Bmw S1000-xr 2019
Vehicle Details: Recalls, Service Bulletins
BMW VIN Decoder
Use the box here to look up VINs from BMW as well as other manufacturers
Frequently Asked Questions
-
Where is the 2019 BMW S1000-XR produced?
- The 2019 BMW S1000-XR is produced in Munich Bavaria, Germany.
-
Are there recalls for the 2019 BMW S1000-XR?
- There are 2 recall(s) for the 2019 BMW S1000-XR, additional information is below.
NHTSA Mandated Recalls
Bulletins
Bulletins are notices put out by manufacturers in conjunction with the NHTSA to notify the public of manufacturing issues or changes.
- B611305 - ELECTRICAL SYSTEM: The electrical system of bmw vehicles has been subject to an ongoing development process over the last few years. This has led to increased demands being placed on the battery. This document covers important information for the dealer on ho
- MC340223 - WHEELS: Front and rear wheel speed sensor faults (0x3a1800 and 0x3a1801) appear after the bike is being revvedover 5000 rpm while still on the side stand, sometimes in conjunction with the side stand fault 0x3a1331. When the engine is revved up wh
- SIB-111421 - SUSPENSION: Check rocker arms and replace where needed.
- MC111421 - EQUIPMENT: Due to a process deviation during production, the surface coating of the rocker arms may wear prematurely.
- MC610821 - ELECTRICAL SYSTEM: When diagnosing fault codes (0x3a13d7, 0x3a13d9), technicians erroneously condemn the electronic throttle grip, which analyses show is rarely the culprit.
- MC610220 - ELECTRICAL SYSTEM: The engine wiring harness may chafe on the honeycomb structure of the frame. In case of damage to the wiring harness, the wake-up line of the instrument cluster will be damaged.
- MC340320 - SERVICE BRAKES, HYDRAULIC: During assembly, an additional mounting bolt was installed on the abs pressure modulator instead of a plastic rivet.
- MC330421 - SUSPENSION: Depending on the chassis and suspension adjustment, as well as vehicle load, the drive chain may make contact with the swing arm under certain conditions.
- MC110821 - AIR BAGS: Warning light and fault message in the tft with faults stored for the rear oxygen sensor (after the catalytic converter). The failure usually occurs shortly after the vehicle handover or the running-in check
- MC610621 - ELECTRICAL SYSTEM:WIRING: Warning light in the instrument cluster for dcc failure in motorcycles equipped with dcc
- MC63022267 - STEERING: STEERING WHEEL/HANDLE BAR: Vibrations on the handlebars in an engine range from 2000 to 4000 rpm may be perceived as uncomfortable by some customers.
- MC610621 - ELECTRICAL SYSTEM: Warning light in the instrument cluster for dcc failure in motorcycles equipped with dcc
- MC62814078 - FUEL SYSTEM, GASOLINE: It has been reported that the fuel hose comes loose at fuel distributor/pressure sensor. Because of thios, there is fuel leak that occurs when switching on the ignition.
- MC6152772 - EQUIPMENT: Grab handles have replaced luggage racks despite despite order requiring luggage rack.
- MC64351344 - EQUIPMENT: Lurching at partial load range and idle speed is unstable
- MC610220 - ELECTRICAL SYSTEM: The engine wiring harness may chafe on the honeycomb structure of the frame. In case of damage to thewiring harness, the wake-up line of the instrument cluster will be damaged. The instrument cluster will nolonger be activated with "ignitio
- MC110220 - ENGINE AND ENGINE COOLING: On the s 1000 models, the seal for the coolant circuit of the oil/coolant pump was manufactured from an incorrect material. This could lead to a minor leakage of coolant into the oil circuit. The oil/coolant pump must be replaced.
- MC110120 - ENGINE (PWS): Bmw motorrad has ascertained that the engine installed in the affected vehicles may have a burr present in the guide bore for the oil supply of the timing chain. The burr can dislodge over time due to vibrations and oil pressure fluctuation
- MC64011504 - EQUIPMENT: Ticking noises from the cylinder hood.
- MC64011504 - ENGINE (PWS): Ticking noises from the cylinder hood.
- MC54380454 - ENGINE (PWS): Rattling/chattering engine noise from the timing chain.
- MC4600115-019 - EQUIPMENT: During an interim period, some vehicles ordered with a luggage carrier were being shipped with grab handles in its place. This was done in order to ensure that all luggage carriers meet the quality standards of bmw motorrad and to avoid a d
- MC2300315-024 - POWER TRAIN:MANUAL TRANSMISSION:COLUMN SHIFT ASSEMBLY: Bmw motorrad has ascertained that in some cases the shift assistant was unable to function correctly. This cause is incorrect vehicle-specific programming of the shift assistant by the supplier.
- MC61479140 - BRAKES (PWS): When the brake system is filled with fluid for the first time in the assembly plant, a float is installed in the fluid reservoir of the handbrake fitting (see figures 1 and 2). This float is required only for the initial, vacuum-assisted fi
- MC3200115 - BRAKES (PWS): When the brake system is filled with fluid for the first time in the assembly plant, a float is installed in the fluid reservoir of the handbrake fitting (see figures 1 and 2). This float is required only for the initial, vacuum-assisted fi
- MC64171614 - ENGINE (PWS): Oil leaking at the clutch release lever sealing ring in the left housing
- MC62177457 - STRUCTURE:BODY:DOOR : There is a notch visible in the lower part of the right grab handle. The fault/defect is due to a tooling error.
- MC61326053 - ELECTRICAL SYSTEM: After activation of the alarm system, the turn indicators remain on for 1 minute with integration levels higher than k001-15-03-510.