Bmw 325 1986

• Recall 20420 [USA]: Vehicles operated under this increased cooling systempressure condition can suffer damage or failure of parts of the cooling systemsuch as (1) leakage from a coolant hose, (2) leakage of the radiator orexpansion tank, (3) disconnection of a hose from a pipe or a fitting, and (4)cracks in the heater core end piece resulting in coolant leakage. in some cases,boiling coolant can contact the lower right leg of the driver resulting inburns. also, escaping coolant in the passenger compartment can cause vaporfogging of the interior surface of the windows, reducing driver visibility.
  The malfunction or failure of a coolant system component results in significantly increased coolant temperature and a resulting increase in system pressure.
  dealers will install a thermostatic bypass valve in the engine compartment to control coolant temperature in the heater core. Also, a new design radiator cap will be installed, to control pressure and provide greater coolant overflow in the event of overheating.
  system: coolant system.Vehicle description: passenger cars.

  Show Content

• Recall 26816 [USA]: Consequence of defect: switch plunger could jam, rendering brake lights either inoperative or continuously illiminated, regardless of brake pedal operation.
  Brake light switch could overheat, eventually leading to melting of plastic internal parts in area of electrical contacts.
  replace brake light switch with revised switch with increased electrical load capacity.
  system: brake light switch. Vehicle description: passenger cars with high brake lights.

  Show Content

• Recall 26737 [USA]: System: steering column.vehicle description: passenger cars.
  The two parts of the steering column disengagement element could completely disconnect if the car contacts an object in the roadway or elsewhere of sufficient mass to apply a significant force directly to the steering gearbox. Consequence of defect: steering control would be lost.
  bolt two specially formed plates to the disengagement element so that steering capability will be retained.
  system: steering column.Vehicle description: passenger cars.

  Show Content

To ensure accuracy and for your safety, it is recommended to do a free VIN recall check here or here [USA] - UK - Canada.

Bulletins are notices put out by manufacturers in conjunction with the NHTSA to notify the public of manufacturing issues or changes.

• Heater core failure investigation # EA92017

  There is no summary currently available
  

  Show Content

• Defective heater cores investigation # DP92004

  Defective heater cores
  

  Show Content

• Mstr cyl fails to release investigation # EA90002

  There is no summary currently available
  

  Show Content

• Brakes drag & fail investigation # PE89142

  Summary:the brakes reportedly began to drag and lock withoutwarning during highway driving on 4 vehicles.The cause is notknown at this time.===
  

  Show Content

My 1986 325es bmw over heat. Change the fluids, perform several checks and it is still over heating. Has there been any recall on the heating or cooling system.

Car has overheated since 2000. I have called the dealership several times and they keep telling me there is no recall for my 86 bmw 325 but i just looked up recalls and saw were overheating was a problem for this year model car. *tr

Defect in electronic locking device. Unable to open passenger doors (front and back), either manually (from inside) or with key (from outside). Have scheduled an appointment to have parts repaired or replaced. *jb

Consumer states that dealership stated that they don't know if they can do consumers recall for free. Mr

Daughter driving, passengers/driver had on seat belts, clear/sunny day, another car tailgating fast. Started slowing to make lane change, car skidded, brakes locked up, car rolled 6 times, car upside down, driver thrown to passenger's side roof. Seatbelt did not hold. *ak

Recall 93v015 heater:defroster:defogger; hot fluid entered compartment and burnt drivers lower leg. Please describe details. Tt

Air conditioning is not powerful enough. *skd

Vehicle was jacked up at left front jack point on perfectly flat concrete floor, it rolled rearward, jack footing slipped and vehicle fell on victim.

Constant heating problem, on and off at times, engine got hot and rod started knocking nhtsa id # 93v01500,# 86v151000. . *ak