Report
Service Bulletin Details
Public Details for: Report
Technician report
- 2014 -
Models from 2014
2014 AUDI A4 |
2014 AUDI ALLROAD |
2014 AUDI S4 |
PERFECT DELIVERY INSPECTION (PDI) 2014 A4/S4/allroad Audi Technician Report Stock No. Dealer Number R.O. No. VIN Road test mileage out Road test mileage in All items must be completed prior to customer delivery by an Audi technician **Refer to the Special functions tab of ODIS Diagnosis using GFF for the PDI function tests **Audi recommends using an Audi approved battery charger to prevent excessive battery discharge during inspection Trunk Inspection FF Install wheel bolt cover removal tool from PDI kit and wheel lock key (if applicable) into trunk tool kit behind right side cover FF Set spare tire pressure FF Verify operation of trunk emergency release handle (if equipped Open Campaigns/Updates FF Check Elsa for open campaigns and updates. Perform campaigns not requiring SVM if applicable. Campaigns requiring SVM should only be performed after the vehicle has been taken out of transport mode. Battery Inspection FF Check battery clamps for proper torque. Re-torque if required FF Perform the A-battery test for new batteries using GFF in ODIS Diagnosis –> Special functions –> Service work. Select option 2, the battery test for new batteries as part of the pre–delivery inspection and act according to the test result (ok, recharge, replace). Ensure diagnosis log is uploaded to the GFF paperless server by selecting “ok” when tester wants to send the current generated diagnosis protocol online. (Note: Do not use Guided Function. The diagnosis log will not be uploaded to GFF paperless) Transport Mode Deactivation, DTC check, set service reminder FF Deactivate vehicle transport mode (via Special functions –> Service work –> 19-Transport mode activating/deactivating ) FF Set service reminder (via Special functions –> Service work –> 17-PDI-resetting SRI at PDI, counter reset, etc.) FF For MMI3G+ vehicles, set adaptation channel (via Special functions –> Service work –> : 5F–Activating/deactivating storage of music) FF Perform an SVM specified /actual comparison (via Special functions ->Software Version Management (SVM)) FF Perform any campaign update requiring SVM at this time (follow instructions listed in campaign documentation) Exterior FF Test windshield washers and headlight washers (if equipped) for aim and function FF Test exterior lighting functions FF Check key functionality including seat memory (if applicable), verify vehicle starts and runs with the start/stop button, verify all doors lock/unlock with remote and Advanced Key, including door handle sensors (if equipped) FF Verify power rear lid/tailgate (allroad) is operational Interior FF Check operation of all switches: locks, windows, seat adjustment, power rear sunshade (if equipped) and child safety features FF Calibrate rear view mirror compass to proper zone and check self-dimming function/lighting (if equipped) FF Verify operation of all interior lights FF Mirrors: Inspect folding, adjustments, RH tilt in reverse, and memory (if equipped) FF Inspect operation of lighter, aux. outlet under armrest and rear outlet FF Verify operation of all front and rear seat belts and latches FF Check horn operation FF Check sunroof operation (open/close/vent/deflector at edge) FF Passenger side airbag: Verify operation of Passenger Occupant Detection System Radio Under the Hood Fluid Check and Inspection FF Verify operation of CD player FF Check all fluid levels and top off if necessary FF Verify operation of AMI or aux. input (if equipped) FF Check engine oil level using Special Tool T40178 on a flat and level surface FF SD card slot: Insert SD card and test function (Test all SD card slots as equipped) FF Verify HD Radio is turned “off” in Radio/Settings Menu (USA ONLY) Effective 10-1-2013 Version 1.0 1 of 2 PERFECT DELIVERY INSPECTION (PDI) 2014 A4/S4/allroad | Audi Technician Report Stock No. Dealer Number R.O. No. VIN Road test mileage out Road test mileage in Audi MMI/Navigation Road Test FF Verify and set Language and Measurement Units in Setup/ Settings menu FF Check for squeaks, rattles and wind noise FF Verify engine performance and acceleration FF Set Time source setting to “GPS” and set Auto daylight savings time to “on.” Change time zone appropriate to the dealer location FF Verify operation of rear view camera and rear parking sensors (if equipped) FF Navigation location: Set dealership location (for following back to dealership during road test) FF Verify Audi active lane assist functionality (if equipped) FF Set the “Music volume while parking” to 6 lines (accessed via MMI rear view camera display: Settings > Music volume while parking)(applies to vehicles with park assist or rear view camera) FF Voice Activation (if equipped): Press the “Talk” button and verify several commands FF Verify Audi side assist functionality (if equipped) FF Verify transmission operation, including shift paddles (if equipped) FF Check steering/tire alignment FF Test drive vehicle, applying brakes at least 4 times at 20 mph (35 km/h) to clean brake rotors Check for abnormal noise/ vibration/pulsation FF Parking brake: Apply and verify hold and release Audi connect (if equipped) (USA ONLY) FF Verify quality of radio reception in AM/FM/SAT bands FF Verify Audi connect Information Packet is present, including Audi brochure, T-Mobile brochure, customer SIM card, T-Mobile Terms & Conditions (T&C)(if applicable) FF Verify cruise control/ACC (if equipped) FF Connect the dealer demo SIM card to the vehicle and make sure the system fully connects to 2G or 3G (2G or 3G symbol with arrows)(only applies if in a T-Mobile service area) FF Climate control: Check all functions and ensure proper A/C cooling FF Enable Google Earth in the navigation settings and verify the white Google Logo appears next to the 2G or 3G symbol FF Ensure the wireless network is turned on (TEL function button > Settings Ctrl button > Wi-Fi settings > Wi-Fi active > select “Visible”) FF Check Wi-Fi hotspot functionality is enabled and verify the SSID is set to “AUDIXXXXX,” where XXXXX = the last five digits of VIN that are automatically preset in the system. On-Hoist Inspection FF Check underside of vehicle for fluid leaks and loose components FF Check steering, boots, brake system, hoses, tires and wheels for damage FF Remove transport suspension blocks (if installed) FF Inspect wheel bolts for proper torque using torque wrench FF Seat heating (if equipped): Inspect for proper operation FF Navigation function (if equipped): Activate NAV and follow directions back to dealership Post-Road Test Inspection FF Interrogate fault memory using the Scan Tool and print Diagnostic Log FF Record final mileage on checklist and sign checklist FF Ensure the yellow tire pressure tag is installed on steering wheel Showroom Display/Inventory Storage/Demo Vehicle FF Install showroom charger to ensure battery remains charged at all times FF Apply Inventory Maintenance Sticker FF Install standard wiper blades (if not already installed) FF Install wheel bolt covers and center caps as supplied Technician I certify that all operations have been completed and this vehicle has been prepared in accordance with Audi Procedures and Quality Standards, and has met the standards for Perfect Delivery. Technician Signature Effective 10-1-2013 Version 1.0 Completion Date 2 of 2