P0081
Intake valve Control Solenoid Circuit (Bank 2)
DTC P0081, sometimes indicated as P008100 is an OBD diagnostic trouble code indicating a generic fault with the vehicle powertrain (i.e. engine and gearbox). This code identifies an error with the air/fuel mixture causing intake valve control solenoid circuit (bank 2).
The Intake valve Control Solenoid Circuit (Bank 2) is open or shorted.
Possible Causes:
- Faulty Intake valve Control Solenoid (Bank 2)
- Intake valve Control Solenoid (Bank 2) harness is open or shorted
- Intake valve Control Solenoid (Bank 2) circuit fuse is blown
Possible Solutions:
1) Check the Intake valve Control Solenoid (Bank 2) for continuity
2) Repair the Intake valve Control Solenoid (Bank 2) circuit
3) Replace the Intake valve Control Solenoid (Bank 2)
- P0081: Intake valve Control Solenoid Circuit (Bank 2)
- P0081: Intake Valve Control Solenoid Circuit Bank 2
- P0081: Intake Valve-Bank 2 Control Circuit
- P0081: Intake Valve Control Solenoid Circuit
- P0081: Intake valve control solenoid, bank 2 – circuit malfunction
- P0081 00: The circuit of the solenoid which controls the intake valve (cylinder block # 2) - malfunction
- P0081 00: Intake valve control solenoid, bank 2 - circuit malfunction
2006 PONTIAC SOLSTICE
I took my Pontiac in and had ignition switch replaced and they installed a reinforcement strip on the air bag passenger seat .This did not fix the problem .I took it to crossroads chevorlet ,mt. Hope w.V. The internet said that if the reinforcement strip fixed it that was good but if it didnt that they would have to replsaace the sensor.Now crossrads have turned it in that is has been repaired and it hasnt. I ask the mechanic when i picked up the car that if i went out and set in the seat if the light on the dash would change butn when i went out and set in it it was still the same .They told me that if i wanted them to keep it or make another appointment that they would run a diagonase on the car and charge me 95.00 dollars and if it was the sensor that they could fix it but it would cost me labor and parts . I had a computer hooked to the car before i took it there and it threw up code P0081 which is the sensor. My car has the same results as it did when i took it there . It still has a warning to service air bag and the light won t change when somebody sets in the passenger seat . Is this something yall can help me with or do i need to get in contact with bbb of wv just wanting recall repaired withoutn any cost . I feel all they have done have put a reinforcement strip on a bad sensor .Can yall help me
AIR BAGS,