Bmw R1150gs 2001
Vehicle Details: Recalls, Investigations, Consumer Complaints, Service Bulletins
Below you will find all available information on the 2001 BMW R1150gs.
Manufacturer | Known WMI(s) | Fuel Type |
---|---|---|
BMW |
Use the box here to look up VINs from BMW as well as other manufacturers
-
Are there recalls for the 2001 BMW R1150gs?
- There are 3 recall(s) for the 2001 BMW R1150gs, additional information is below.
Recall 3252 [USA]: Brake fluid leakage could occur, resulting in a loss of front braking capability. if this happened, depending on traffic conditions and the rider's reactions, a crash could occur.
Recall 2004026 [Canada]: Fuel supply
Recall 2002011 [Canada]: Brakes
To ensure accuracy and for your safety, it is recommended to do a free VIN recall check here or here [USA] - UK - Canada.
Bulletins are notices put out by manufacturers in conjunction with the NHTSA to notify the public of manufacturing issues or changes.
- MC51142327 - EQUIPMENT: Leaks have been reported in fork legs. The cause is reported be from oil lubricating film with accompanying dirt/grease ring is incorrectly interpreted to be a leaking fork leg. Investigations have shown that the part is not defective.
- SIB-63-02-01 - EXTERIOR LIGHTING: Bmw: procedure for determining and replacing incandescent and halogen light bulbs under warranty. *rm
- SIB-16-02-09 - FUEL SYSTEM, GASOLINE:DELIVERY:FUEL PUMP: Bmw vehicles: fuel level sensor repairs. Where it is necessary to replace the right or the left side fuel level sensor due to a failure, the entire pump and housing or delivery unit (suction jet assembly) do not need to be replaced as wel
- SB-00-021-07 - FUEL SYSTEM, OTHER: Bmw motorcycle: engine fuels containing ethanol. Bmw motorrad has no objection to the use of si engine fuels containing up to a maximum of 10% ethanol and imposes no warranty restrictions. Ethanol mixtures in proportions higher than 10%
Fuel line leakage investigation # PE03054
Bmw is conducting a recall (04v-028).An information request(ir)response was not received. Upon bmws receipt of the ir, and after discussions with odi, bmwdetermined that a recall was necessary. On certain motorcycles, the o-ring contained within the fuel line quick-disconnect coupling could become damaged.Further, there is also a problem involving crimp-type hose clamps, which can also result in a small fuel leak.Dealers will inspect, and if necessary, adjust all crimp-type hose clamps.Also all fuel line quick-disconnect couplings will be inspected.If a leak is detected, the quick-disconnect o-ring will be replaced.If damaged, the coupling will be replaced.Owner notification is expected to begin during february 2004.
Crash | Fire | Towed | Injured | Deaths | Failure Date |
---|
No | No | N | None | None | 20090727 |
While on a cross country motorcycle trip. I was traveling at highway speeds when the motorcycle began to have a grinding noise and vibration from the rear. I stopped to find oil leaking from the final drive all over the rear tire and wheel assembly. While attempting to stop, the rear abs system activated because the gear oil saturated the brake rotor and pads. I almost crashed the motorcycle because of the oil on the tire. The final drive was serviced per bmw specifications of gear oiltype and weight days prior to the trip. There were no indicators prior to the final drive failing. The gear oil escaped the housing due to a torn bearing seal on the back side of the housing next to the brake rotor. Teardown of the finaldrive assembly found a disintegration of the main bearing including ball bearings. The metal in the housing tearing the bearing seal leaking oil on to the rear wheel assembly. The metal in the housing also damaged the second smaller bearing which had to be replaced. The following are the bmw part numbers for the failed parts 33121242210 grooved ball bearing 33121451188 tapered bearing 33127663482 shaft seal *kb
No | No | N | None | None | 20030519 |
Rear drive (wheel) bearing failure. This is the only suport bearing for the wheel.*ak
No | No | N | None | None | 20010726 |
Bmw motorcycle rear drive failure, could lead to catastrophic crash if rear wheel locks up. Drive failed with no advance symptoms. Drive rebuilt.*ak