Bmw 318i/318is 1992

• Recall 12390 [USA]: If a crack were to form or a seam were to separate in the heater core end piece, hot coolant could suddenly be expelled, increasing the risk of personal injury to a vehicle occupant.
  Vehicle description: passenger vehicles. A malfunction or failure of a coolant system component, such as a thermostat, water pump, or fan belt, can result in significantly increased coolant temperature and system pressure. If the indications of a critical overheating condition is not noticed by the driver, it is possible that damage to, or failure of, a coolant system component could occur.
  dealers will install a new design radiator cap to control pressure and provide greater coolant overflow in the event of overheating.
  owner notification began march 31, 1999. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact bmw at 1-800-831-1117.Also contact the national highway traffic safety administration's auto safety hotline at 1-888-dash-2-dot (1-888-327-4236).

  Show Content

• Recall 16174 [USA]: This could cause the throttle valve to remain partially open. it his were to occur, the car might not decelerate as expected increasing the risk of a vehicle crash.
  The cruise control and throttle cables are attached to the same throttle valve actuating lever at the throttle housing. It is possible that the plastic bushing on either cable could break due to environmental influences coupled with vibration. If the bushing breaks, the outer cable housing can separate from the bushing. In this case, during application of the throttle pedal without cruise control being engaged, the outer tube could catch on the edge of the broken bushing.
  dealers will install a spring steel clip on the outer tube of each cable in the area of the adjusting screw and plastic bushing. The clip is designed to prevent the outer tube from dislodging from the bushing.
  owner notification is expected to begin by the end of october 1997. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact bmw at 1-800-831-1117.Also contact the national highway traffic safety administration's auto safety hotline at 1-800-424-9393.

  Show Content

• Recall 18601 [USA]: If this happens, the contact ring wiring could eventually break. the air bag readiness indicator lamp (srs or airbag) in the instrument cluster will illuminate, and the air bag would not deploy in the event of a frontal impact vehicle collision.
  The air bag contact ring locking tab located in the steering wheel assembly can break without warning.
  dealers will replace the locking tab with one of a different design.
  system: interior; passive restraint; air bag; driver. Vehicle description: passenger vehicles. Owner notification: owner notification is expected to begin august 5, 1996. Note: owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact bmw at 1-800-831-1117. Also contact the national highway traffic safety administration's auto safety hotline at 1-800-424-9393.

  Show Content

To ensure accuracy and for your safety, it is recommended to do a free VIN recall check here or here [USA] - UK - Canada.

Bulletins are notices put out by manufacturers in conjunction with the NHTSA to notify the public of manufacturing issues or changes.

Faulty profile gasket on 1992 bmw 318i engine. *ak

Onboard computer failed when got wet at a car wash.*ak

The profile head gasket is a widely reported defect on bmw 318i engines. For me its a serious problme now that this is the second head gasket to blow. The first was replaced under warranty, the second may or may not be replaced under warranty. In anny event the repair work has not yet been done. Based on the web pages i have read this is a widespread problem and bmw is not reacting properly. I think you should consider a class-action law suit to make them act properly for such a major defect.

I have done some research over the internet for this problem and it appears to be a very common one. I am completely amazed that bmw is not covering this repair of this, even though they are aware of the defect.

Profile gasket failure. The part fails on all m42 engines produced by bmw between 1991 and 1992. Was made aware via technical bullletin sent to dealers. A recall needs to be issued.

Air bag contact ring on the driver's side broke. When the air bag warning light came on, vehicle was taken to the dealer where the ring was replaced at owner's expense. Vehicle not included in recall 96v110000 bmw/interior; passive restraint: air bag:driver. *ak *ml

Vehicle experienced coolant loss and low coolant levels but the temperature guage did not rise above normal. Loss was due to engine gasket failure.

When driving at 30 mph the vehicle surges, the engine races to high rpm and the vehicle cuts off without warning. Contacted the dealer, cause of problem was yet to be determined. *ak