PRELIMINARY INFORMATION
Subject:
Service Stabilitrak Message With DTC C0455 and/or C0710 SYM5A After A Sequential
Programming
Models:
2010 Cadillac Escalade Hybrid
2010 Chevrolet Silverado Hybrid and Tahoe Hybrid
2010 GMC Sierra Hybrid and Yukon Hybrid
The following diagnosis might be helpful if the vehicle exhibits the symptom(s) described in this PI.
Condition/Concern
For the 2010 models, there is a 1st and 2nd design Steering Wheel Position Sensor (SWPS) and the EBCM has a
different calibration for each sensor design. If, after a sequential programming event, the EBCM sets DTC C0455
and/or C0710 SYM5A, it could be caused by the EBCM being programmed for the wrong SWPS design.
Recommendation/Instructions
Please contact Techline Customer Support Center at 800-828-6860 to determine if the vehicle has the correct EBCM
calibration.
Warranty Information
For vehicles repaired under warranty, please refer to the latest version of bulletin 06-08-47-001 for warranty
information on control module reset/configuration.
Please follow this diagnostic or repair process thoroughly and complete each step. If the condition exhibited is
resolved without completing every step, the remaining steps do not need to be performed.