Bmw 3-series 2019

• Recall R/2020/219 [UK]: Steering tie rod can become broken in the 'kink' groove area of the rod
  A steering tie rod with an earlier design configuration can become broken in the ?Kink? Groove area of the rod.
  both of the steering tie rods will be replaced on the affected vehicles.

  Show Content

• Recall R/2019/290 [UK]: The foldable rear centre head restraint interlock was not welded according to specifications
  The rear center head restraint interlock was not welded according to specification.
  on the affected vehicles the center rear head restraint will be replaced.

  Show Content

• Recall R/2019/368 [UK]: The pressing force of the bearing bushing into the crankcase may be out of specification
  The engine counterbalance shaft bearing bushing into the crankcase may be out of specification
  replace the engine of affected vehicles

  Show Content

• Recall R/2021/288 [UK]: The tandam vacuum/oil pump may fail
  The fault involves the tandem vacuum/oil pump fitted to the engine. On affected vehicles it is possible that the engine rotates in the opposite direction than it is meant to on start-up causing the tandem pump to fail.
  on the affected vehicles the control unit (dme) will be programmed to prevent the failure from occuring.

  Show Content

• Recall 2021078 [Canada]: Visual system
  Issue: on certain vehicles, a software problem could cause the rearview camera image not to appear correctly in the central display. Canadian regulations require the rearview image to display when the transmission is shifted into reverse gear. Safety risk: a rearview camera image that does not display correctly could reduce a driver's ability to see behind the vehicle while backing up. This could increase the risk of a crash. Corrective actions: bmw will notify owners by mail and instruct you to take your vehicle to a dealer to update the rearview camera software, if necessary.

  Show Content

• Recall 2020267 [Canada]: Steering
  Issue: on certain vehicles, high temperatures and excessive vibration could cause damage to the steering tie rods. If this happens, the tie rods could break. This could result in a loss of steering control. Safety risk: a loss of steering control could create a risk of a crash. Corrective actions: bmw will notify owners by mail and instruct you take your vehicle to a dealer to replace the steering tie rods.

  Show Content

• Recall 2019519 [Canada]: Engine
  Issue: on certain 330i xdrive models, the bearings on the engine counterbalance shafts may not be installed correctly. This could cause the counterbalance shafts to loosen, and result in severe engine damage or an engine failure. An engine failure would cause a sudden loss of power with an inability to restart. Safety risk: a sudden loss of engine power could increase the risk of a crash. Corrective actions: bmw will notify owners by mail and instruct them to take their vehicle to a dealer to replace the engine.

  Show Content

• Recall 2019480 [Canada]: Visual system
  Issue: on certain vehicles, the rearview camera does not return to the default settings when it turns on. This could make the rearview image difficult to see if a driver had previously adjusted the camera display brightness at or near the lowest setting, and contrast at or near the highest setting. Canadian regulations require that the rearview display returns to the default view each time the camera is turned on. Safety risk: reduced rear visibility could increase the risk of a crash. Corrective actions: the company will notify owners by mail and instruct them to take their vehicle to a dealer to update the software for the rearview camera. Drivers are recommended not to adjust the display brightness at or near the lowest setting, and contrast at or near the highest setting, until this recall is completed.

  Show Content

• Recall 2019220 [Canada]: Airbag
  Issue: on certain vehicles, the driver and front passenger knee airbags were not assembled correctly. This could cause the airbags not to inflate properly in a crash. Safety risk: a knee airbag that does not deploy properly could create an increased risk of injury in a crash. Corrective actions: bmw will notify owners by mail and instruct them to take their vehicle to a dealer to replace the driver and/or front passenger knee airbag modules as required.

  Show Content

• Recall 2018428 [Canada]: Airbag
  Certain vehicles may have been built with a defective passenger front airbag. This could cause the airbag not to deploy properly in a crash, increasing the risk of injury to the seat occupant. Correction: dealers will replace the passenger front airbag.

  Show Content

To ensure accuracy and for your safety, it is recommended to do a free VIN recall check here or here [USA] - UK - Canada.