Recalls

Known Recall Investigations

  • Vehicle roll away
    On april 1, 2020, following information received from the office of defects investigation (odi) network of fleet contacts, odi opened pe20-003 to investigate reports of vehicle roll away in certain model year (my) 2008-2020 autocar and mack refuse trucks equipped with certain bendix pp-1 push-pull pneumatic park brake control valves with a pipe-away exhaust configuration. Prior to odi’s investigation,[kk(1]  bendix commercial vehicle systems llc (bendix), the subject component manufacturer, published two related technical service bulletins (tsbs): bendix push-pull type control valves service data sd-03-3611 rev. 007 (2019-03) and bendix pp-1 & pp-8 park control valve wear and replacement notice technical bulletin tch-003-056 (2019-11-20). Odi sent information request (ir) letters to motor vehicle manufacturers autocar llc (autocar) and volvo trucks north america/mack trucks, inc. (volvo/mack) and motor vehicle equipment manufacturer bendix. Ir response data from all three manufacturers was analyzed and cross-referenced to gain further understanding. To date, odi is aware of 5 vehicle roll-away incidents related to the alleged defect condition in the subject vehicles equipped with the subject components, resulting in 4 crashes and 1 injury. On december 9, 2021, volvo/mack notified the agency of a safety recall (21v953) to address a safety defect in certain my 2008-2019 terrapro (mru) and my 2019-2022 terrapro (te) trucks originally equipped with the subject components. [kk(2] on january 1, 2023, autocar notified the agency of a safety recall (23v023) to address a safety defect in certain my 2008-2020 acx (xpeditor), my 2012-2020 acmd (xpert), my 2010-2020 actt (xspotter), my 2008-2010 wx and my 2008-2010 wxll trucks. Volvo/mack and autocars recall remedies involve removing the vent line fitting threaded into the exhaust port of the subject pp-1 valve. [vd(3] both autocar and mack have stopped equipping new refuse trucks with park control valves using the exhaust pipe-away configuration. After discussions between odi and bendix concerning ways to prevent new pp-1 valves from being sold and installed with a potential for the exhaust to become restricted, bendix will take the following actions: 1) issue a letter to all original equipment (oe) customers with important safety information warning them about the safety risk of attaching plumbing to the exhaust port when the subject component is used as a park control valve; and 2) affix a warning label on all aftermarket parts warning not to install pipe-away exhaust port plumbing. In view of the recalls being conducted by volvo/mack and autocar, and the actions taken by bendix, odi has closed this preliminary evaluation. The closing of this investigation does not constitute a finding by nhtsa that a safety-related defect does not exist in equipment or other model or my vehicles that have not been recalled. The agency reserves the right to take further action if warranted.
    Last updated on 2024-05-11 09:10:28

© dot.report 2024

Use of this information constitutes acceptance for use in an AS IS condition. There are NO warranties, implied or otherwise, with regard to this information or its use. Any use of this information is at the user's risk. It is the responsibility of user to evaluate the accuracy, completeness or usefulness of any information, opinion, advice or other content. EACH USER WILL BE SOLELY RESPONSIBLE FOR ANY consequences of his or her direct or indirect use of this web site. ALL WARRANTIES OF ANY KIND ARE EXPRESSLY DISCLAIMED. This site will NOT BE LIABLE FOR ANY DIRECT, INDIRECT or any other kind of loss.