Bmw R1100 Rs 2000
Vehicle Details: Investigations, Consumer Complaints, Service Bulletins
Use the box here to look up VINs from BMW as well as other manufacturers
-
Where is the 2000 BMW R1100 Rs produced?
- The 2000 BMW R1100 Rs is produced in Munich Bavaria, Germany.
Bulletins are notices put out by manufacturers in conjunction with the NHTSA to notify the public of manufacturing issues or changes.
- SIB-63-02-01 - EXTERIOR LIGHTING: Bmw: procedure for determining and replacing incandescent and halogen light bulbs under warranty. *rm
- SIB-16-02-09 - FUEL SYSTEM, GASOLINE:DELIVERY:FUEL PUMP: Bmw vehicles: fuel level sensor repairs. Where it is necessary to replace the right or the left side fuel level sensor due to a failure, the entire pump and housing or delivery unit (suction jet assembly) do not need to be replaced as wel
- SB-00-021-07 - FUEL SYSTEM, OTHER: Bmw motorcycle: engine fuels containing ethanol. Bmw motorrad has no objection to the use of si engine fuels containing up to a maximum of 10% ethanol and imposes no warranty restrictions. Ethanol mixtures in proportions higher than 10%
Fuel line leakage investigation # PE03054
Bmw is conducting a recall (04v-028).An information request(ir)response was not received. Upon bmws receipt of the ir, and after discussions with odi, bmwdetermined that a recall was necessary. On certain motorcycles, the o-ring contained within the fuel line quick-disconnect coupling could become damaged.Further, there is also a problem involving crimp-type hose clamps, which can also result in a small fuel leak.Dealers will inspect, and if necessary, adjust all crimp-type hose clamps.Also all fuel line quick-disconnect couplings will be inspected.If a leak is detected, the quick-disconnect o-ring will be replaced.If damaged, the coupling will be replaced.Owner notification is expected to begin during february 2004.
| Crash | Fire | Towed | Injured | Deaths | Failure Date |
|---|
| No | No | N | None | None | 20010731 |
The transmission input shaft seal or the seal installation procedure is defective. This seal on my transmission has leaked for the past 7000 miles. Bmw attempted to repair this leak by replacing this seal under warranty at 15k miles. The new seal has begun to leak. This seal is a known problem to bmw motorcycle owners - especially r1100s owners. Any lubricant leak on a motorcycle is a safety issue. Manufacturers must be forced to resolve known repetitive leaks.*ak
| No | No | N | None | None | 20000901 |
A surge condition at engine speeds between 2,500 toover 4,000 rpm. The surge condition causes a momentary loss of power, then powers up again. If riding in a turn, and the surge condition occurs, the balance of the motorcycle is upset. The surge results in an imbalance that has caused me grave concern for my sersonal safety. The condition was first experienced shortly after i purchased the bike.*ak
| No | No | N | None | None |
2000 bmw, r1100rl. The motorcycle contained a design flaw in the final drive gear lube seal within the chassis of the motorcycle.*ak *jb