Bmw R Series 2002

• Recall 42057 [USA]: Fuel leakage in the presence of an ignition source could result in a fire.
  On certain motorcycles, the o-ring in fuel line quick-disconnect coupling could become damaged and lead to a fuel leak. There is also a problem involving crimp-type hose clamps, which can result in a fuel leak.
  dealers will inspect and, if necessary, adjust all crimp-type hose clamps. Also, all fuel line quick-disconnect couplings will be inspected. If a leak is detected, the quick-disconnect o-ring will be replaced. If damaged, the coupling will be replaced. Owner notification began on april 30, 2004. Owners should contact bmw at 1-800-831-1117.
  customers can also contact the national highway traffic safety administration's auto safety hotline at 1-888-dash-2-dot (1-888-327-4236).

  Show Content

• Recall RM/2003/002 [UK]: Gearbox may lock up
  The idler gears for third and fourth gear may not be securely seated on the intermediate shaft. As a consequence two gears could be engaged similtaneously and cause the gearbox to lock up.
  replace the gearbox on the affected motorcycles.

  Show Content

• Recall RM/2015/005 [UK]: Wheel may detatch
  It is possible that during maintenance work on brake discs and/or wheel changes threaded fasteners might have been over tightened. The over tightening can result in cracks in the wheel flange. In the course of a lengthy service life the cracks can propagate and under worst-case conditions lead to fracture of the bolted join and the wheel separating from the machine. Initially owners will be warned of the concern and when the new components are available the owners will be notified so the components can be replaced.
  recall the vehicles that are likely to be affected and replace the aluminium wheel flange with a steel flange.

  Show Content

To ensure accuracy and for your safety, it is recommended to do a free VIN recall check here or here [USA] - UK - Canada.

Bulletins are notices put out by manufacturers in conjunction with the NHTSA to notify the public of manufacturing issues or changes.

• Motorcycle fires investigation # PE07031

  Unlike most motorcycles, where a sight glass is used to determine engine oil level, the subject, air-cooled, motorcycles are built by bmw with a polymer (plastic) sight glass that, in some instances, melts due to high engine/oil temperature.This typically occurs when the motorcycle is operated contrary to bmws owner manual admonition: "warning:do not keep the engine running while the motorcycle is at a standstill -- risk of overheating and fire."each of the alleged fires occurred while the motorcycle was parked and idling.Odi is unaware of any structure fires where a melted sight glass is the root cause.Of the eight known fires, one occurred in 2000, three in 2004 and again in 2005, and one in february, 2007.The subject vehicles do not have an elevated fire-related insurance claims history. Based on the low incidence rate, it appears bmws warning is effective and no defect trend is identified.Further use of agency resources appears unwarranted.This investigations closing does not constitute a nhtsa finding that no safety-related defect exists and we reserve the right to take further action if warranted.
  

  Show Content

Earlier in the week the abs failure lights came on and then the brakes stopped working effectively. There is a backup "residual braking" of about 15%. I survived because i was not in traffic and did not need a serious stop. I had it "fixed" at the dealer on saturday. The lights were out and the brakes worked for about 4 on off cycles. Then they failed again driving down the road. It has been intermittent since. I then researched this problem on the internet and found it is rampant. People have been permanently disabled. Motorcycles have crashed over and over. Bmw ignores it and wants over $2,400 for the part replacement alone. But the design is unsafe! When the abs fails it should give full normal braking power. It does not. More people are going to be killed by these systems. Bmw claims to have tested the residual braking and found it safe. They are lying! No one could survive an emergency stop expecting normal function and getting only 15% with a ten times harder braking effort. Further sometimes the failures cause the brakes to lock and the motorcycle to crash. They should at least offer free removal of this system. It can be done and make the machines safe.

Tl*the contact owns a 2002 bmw r1150rt.. While starting the motorcycle, the kickstand bent and it fell over. The motorcycle was taken home where the contact repaired it himself. The failure mileage was 45,000 and the current mileage was 51,000. Updated 12/20/10 *bf the consumer stated he did not receive any paper work to fill out. Updated 12/27/10 updated 01/13/11*lj updated 01/27/11

Tl* the contact owns a 2002 bmw r1150rt motorcycle. While driving approximately 70 mph, the contact noticed fuel was leaking from the connecting sleeve to the fluid line. In addition, fuel began leaking onto the hot cylinder. This was the second instance of the failure. The vehicle was not taken to the dealer for diagnostic testing or repairs. The failure mileage was 20,600 and the current mileage is 25,300. Updated 10/21/10. *lj updated 10/26/10

Clutch to transmission input shaft splines failed on my 2002 bmw r1150rt motorcycle. Sudden loss of power due to failure of the splines which connect the clutch plate to the transmission input shaft. Fortunately i was on a side street which wasn't busy and near home. No accident resulted due to location where failure occurred. *tr

Final drive crown bearing failed. Excess axle movement damaged seal, final drive oil leaked out over tire, oil on motorcycle tire is dangerous. I was lucky. There is lots on internet activity on this, there have been crashes and fires reported but i do not have personal knowledge of any. Vehicle is 2002 bmw r1150rs same final drive design used on all r and k models for many years. *tr

Quick disconnect fuel line fitting failure (fractured for no special reason while riding motorcycle) was not damaged or misused in any way. Gasoline was spilling onto hot catalytic converter, but no fire. *jb

2002 bmw r1150r fuel leak problem/ fuel line recall.*mr the consumer stated the motorcycle developed a fuel leak during operation that resulted in gasoline being sprayed onto the engine block as well as the consumer leg. The consumer had the motorcycle towed and upon inspection, the consumer was informed that the male end of one of the quick disconnects on the fuel had cracked. The consumer had recall 04v028000 perform on the motorcycle in 2004. The repair work was covered under warranty, however the consumer is requesting reimbursement of the towing charges he incurred. *jb

Operating under normal driving condition at speed below 40 mph. Vehicle loss all power from engine to transmission. Engine still operates and revs normally, but no engine power is transferred to transmission. Transmission still shift proper into each gear in the gearbox. Vehicle towed to main line bmw motorcycle, diagnosed with failure of clutch and drive shaft spline interface. Clutch and transmission input shaft replaced, transmission rebuilt under vehicle factory warranty (2 year/30,000 mi.).